CWB Inspector Level 1 – Drawings, Joints & Preparation for Welding Exam Questions and Answers | Welding Symbols & Blueprint Reading Study Guide 2026/2027

CWB Inspector Level 1 - Drawings, joints and Prep for Welding
(1) exam questions and answers with complete solutions
verified latest update



What number of dimensions are
required to evaluate a


C fillet weld's size? A) 1 B) 2 C) 3
D) 4

GO back to test to practice weld symbols questions.

A weld symbol shown on the top
of the reference line


A applies to:
A) the other side of the joint.
B) the arrow side of the joint.
C) both sides of the joint.
D) all joints of the same design (typical).

, Disadvantages of water jet cutting include: C
A) high initial cost, straight line cutting only, limited to
cutting thin steel plate thicknesses
and disposal of spent water
contaminated with abrasives.
B) it is limited to cutting ferrous
materials only, high initial cost,
and frequent nozzle
replacement.
C) high initial cost, frequent
nozzle replacement, disposal of
spent water contaminated
with abrasives and high noise
level.
D) high noise level, limited to cutting metals only.

Dimension lines are generally
placed so that the drawing


B may be read from the: A)
bottom and left-hand edge of
the sheet.
B) bottom and right-hand edge of the sheet.
C) left and right-hand edge of the sheet.
D) top and right-hand edge of the sheet.

What is the maximum number