1
Locksmith Test 2025-2026 Edition.
Questions with Correct Answers. Graded
A
1 - ANS Which choice below represents a true input?
1/8" - ANS How much should you cut off the tip of the key for a Type II
Chrysler in order to access ignition failures?
10 minutes - ANS What is Jim's average time to make a car key?
100 lbs - ANSManhole covers should be over ____ or otherwise designed
to require the use of tools to open.
12,4,8 - ANSThe Johnson Pacific with the key operated LaGard Lock has
what standard bolt configuration?
13% - ANSToday, approximately _______ of America's aluminum
production is utilized for building products.
1935 - ANSIn what year did GM invent the side bar wafer lock?
3 - ANSLocal restaurant owner has three locations
1
, 2
36" (3ft) - ANSRelays that control Life Safety Functioms are mounted within
what distance of the equipment they control?
360 - ANSThe first thing you must do when side-punching a round head, in-
floor safe is ensure the head will rotate _______ degrees.
3mm - ANSWhat size of ball detent was added to the 5th chamber to
prevent lock bumping?
4 - ANSHow many screws are in the lock housing end cap of the Detex
Advantex hardware?
413AA - ANSWhich key code indicates there are only two levels of keying?
6 - ANSWhat depth # was the key Jake was referring to cut?
6.5 ft - ANSThe minimum head room of working spaces about service
equipment, switch-boards, panel boards, or motor control centers should be
______.
650 - ANSRound access openings in a manhole shall not be less than ____
mm in diameter.
90 - ANSIn all cases, the work space should permit at least a _____ degree
opening equipment doors or hinged panels.
2
Locksmith Test 2025-2026 Edition.
Questions with Correct Answers. Graded
A
1 - ANS Which choice below represents a true input?
1/8" - ANS How much should you cut off the tip of the key for a Type II
Chrysler in order to access ignition failures?
10 minutes - ANS What is Jim's average time to make a car key?
100 lbs - ANSManhole covers should be over ____ or otherwise designed
to require the use of tools to open.
12,4,8 - ANSThe Johnson Pacific with the key operated LaGard Lock has
what standard bolt configuration?
13% - ANSToday, approximately _______ of America's aluminum
production is utilized for building products.
1935 - ANSIn what year did GM invent the side bar wafer lock?
3 - ANSLocal restaurant owner has three locations
1
, 2
36" (3ft) - ANSRelays that control Life Safety Functioms are mounted within
what distance of the equipment they control?
360 - ANSThe first thing you must do when side-punching a round head, in-
floor safe is ensure the head will rotate _______ degrees.
3mm - ANSWhat size of ball detent was added to the 5th chamber to
prevent lock bumping?
4 - ANSHow many screws are in the lock housing end cap of the Detex
Advantex hardware?
413AA - ANSWhich key code indicates there are only two levels of keying?
6 - ANSWhat depth # was the key Jake was referring to cut?
6.5 ft - ANSThe minimum head room of working spaces about service
equipment, switch-boards, panel boards, or motor control centers should be
______.
650 - ANSRound access openings in a manhole shall not be less than ____
mm in diameter.
90 - ANSIn all cases, the work space should permit at least a _____ degree
opening equipment doors or hinged panels.
2
