NWSA TTT-1 Study Guide Exam Questions and
Answers
1. Who is the third party group that approves and endorses standards?:
American National Standards Institute
2. What term is used to describe the documents written by members, or
peers, in the industry?: Standards
3. A company's health, safety and environment policy should be a
combination of labor regulations and ?: Industry standards
4. Where OSHA has not promulgated specific standards, who is
responsible for following the acts general clause?: Employer
5. On a job site who should be involved in the JHA process?: The Whole Crew
6. What does the Term SOW stand for?: Scope Of Work
7. The letters JHA stand for what ?: Job Hazard Assessment
8. When using a extension ladder, how many feet past the platform
must it extend?: 3
1/
10
, 9. If you have a sixteen foot ladder leaning against a building wall, how
many feet from the wall does the case need to by to have the correct
slope?: 4
10. Work boots with ankle support are recommended for all work
sites?: True
11. What do the letters PPE stand for ?: Personal Protective Equipment
12. What does the ground fault circuit interrupter (GFCI) do?: Senses a
short circuit, prevents electrocution , shuts off the flow of electricity
13. Who is responsible for providing PPE?: Employer
14. When using a y-lanyard attached to your back d-ring, at what
height should the connection to your anchorage be placed? extend?:
Shoulder level or above
15. What is the maximum distance between the sternal d-ring and
the fixed safety climb?: Nine inches
16. When calculating a fall distance using a "6 foot" energy
absorbed, what is the maximum pull out distance?: Four feey
17. What is the minimum force that a work positioning system
2/
10
Answers
1. Who is the third party group that approves and endorses standards?:
American National Standards Institute
2. What term is used to describe the documents written by members, or
peers, in the industry?: Standards
3. A company's health, safety and environment policy should be a
combination of labor regulations and ?: Industry standards
4. Where OSHA has not promulgated specific standards, who is
responsible for following the acts general clause?: Employer
5. On a job site who should be involved in the JHA process?: The Whole Crew
6. What does the Term SOW stand for?: Scope Of Work
7. The letters JHA stand for what ?: Job Hazard Assessment
8. When using a extension ladder, how many feet past the platform
must it extend?: 3
1/
10
, 9. If you have a sixteen foot ladder leaning against a building wall, how
many feet from the wall does the case need to by to have the correct
slope?: 4
10. Work boots with ankle support are recommended for all work
sites?: True
11. What do the letters PPE stand for ?: Personal Protective Equipment
12. What does the ground fault circuit interrupter (GFCI) do?: Senses a
short circuit, prevents electrocution , shuts off the flow of electricity
13. Who is responsible for providing PPE?: Employer
14. When using a y-lanyard attached to your back d-ring, at what
height should the connection to your anchorage be placed? extend?:
Shoulder level or above
15. What is the maximum distance between the sternal d-ring and
the fixed safety climb?: Nine inches
16. When calculating a fall distance using a "6 foot" energy
absorbed, what is the maximum pull out distance?: Four feey
17. What is the minimum force that a work positioning system
2/
10
