CTSP ALL ANSWERS AND QUESTIONS SET A+
1
✔✔18. When your work obstructs any part of the roadway , advance - warning signs are
required . The closest sign should be about how many feet away on low - speed roads ?
- ✔✔B. 200
✔✔19. When cones are used to channel traffic away from the work site , the distance
between cones should be determined by which of the following ? - ✔✔C. Speed limit
✔✔20. If one of your company vehicles is involved in an accident with another driver ,
what would your driver and crew do FIRST ? - ✔✔C. Make sure that all people involved
in the incident are removed from danger and prevent further collisions
✔✔21. One of your drivers approaches an intersection where your work vehicle has the
right of way , but a car pulls out in front of them . What would you advise the employee
to do in a situation like this ? - ✔✔D. Yield the right of way
✔✔22. In adverse weather conditions or when pulling a trailer or heavy load , your
truck's following distance should be at least from the vehicle in front of it . - ✔✔C. Eight
seconds
✔✔23. Why does operating a big truck require different skills and thinking than for a
passenger car ? - ✔✔A. It usually has larger blind spots
• B. A truck doesn't respond as quickly to acceleration, deceleration and steering
• C. It requires much more time and distance to stop
• D. All the above—
✔✔24. What is the proper sequence of events when your crew arrives at a work site ? -
✔✔C. Site inspection , work plan , job briefing , get to work
✔✔25. According to OSHA , an accident isn't considered recordable if it required only
first aid treatment before the employee could resume work . Which of the following
would be considered a recordable accident ? - ✔✔? A. Obtaining stitches
, ✔✔26. Company A has 12 full - time employees . In the previous year , they worked an
average of 1,780 hours each . Among them all , there were four recordable injuries ,
including two lost workday injuries and a total of five lost workdays . What is their
incidence rate ? - ✔✔C. 37.5
✔✔27. You want to set up a " zero - exposure " safety incentive plan , making it
somewhat competitive between the crews you supervise . Which of the following would
be the fairest and most accurate measure of hazard exposure to use for comparison ? -
✔✔C. Accident Investigation reports
✔✔28. If you wanted to setup a " less than zero " safety program , where would you
focus your attention ? - ✔✔B. Non - serious accidents and near misses ( close calls ,
simply because there is more of them and your efforts here can result in faster
improvement . )
✔✔29. Which of the following is NOT an acceptable practice for safe lifting ? - ✔✔B.
Keeping your head , shoulders and back bent forward , over the load as you lift
✔✔30. What PPE is required by Z133 for operating a chain saw on the ground ? - ✔✔A.
Work boots , helmet , eye protection , leg protection , hearing protection
✔✔31. What PPE is required for operating a chipper ? - ✔✔C. Work boots , helmet ,
eye protection , hearing protection
✔✔32. Struck - by hazards can be minimized by - ✔✔A. Setting up a work zone with
proper cones, signs, and flags
• B. Making sure the work zone is free of trip hazards
• C. Staying out from under trees where limbs are being dropped
D. Both A and C—
✔✔33. If you are using a helmet with a face screen or shield , which of the following is
correct ? - ✔✔C. Separate eye protection is needed
✔✔34. " ANSI Z133 : Workers engaged in arboricultural operations shall wear head
protection that conforms to ANSI Z89.1 " " Face protection shall comply with ANSI
Z87.1 " Respiratory protection shall comply with ANSI Z88.2 " " Eye protection in
accordance with ANSI Z87.1 shall be worm when engaged in arboricultural operations "
From the ANSI Z133 statements above , which PPE is required to be worn for all tree -
care related activities ? - ✔✔D. Hardhats and eye protection
✔✔35. According to ANSI Z133 , a " qualified arborist trainee " must be under the direct
supervision of a qualified arborist . Which of the following is a correct application of this
1
✔✔18. When your work obstructs any part of the roadway , advance - warning signs are
required . The closest sign should be about how many feet away on low - speed roads ?
- ✔✔B. 200
✔✔19. When cones are used to channel traffic away from the work site , the distance
between cones should be determined by which of the following ? - ✔✔C. Speed limit
✔✔20. If one of your company vehicles is involved in an accident with another driver ,
what would your driver and crew do FIRST ? - ✔✔C. Make sure that all people involved
in the incident are removed from danger and prevent further collisions
✔✔21. One of your drivers approaches an intersection where your work vehicle has the
right of way , but a car pulls out in front of them . What would you advise the employee
to do in a situation like this ? - ✔✔D. Yield the right of way
✔✔22. In adverse weather conditions or when pulling a trailer or heavy load , your
truck's following distance should be at least from the vehicle in front of it . - ✔✔C. Eight
seconds
✔✔23. Why does operating a big truck require different skills and thinking than for a
passenger car ? - ✔✔A. It usually has larger blind spots
• B. A truck doesn't respond as quickly to acceleration, deceleration and steering
• C. It requires much more time and distance to stop
• D. All the above—
✔✔24. What is the proper sequence of events when your crew arrives at a work site ? -
✔✔C. Site inspection , work plan , job briefing , get to work
✔✔25. According to OSHA , an accident isn't considered recordable if it required only
first aid treatment before the employee could resume work . Which of the following
would be considered a recordable accident ? - ✔✔? A. Obtaining stitches
, ✔✔26. Company A has 12 full - time employees . In the previous year , they worked an
average of 1,780 hours each . Among them all , there were four recordable injuries ,
including two lost workday injuries and a total of five lost workdays . What is their
incidence rate ? - ✔✔C. 37.5
✔✔27. You want to set up a " zero - exposure " safety incentive plan , making it
somewhat competitive between the crews you supervise . Which of the following would
be the fairest and most accurate measure of hazard exposure to use for comparison ? -
✔✔C. Accident Investigation reports
✔✔28. If you wanted to setup a " less than zero " safety program , where would you
focus your attention ? - ✔✔B. Non - serious accidents and near misses ( close calls ,
simply because there is more of them and your efforts here can result in faster
improvement . )
✔✔29. Which of the following is NOT an acceptable practice for safe lifting ? - ✔✔B.
Keeping your head , shoulders and back bent forward , over the load as you lift
✔✔30. What PPE is required by Z133 for operating a chain saw on the ground ? - ✔✔A.
Work boots , helmet , eye protection , leg protection , hearing protection
✔✔31. What PPE is required for operating a chipper ? - ✔✔C. Work boots , helmet ,
eye protection , hearing protection
✔✔32. Struck - by hazards can be minimized by - ✔✔A. Setting up a work zone with
proper cones, signs, and flags
• B. Making sure the work zone is free of trip hazards
• C. Staying out from under trees where limbs are being dropped
D. Both A and C—
✔✔33. If you are using a helmet with a face screen or shield , which of the following is
correct ? - ✔✔C. Separate eye protection is needed
✔✔34. " ANSI Z133 : Workers engaged in arboricultural operations shall wear head
protection that conforms to ANSI Z89.1 " " Face protection shall comply with ANSI
Z87.1 " Respiratory protection shall comply with ANSI Z88.2 " " Eye protection in
accordance with ANSI Z87.1 shall be worm when engaged in arboricultural operations "
From the ANSI Z133 statements above , which PPE is required to be worn for all tree -
care related activities ? - ✔✔D. Hardhats and eye protection
✔✔35. According to ANSI Z133 , a " qualified arborist trainee " must be under the direct
supervision of a qualified arborist . Which of the following is a correct application of this
