NTN FireTEAM Study Set EXAM
ACTUAL EXAM QUESTIONS AND
CORRECT DETAILED SOLUTIONS
LATEST JUST RELEASED
Terms in this set (50)
What do you use to tighten a bolt socket wrench
What shape is a drillbit used for metal sleek shape, not pointed, no pertruding edges for operations
at high speed to go through hard metal or sometimes
wood
what shape drillbit is hand operated for the tip is a threaded point, pertruding edges to cut through
drilling wood soft wood.
what shape drillbit is used from squared off tip bit
ceramics/masonry
small gear vs big gear, what turns faster? Big gear
When installing Bolt w/ washer and Threaded end goes away from body to prevent hazard
nut, what side faces you?
What tool is used to cut bolts? Hacksaw (NOT BOLTCUTTERS)
Mechanical Brick Factory: What do you do if Stop, call mechanic
there is unmelted material?
Mechanical Brick Factory: If you want more Adjust amount released by Hopper, DONT adjust speed of
material from the start of the assembly, what belt
do you do?
Mechanical Brick Factory: If the first grinder There is a jam in the grinder
is stuck, what do you suspect?
Mechanical Brick Factory: How do you fix a You put it in reverse manually
grinder jam?
Mechanical Brick Factory: How do you 1. Loosen middle nut
remove a molding station arm? 2.then remove end nut
Mechanical Brick Factory: If water is pouring Green Filter CLOG
over the edge, what do you suspect is
wrong?
ACTUAL EXAM QUESTIONS AND
CORRECT DETAILED SOLUTIONS
LATEST JUST RELEASED
Terms in this set (50)
What do you use to tighten a bolt socket wrench
What shape is a drillbit used for metal sleek shape, not pointed, no pertruding edges for operations
at high speed to go through hard metal or sometimes
wood
what shape drillbit is hand operated for the tip is a threaded point, pertruding edges to cut through
drilling wood soft wood.
what shape drillbit is used from squared off tip bit
ceramics/masonry
small gear vs big gear, what turns faster? Big gear
When installing Bolt w/ washer and Threaded end goes away from body to prevent hazard
nut, what side faces you?
What tool is used to cut bolts? Hacksaw (NOT BOLTCUTTERS)
Mechanical Brick Factory: What do you do if Stop, call mechanic
there is unmelted material?
Mechanical Brick Factory: If you want more Adjust amount released by Hopper, DONT adjust speed of
material from the start of the assembly, what belt
do you do?
Mechanical Brick Factory: If the first grinder There is a jam in the grinder
is stuck, what do you suspect?
Mechanical Brick Factory: How do you fix a You put it in reverse manually
grinder jam?
Mechanical Brick Factory: How do you 1. Loosen middle nut
remove a molding station arm? 2.then remove end nut
Mechanical Brick Factory: If water is pouring Green Filter CLOG
over the edge, what do you suspect is
wrong?
