26208-17 Conductor Terminations & Splices
26208-17 Conductor Terminations & Splices
Study online at https://quizlet.com/_9m9qbz
1. To properly install heat-shrink insulators, _____. Slip the insulator over the con-
nector and apply heat for a few
seconds
2. When used in control cable, which of the following Drain wires
must be grounded in order to be effective?
3. To determine the correct connector size for MC ca- Refer to the manufacturer liter-
ble, _____. ature
4. Burnishes, nicks, and scrapes are generally the re- Poorly stripped conductors
sult of which of the following?
5. When stripping conductors, be sure to _____. Cut the insulation so that no
frayed pieces or threads extend
past the point of cut off
6. Which of the following inscriptions on a wire con- AL-CU
nector indicates that it is designed for use on both
copper and aluminum wire?
7. A true statement concerning solid versus stranded The diameters are different
conductors is _____.
8. Wire connectors marked only with the wire size Copper conductors
should only be used on _____.
9. A good electrical connection should ____. Be mechanically and electrical-
ly secure
10. Heat-shrink insulators are intented to provide _____. Strain relief protection
11. Before a splice or connection can be made to a Type Conductor ends must be
THHN conductor, the _____. stripped and cleaned
1/2
26208-17 Conductor Terminations & Splices
Study online at https://quizlet.com/_9m9qbz
1. To properly install heat-shrink insulators, _____. Slip the insulator over the con-
nector and apply heat for a few
seconds
2. When used in control cable, which of the following Drain wires
must be grounded in order to be effective?
3. To determine the correct connector size for MC ca- Refer to the manufacturer liter-
ble, _____. ature
4. Burnishes, nicks, and scrapes are generally the re- Poorly stripped conductors
sult of which of the following?
5. When stripping conductors, be sure to _____. Cut the insulation so that no
frayed pieces or threads extend
past the point of cut off
6. Which of the following inscriptions on a wire con- AL-CU
nector indicates that it is designed for use on both
copper and aluminum wire?
7. A true statement concerning solid versus stranded The diameters are different
conductors is _____.
8. Wire connectors marked only with the wire size Copper conductors
should only be used on _____.
9. A good electrical connection should ____. Be mechanically and electrical-
ly secure
10. Heat-shrink insulators are intented to provide _____. Strain relief protection
11. Before a splice or connection can be made to a Type Conductor ends must be
THHN conductor, the _____. stripped and cleaned
1/2
