NEIEP 800 final 2025 Update |Complete
Exam Set Questions And Verified Answers
(solutions) | Get It 100% Accurate!!|
Already Passed A+
Hydro elevators in low rise applications do not need
an _____ _____ room. - ANSWER-overhead
machine
Some advantages of hydros are lower equipment
and building construction costs because the load of
a hydro is carried to the _____ where as the load of
a traction car is carried by the _____ _____. -
ANSWER-ground, building structure
When drilling the jack hole, the only proper way to
determine if the hole is plumb is to remove the drill
,stem and bit and use a _____ _____. - ANSWER-
Spider Bob
To plumb the hole, a spider bob is attached to a
length of piano wire suspended from as near as
possible to the top of the _____ or from a fixed point
on the drill rig. - ANSWER-Hoistway
When welding a joint, lay _____ inch tack welds
_____ degrees apart, shift it 90 degrees and lay two
more 1 inch tack welds 180 degrees apart. -
ANSWER-1, 180
On power units having the motor beneath the tank,
the pump may be either _____ driven or _____
coupled. - ANSWER-belt, direct
The purpose of the _____/_____ is to silence the
effect of any pulsations in the pump output and
should be as close to the pump as possible. -
ANSWER-silencer, muffler
,On Bolsters/Bolster Assembly, the plunger is
fastened to the _____ _____ which is then mounted
to the center of the Bolster Assembly. - ANSWER-
platen plate
With wye-delta, reduced current starting is
accomplished without the need for _____. -
ANSWER-resistors
_____ run buttons should run the platform and sling
at leveling speeds only. - ANSWER-Temporary
A _____ _____ consists of a piston held closed by
an adjustable spring and must open at a certain
pressure to prevent any further increase in pressure.
- ANSWER-relief valve
A _____ lowering valve allows the car to be lowered
at a speed not exceeding 20fpm in case of power
failure. - ANSWER-manual
, As the oil temperature changes, the _____ will
change as well and will effect the performance, more
specifically, the leveling and approach of the
elevator. - ANSWER-viscosity
Be sure wellways are properly _____ to avoid
accidental injury to you, your team or anyone
working outside of our industry. - ANSWER-
barricaded
Barricades around the wellway must be _____
inches high and be capable of withstanding a
_____lb force. - ANSWER-42, 200
A _____ protects you if you come in contact with a
hot wire or component and then come in contact
with ground. It opens the circuit and diverts the
supplied current to ground. - ANSWER-GFCI
A _____ _____ is useful for horizontal (side-to-side)
pulling of the truss while being lowered into the
wellway. - ANSWER-lever hoist
Exam Set Questions And Verified Answers
(solutions) | Get It 100% Accurate!!|
Already Passed A+
Hydro elevators in low rise applications do not need
an _____ _____ room. - ANSWER-overhead
machine
Some advantages of hydros are lower equipment
and building construction costs because the load of
a hydro is carried to the _____ where as the load of
a traction car is carried by the _____ _____. -
ANSWER-ground, building structure
When drilling the jack hole, the only proper way to
determine if the hole is plumb is to remove the drill
,stem and bit and use a _____ _____. - ANSWER-
Spider Bob
To plumb the hole, a spider bob is attached to a
length of piano wire suspended from as near as
possible to the top of the _____ or from a fixed point
on the drill rig. - ANSWER-Hoistway
When welding a joint, lay _____ inch tack welds
_____ degrees apart, shift it 90 degrees and lay two
more 1 inch tack welds 180 degrees apart. -
ANSWER-1, 180
On power units having the motor beneath the tank,
the pump may be either _____ driven or _____
coupled. - ANSWER-belt, direct
The purpose of the _____/_____ is to silence the
effect of any pulsations in the pump output and
should be as close to the pump as possible. -
ANSWER-silencer, muffler
,On Bolsters/Bolster Assembly, the plunger is
fastened to the _____ _____ which is then mounted
to the center of the Bolster Assembly. - ANSWER-
platen plate
With wye-delta, reduced current starting is
accomplished without the need for _____. -
ANSWER-resistors
_____ run buttons should run the platform and sling
at leveling speeds only. - ANSWER-Temporary
A _____ _____ consists of a piston held closed by
an adjustable spring and must open at a certain
pressure to prevent any further increase in pressure.
- ANSWER-relief valve
A _____ lowering valve allows the car to be lowered
at a speed not exceeding 20fpm in case of power
failure. - ANSWER-manual
, As the oil temperature changes, the _____ will
change as well and will effect the performance, more
specifically, the leveling and approach of the
elevator. - ANSWER-viscosity
Be sure wellways are properly _____ to avoid
accidental injury to you, your team or anyone
working outside of our industry. - ANSWER-
barricaded
Barricades around the wellway must be _____
inches high and be capable of withstanding a
_____lb force. - ANSWER-42, 200
A _____ protects you if you come in contact with a
hot wire or component and then come in contact
with ground. It opens the circuit and diverts the
supplied current to ground. - ANSWER-GFCI
A _____ _____ is useful for horizontal (side-to-side)
pulling of the truss while being lowered into the
wellway. - ANSWER-lever hoist
