NICET LEVEL 1 Questions and Answers
(Top Grade Assured) 2026 Update
what is the maximum number of 14 AWG RHH conductors
which can be installed in 1/2 rigid metal conduit? - Correct
Answers ✅4 wires
Which of the following would be an appropriate mounting
height for a pull station? - Correct Answers ✅3.5'-48" to
the actuator
What is the minimum flash rate for a visible notification
device? - Correct Answers ✅1 flash per second
What is the minimum mounting height for audible notification
devices? - Correct Answers ✅90" to the top of the device
What is the minimum mounting height for visible notification
devices? - Correct Answers ✅Such that the entire lens is
not less then 80"
What is the formula for Ohm's Law - Correct Answers
✅Voltage=Current X Resistence
When using your mult-meter to measure, you must: -
Correct Answers ✅Put your meter in series with the circuit
Waterflow devices shall be tested with that frequency? -
Correct Answers ✅Semi-annually
, NICET LEVEL 1 Questions and Answers
(Top Grade Assured) 2026 Update
With what frequency shall ionization smoke detectors be
given a functional test? - Correct Answers ✅Annually
What are the standby power requirements for a proprietary
signaling system? - Correct Answers ✅24 hours in normal
operation, 5 minutes in alarm
Which of the following is a type of auxiliary protective
signaling system? - Correct Answers ✅Shunt type
Remote station signaling systems are permitted to send
signals to: - Correct Answers ✅A UL listed central station
A receiver located at an unlisted monitoring facility
A fire department or communications center
Non-power limited fire alarm cable shall have an insulation
rating of: - Correct Answers ✅600V
Which of these HVAC systems would require duct detectors
on supply and return? - Correct Answers ✅20,000 CFM
HVAC system serving a single floor
15,000 CFM HVAC system serving 3 floors
20,000 CFM HVAC system serving 2 floors
(Top Grade Assured) 2026 Update
what is the maximum number of 14 AWG RHH conductors
which can be installed in 1/2 rigid metal conduit? - Correct
Answers ✅4 wires
Which of the following would be an appropriate mounting
height for a pull station? - Correct Answers ✅3.5'-48" to
the actuator
What is the minimum flash rate for a visible notification
device? - Correct Answers ✅1 flash per second
What is the minimum mounting height for audible notification
devices? - Correct Answers ✅90" to the top of the device
What is the minimum mounting height for visible notification
devices? - Correct Answers ✅Such that the entire lens is
not less then 80"
What is the formula for Ohm's Law - Correct Answers
✅Voltage=Current X Resistence
When using your mult-meter to measure, you must: -
Correct Answers ✅Put your meter in series with the circuit
Waterflow devices shall be tested with that frequency? -
Correct Answers ✅Semi-annually
, NICET LEVEL 1 Questions and Answers
(Top Grade Assured) 2026 Update
With what frequency shall ionization smoke detectors be
given a functional test? - Correct Answers ✅Annually
What are the standby power requirements for a proprietary
signaling system? - Correct Answers ✅24 hours in normal
operation, 5 minutes in alarm
Which of the following is a type of auxiliary protective
signaling system? - Correct Answers ✅Shunt type
Remote station signaling systems are permitted to send
signals to: - Correct Answers ✅A UL listed central station
A receiver located at an unlisted monitoring facility
A fire department or communications center
Non-power limited fire alarm cable shall have an insulation
rating of: - Correct Answers ✅600V
Which of these HVAC systems would require duct detectors
on supply and return? - Correct Answers ✅20,000 CFM
HVAC system serving a single floor
15,000 CFM HVAC system serving 3 floors
20,000 CFM HVAC system serving 2 floors
