Written by students who passed Immediately available after payment Read online or as PDF Wrong document? Swap it for free 4.6 TrustPilot
logo-home
Document preview thumbnail
Preview 2 out of 8 pages
Exam (elaborations)

B2 Trade Exam Practice Test 2 | | Contractor Licensing Practice Questions & Construction Exam Prep

Document preview thumbnail
Preview 2 out of 8 pages

B2 Trade Exam Practice Test 2 is a focused preparation resource designed for candidates studying for a B2 contractor or construction trade licensing examination. The material provides practice-oriented review of trade knowledge, construction principles, jobsite practices, safety considerations, regulations, and technical concepts relevant to contractor licensing assessments. Ideal for aspiring contractors and construction professionals preparing for B2 trade exams, this resource supports targeted practice, knowledge reinforcement, and exam readiness.

Content preview

B2 Trade Exam Practice Test 2
The tool used to carry grout needed to patch a small hole C. A spot board is also known as a gauge board. A Hawk is used for larger
is a: quantities of mortar.



In construction, a hazardous area should be marked with D.
what color tape?



What is the minimum weight a handrail should be able to C.
support?



4. When installing cabinets how far should fasteners B.
extend into the wall?



What is the required height for a grab bar in a shower? A.




While digging, you uncover a gray-colored plastic pipe. It C. Water pipes are typically blue or white and sewer pipes are typically green,
is most likely a: white, or black, depending on the location.



What is the minimum concrete covers at sides where D.
concrete is cast against the ground and bottom of
footings?


What is the tolerance in longitudinal placement of rebar D.
in a slab?



9. How long should tile set on an organic adhesive bed in C.
order to cure?



Rubber-soled shoes would protect you against: C.




If the election of point A is 92.6 feet, and the transit C. 92.6 feet + 3.4 feet = 96 feet
reading at point A is a 3.4, then the elevation of the
transit is:


Which of the following will not affect fire rating? D.




What is the maximum height of a threshold for a door B. When a door is not intended for disabled access, the maximum height is 1
designed for disabled access? inch.



What is the minimum size landing for an automatic B.
electric door designed for disabled access?



When scaffold is over 7-1/2 feet, which of the following A. Toeboards are also required when railings are required
are required?



When notching and boring studs in non-bearing walls, A.
you must not cut more than:

, B2 Trade Exam Practice Test 2
When hardwood flooring arrives at the site, you should: B.




Which of the following is a consideration for disabled D.
access



19. After drywall has been screwed into place, when do C.
you check the placement of the screws?



How many receptacles are on a dedicated circuit? A.




The first thing to do when installing a drop ceiling is: D. Measure to the desired ceiling height and snap a chalk line




What type of hammer is best to use for drywall A. Drywall hammers are slightly convex to create a shallow dimple.
installation?



23. What type of drain is best when you install tile in a C.
shower with a moisture membrane?



How soon should you pour concrete after you have A. and it must be placed within 90 minutes to prevent the concrete becoming to
mixed it without additives? stiff and difficult to place and finish.



What is the formula for the area of a circle? C. State may write it as pi x radius x radius




What is the formula for the circumference of a circle? A.




What is the correct term for a floor that extends beyond B.
the lower portion of the house?



What is the minimum distance from the centerline of a A. 17 inches minimum and 18 inches maximum for wheelchair accessible
toilet to wall? compartments. 17 inches minimum and 19 inches maximum for ambulatory
accessible compartments.


How is drywall hung on the wall? B.




What is the maximum amount of lead allowable for C.
solder used on piping for portable water systems?



When a customer asked you to install trim what are they A.
most likely referring to?



Which of the following is the best way to sand wood? A.

Document information

Uploaded on
August 29, 2026
Number of pages
8
Written in
2026/2027
Type
Exam (elaborations)
Contains
Questions & answers
$10.99

Wrong document? Swap it for free Within 14 days of purchase and before downloading, you can choose a different document. You can simply spend the amount again.
Written by students who passed
Immediately available after payment
Read online or as PDF

Seller avatar
ExamBooster111
5.0
(3)
Sold
3
Followers
1
Items
886
Last sold
2 weeks ago



Why students choose Stuvia

Created by fellow students, verified by reviews

Quality you can trust: written by students who passed their tests and reviewed by others who've used these notes.

Didn't get what you expected? Choose another document

No worries! You can instantly pick a different document that better fits what you're looking for.

Pay as you like, start learning right away

No subscription, no commitments. Pay the way you're used to via credit card and download your PDF document instantly.

Student with book image

“Bought, downloaded, and aced it. It really can be that simple.”

Alisha Student

Working on your references?

Create accurate citations in APA, MLA and Harvard with our free citation generator.

Working on your references?

Frequently asked questions