AUMT1410SEC1 Exam Questions Part 3 Questions with Correct Answers
Question 1:
Brake rotor service is being discussed. Technician A says the first item to be removed after the
wheel assembly and caliper, if equipped, is the nut lock and adjusting nut. Technician B says the
thrust washer is removed after the adjusting nut. Who is correct?
Answer:
Both A and B
Question 2:
Technician A says servo action is accomplished by the opposing forces of the two disc pads per
wheel. Technician B says drum brakes require higher application pressure because their shape
is similar to that of the drum. Who is correct?
Answer:
A only
Question 3:
A self powered test light, sometimes called a continuity tester, is used to test a circuit with
current flowing in the circuit from the circuit's power supply.
Answer:
False
Question 4:
A brake pedal assembly has a 9-inch lever and the master cylinder pushrod is 1.5 inches from
the fulcrum. If the driver applies 50 pounds of force to the pedal, how much force will be
applied to the master cylinder?
Answer:
300 pounds
Question 5:
Technician A says the first check of the suspension should be with the vehicle supported on a
lift. Technician B says the first check of the suspension should be the springs through ride
height. Who is correct?
Answer:
Neither A nor B
Question 1:
Brake rotor service is being discussed. Technician A says the first item to be removed after the
wheel assembly and caliper, if equipped, is the nut lock and adjusting nut. Technician B says the
thrust washer is removed after the adjusting nut. Who is correct?
Answer:
Both A and B
Question 2:
Technician A says servo action is accomplished by the opposing forces of the two disc pads per
wheel. Technician B says drum brakes require higher application pressure because their shape
is similar to that of the drum. Who is correct?
Answer:
A only
Question 3:
A self powered test light, sometimes called a continuity tester, is used to test a circuit with
current flowing in the circuit from the circuit's power supply.
Answer:
False
Question 4:
A brake pedal assembly has a 9-inch lever and the master cylinder pushrod is 1.5 inches from
the fulcrum. If the driver applies 50 pounds of force to the pedal, how much force will be
applied to the master cylinder?
Answer:
300 pounds
Question 5:
Technician A says the first check of the suspension should be with the vehicle supported on a
lift. Technician B says the first check of the suspension should be the springs through ride
height. Who is correct?
Answer:
Neither A nor B
