Written by students who passed Immediately available after payment Read online or as PDF Wrong document? Swap it for free 4.6 TrustPilot
logo-home
Document preview thumbnail
Preview 4 out of 66 pages
Exam (elaborations)

ASMIRT MRI Accreditation Exam Questions Version 2 /ASMIRT MRI Accreditation prep Exam Questions and Answers Practice Questions with Solutions Newest | Already Graded A+

Document preview thumbnail
Preview 4 out of 66 pages

ASMIRT MRI Accreditation Exam Questions Version 2 /ASMIRT MRI Accreditation prep Exam Questions and Answers Practice Questions with Solutions Newest | Already Graded A+

Content preview

, ASMIRT MRI Accreditation Exam Questions Version
2/ASMIRT MRI Accreditation prep Exam Questions
and Answers Practice Questions with Solutions
Newest | Already Graded A+


1. In a diffusion-weighted imaging sequence, the b-value is increased from 1000 s/mm² to 2000
s/mm². Which of the following best describes the effect on the signal-to-noise ratio (SNR) and the
sensitivity to water diffusion?

A. SNR increases and sensitivity to diffusion decreases
B. SNR decreases and sensitivity to diffusion increases
C. SNR increases and sensitivity to diffusion increases
D. SNR decreases and sensitivity to diffusion decreases

Answer: B
Rationale: Higher b-values increase diffusion weighting, making the signal more sensitive to diffusion,
but also reduce the overall signal due to longer TE and stronger gradients, thus decreasing SNR.
Options A and C are incorrect because SNR does not increase with higher b-values. Option D is
incorrect because sensitivity increases, not decreases.


2. A patient with a metallic implant undergoes an MRI at 1.5 T. The implant is known to be
non-ferromagnetic but has a high magnetic susceptibility. Which artifact is most likely to be
observed and what is the best method to reduce it?

A. Chemical shift artifact; increase receiver bandwidth
B. Susceptibility artifact; use a spin-echo sequence with short TE
C. Motion artifact; apply respiratory gating
D. Zipper artifact; check RF shielding

Answer: B
Rationale: High susceptibility materials cause local magnetic field inhomogeneities, leading to signal
loss and geometric distortion, especially in gradient-echo sequences. Using a spin-echo sequence with a
short TE minimizes dephasing and reduces susceptibility artifact. Chemical shift artifact (A) is due to
fat-water frequency differences, not metal. Motion (C) and zipper (D) artifacts are unrelated.


3. In parallel imaging using GRAPPA, the acceleration factor is set to 2. If the number of k-space
lines acquired is 128, how many reference lines are typically required for calibration, and what is
the primary advantage of this technique?

A. 32 lines; reduced specific absorption rate (SAR)
B. 64 lines; improved SNR
C. 16 lines; reduced scan time




Page 1

,D. 32 lines; reduced motion artifacts

Answer: A
Rationale: GRAPPA typically requires an additional set of auto-calibration signal (ACS) lines, often
about 10-20% of the total k-space lines. For 128 lines, 32 lines (25%) is a reasonable estimate. The
primary advantage is reduced scan time, but a secondary benefit is reduced SAR due to fewer RF pulses.
Option B is incorrect because SNR decreases with acceleration. Option D is not a primary advantage.


4. A researcher is designing a study to evaluate hepatic steatosis using MRI. Which of the following
sequences and parameters would provide the most accurate quantification of liver fat fraction?
A. T1-weighted spin-echo with fat saturation
B. T2*-weighted gradient-echo with multiple echo times
C. Diffusion-weighted imaging with b=50 s/mm²
D. Chemical shift-encoded imaging with multi-echo acquisition and correction for T2* decay

Answer: D
Rationale: Chemical shift-encoded imaging (e.g., IDEAL or Dixon) with multi-echo acquisition and T2*
correction allows accurate fat quantification by separating water and fat signals and accounting for T2*
decay. Option A only suppresses fat, not quantify. Option B is sensitive to iron, not fat. Option DWI is
not specific for fat.


5. In a balanced steady-state free precession (bSSFP) sequence, banding artifacts occur due to
off-resonance effects. Which of the following strategies is most effective at reducing these artifacts?
A. Increasing the flip angle
B. Decreasing the repetition time (TR)
C. Using a frequency scout to adjust the center frequency
D. Applying a phase-cycled acquisition with multiple phase increments

Answer: D
Rationale: Banding artifacts in bSSFP arise from signal voids at off-resonance frequencies where the
steady-state is disrupted. Phase-cycled acquisition (e.g., multiple acquisitions with different RF phase
increments) can shift the band locations, and combining images can eliminate them. Decreasing TR
reduces the spacing between bands but does not eliminate them. Increasing flip angle increases signal
but not banding. Frequency scout helps but is less effective than phase cycling.


6. A technologist notices that the MRI scanner's shim settings are not optimal during a brain scan.
Which of the following artifacts is most likely to be exacerbated?
A. Gibbs ringing
B. Chemical shift artifact
C. Moiré fringes
D. Partial volume artifact

Answer: B
Rationale: Poor shimming causes inhomogeneities in the main magnetic field (B0), which worsens
chemical shift artifact because the frequency difference between fat and water becomes more variable
across the field of view. Gibbs ringing (A) is due to truncation of k-space. Moiré fringes (C) are from
undersampling. Partial volume (D) is from slice thickness.


Page 2

, 7. In MR spectroscopy of the brain, a peak at 1.3 ppm is observed. Which metabolite is most likely
responsible, and what pathological condition is it associated with?

A. Lactate; hypoxia
B. Lipids; tumor necrosis
C. N-acetylaspartate; neuronal loss
D. Choline; membrane turnover

Answer: B
Rationale: Lipids resonate at 1.3 ppm and are typically not seen in normal brain spectra. Their presence
indicates necrosis, often in high-grade tumors or abscesses. Lactate (A) has a doublet at 1.33 ppm but is
usually inverted at short TE. NAA (C) is at 2.02 ppm. Choline (D) is at 3.2 ppm.


8. A cardiac MRI examination is performed to assess myocardial viability. Which sequence is most
appropriate, and what is the typical appearance of infarcted myocardium?
A. T2-weighted dark-blood turbo spin-echo; hyperintense
B. Late gadolinium enhancement (LGE) inversion recovery gradient-echo; hyperintense
C. Cine balanced SSFP; hypointense
D. First-pass perfusion gradient-echo; hypointense

Answer: B
Rationale: LGE imaging with an inversion recovery sequence is the gold standard for viability. Infarcted
myocardium shows delayed enhancement (hyperintense) due to gadolinium accumulation in fibrotic
tissue. T2-weighted imaging (A) shows edema, not fibrosis. Cine (C) shows wall motion abnormalities.
First-pass perfusion (D) shows hypoperfusion.


9. In contrast-enhanced MR angiography (CE-MRA), the timing of the contrast bolus is critical.
Which of the following methods best ensures optimal arterial enhancement while minimizing
venous contamination?

A. Fixed delay of 20 seconds after contrast injection
B. Automated bolus detection with real-time triggering and a centric k-space ordering
C. Test bolus injection with time-resolved imaging
D. Elliptical centric ordering with a long acquisition window

Answer: B
Rationale: Automated bolus detection (e.g., fluoroscopic triggering) combined with centric k-space
ordering (central lines acquired first) ensures maximal arterial enhancement and minimizes venous
contamination. Fixed delay (A) is unreliable. Test bolus (C) is helpful but time-resolved imaging may
have lower spatial resolution. Elliptical centric (D) with long acquisition may increase venous signal.


10. A patient with claustrophobia requires an MRI of the lumbar spine. Which of the following is
the most appropriate strategy to reduce scan time while maintaining diagnostic quality?
A. Use a surface coil with higher sensitivity and increase the number of signal averages
B. Apply parallel imaging with an acceleration factor of 2 and reduce the matrix size
C. Increase the slice thickness to 5 mm and use a 256x256 matrix
D. Decrease the field of view to 20 cm and use a 512x512 matrix




Page 3

Document information

Uploaded on
July 31, 2026
Number of pages
66
Written in
2025/2026
Type
Exam (elaborations)
Contains
Questions & answers
$22.99

Wrong document? Swap it for free Within 14 days of purchase and before downloading, you can choose a different document. You can simply spend the amount again.
Written by students who passed
Immediately available after payment
Read online or as PDF

Sold
1
Followers
1
Items
722
Last sold
1 month ago


Why students choose Stuvia

Created by fellow students, verified by reviews

Quality you can trust: written by students who passed their tests and reviewed by others who've used these notes.

Didn't get what you expected? Choose another document

No worries! You can instantly pick a different document that better fits what you're looking for.

Pay as you like, start learning right away

No subscription, no commitments. Pay the way you're used to via credit card and download your PDF document instantly.

Student with book image

“Bought, downloaded, and aced it. It really can be that simple.”

Alisha Student

Working on your references?

Create accurate citations in APA, MLA and Harvard with our free citation generator.

Working on your references?

Frequently asked questions