MSF MOTORCYCLE SAFETY FOUNDATION ECOURSE QUESTIONS AND ANSWERS 2026

MSF MOTORCYCLE SAFETY
FOUNDATION ECOURSE QUESTIONS
AND ANSWERS 2026



SECTION 1: FINEC PRESTART ROUTINE (Questions 1–20)


1. What does the acronym FINEC refer to?
A) A riding posture checklist
B) A pre ride inspection for tires and brakes
C) An engine prestart routine
D) A emergency braking procedure


Correct Answer: C – FINEC is the MSF recommended prestart routine that must
be performed before starting the engine. Options A, B, and D describe other safety
procedures, not the prestart routine.


2. What does the letter "F" in FINEC stand for?
A) Front brake
B) Fuel
C) Friction zone
D) Final drive

,Correct Answer: B – "F" stands for Fuel – if equipped, turn the fuel supply valve
on. The other options are motorcycle components but are not part of the FINEC
acronym.


3. What does the letter "I" in FINEC represent?
A) Ignition
B) Intake
C) Indicator lights
D) Idle speed


Correct Answer: A – "I" stands for Ignition – turn the ignition switch to the On
position; some indicator lights should come on. The other options are not part of
the FINEC acronym.


4. What does the letter "N" in FINEC indicate?
A) Neutral
B) Night riding
C) Navigation
D) No choke


Correct Answer: A – "N" stands for Neutral – the motorcycle should be in neutral,
indicated by a green light on the instrument cluster. When in neutral, the bike will
roll freely with the clutch and brake released.


5. What does the letter "E" in FINEC stand for?
A) Engine cutoff switch
B) Exhaust

,C) Emergency brake
D) Engine temperature


Correct Answer: A – "E" stands for Engine cutoff switch – put the switch in the
Run/On position. The other options are not part of the FINEC acronym.


6. What does the letter "C" in FINEC represent?
A) Clutch and Choke
B) Carburetor
C) Controls
D) Chain


Correct Answer: A – "C" stands for Choke and Clutch – set the choke (if needed
for a cold engine) and squeeze in the clutch lever. The choke should be On for a
cold engine, though some motorcycles do not have a choke.


7. How many brakes should you apply when starting the engine?
A) Zero
B) At least one
C) Both front and rear
D) Only the rear


Correct Answer: B – Always apply at least one brake when starting the engine to
prevent the motorcycle from moving if it is in gear.


8. What should you NOT use if the choke is On?
A) The clutch

, B) The throttle
C) The brakes
D) The starter


Correct Answer: B – Do not use the throttle if the choke is On, as this could
provide too much fuel to the engine.


9. After the engine starts, you can release the clutch lever slowly. Why?
A) To warm up the engine faster
B) In case the motorcycle is not in neutral
C) To check the oil pressure
D) To engage the kickstand


Correct Answer: B – Release the clutch lever slowly in case the motorcycle is not
in neutral, which could cause it to lurch forward.


10. Why should you NOT take your hand off the clutch when starting the engine?
A) It could damage the clutch cable
B) The motorcycle may be in gear
C) It drains the battery
D) It engages the starter motor


Correct Answer: B – Do not take your hand off the clutch when starting because
the motorcycle may be in gear, causing it to move unexpectedly.


11. FINEC is performed before which activity?