Written by students who passed Immediately available after payment Read online or as PDF Wrong document? Swap it for free 4.6 TrustPilot
logo-home
Exam (elaborations)

A-5 Excavating, Grading and Oil Surfacing Comprehensive Resource To Help You Ace Exams Includes Frequently Tested Questions With ELABORATED 100% Correct COMPLETE SOLUTIONS Guaranteed Pass First Attempt!! Current Update!!

Rating
-
Sold
-
Pages
22
Grade
A+
Uploaded on
25-07-2026
Written in
2025/2026

A-5 Excavating, Grading and Oil Surfacing Comprehensive Resource To Help You Ace Exams Includes Frequently Tested Questions With ELABORATED 100% Correct COMPLETE SOLUTIONS Guaranteed Pass First Attempt!! Current Update!! In road construction the final grading is commonly guided by stakes at subgrade elevations. What are these stakes called? - Correct Answer: Blue Tops What is the definition of a type of soil that can be excavated with vertical side slopes and remain intact while exposed? - Correct Answer: Stable Rock According to OSHA, refueling trucks handling flammable materials must carry a fire extinguisher rated at not less than: - Correct Answer: 20-B:C: Using a builder's level, a cut stake is being set for the excavation of a footing. The top of the footing will at an elevation of 94.00 feet. A backsite to the benchmark (elevation 102.50 feet) has a rod reading of 4.70 feet. The rod reading of the mark on the cut stake is 6.20 feet. The footing is 6 inches thick. The mark on the cut stake should read. ? - Correct Answer: C 7.50 If a rectangular shaped or other structure has edge measurements of 56 feet by 90 feet, the diagonal measurement should be feet if all the corners are square. - Correct Answer: 106 Refer to the illustration, which number identifies the catch point? - Correct Answer: 2 On a plan where 1/2" equals 1 foot, a plan distance of 4-1/4" would have a project distance of ? - Correct Answer: 8'6" According to OSHA, ladders (or steps) are required in all trenches or ditches at feet or more in depth for an adequate means of exit. - Correct Answer: 4 feet

Show more Read less
Institution
A-5 Excavating, Grading And Oil Surfacing
Course
A-5 Excavating, Grading and Oil Surfacing

Content preview

A-5 Excavating, Grading and Oil Surfacing Comprehensive Resource To Help You Ace 2026-
2027 Exams Includes Frequently Tested Questions With ELABORATED 100% Correct
COMPLETE SOLUTIONS Guaranteed Pass First Attempt!! Current Update!!

In road construction the final grading is commonly guided
by stakes at subgrade elevations. What are these stakes Blue Tops
called?
What is the definition of a type of soil that can be excavated
Stable Rock
with vertical side slopes and remain intact while exposed?
According to OSHA, refueling trucks handling flammable
materials must carry a fire extinguisher rated at not less 20-B:C:
than:
Using a builder's level, a cut stake is being set for the
excavation of a footing. The top of the footing will at
an elevation of 94.00 feet. A backsite to the benchmark
(elevation 102.50 feet) has a rod reading of 4.70 feet. The C 7.50
rod reading of the mark on the cut stake is 6.20 feet. The
footing is 6 inches thick. The mark on the cut stake should
read. ?
If a rectangular shaped or other structure has edge mea-
surements of 56 feet by 90 feet, the diagonal measure-
106
ment should be feet if all the corners are
square.
2

Refer to the illustration, which number identifies the catch
point?


On a plan where 1/2" equals 1 foot, a plan distance of
8'6"
4-1/4" would have a project distance of ?
According to OSHA, ladders (or steps) are required in all
trenches or ditches at feet or more in depth for 4 feet
an adequate means of exit.


, A-5 Excavating, Grading and Oil Surfacing Comprehensive Resource To Help You Ace 2026-
2027 Exams Includes Frequently Tested Questions With ELABORATED 100% Correct
COMPLETE SOLUTIONS Guaranteed Pass First Attempt!! Current Update!!

What is the definition of grade? Rise over run
While trenching and excavating, OSHA requires that em-
ployees be protected from excavated materials and oth-
er materials stored near the trench or excavation. These 2 feet
materials must be at least from the trench or
excavation.
If a bucket holds 2.5 cubic yards of foliated rock, how much
4 to 6 cubic yards
will it hold if it is heaped up with loamy soil?
The volume change that occurs when soil goes from a
compacted state to an uncompacted state (such as when Swell
being excavated) is called:
Best adhesion between asphalt cement and aggregate is
Hot and dry
achieved when aggregate is in what state?
What type of retaining wall is designed and built to use
Gravity
only its own weight and positioning to keep soil back?
What does a standard proctor test determine? Soil density and optimum moisture content of the soil
The maximum lateral distance allowed to any means of
egress from a trench excavation that is 4 feet or more in 25
depth is?
All of the following Soil provisions are considered expan-
sive except for:

- more than 10% of soil particles pass a #200 sieve At least 9% of soil particles are less than 5 micrometers in
- a plasticity index of 15 or greater size
- at least 9% of soil particles are less than 5 micrometers
in size
- an expansion index greater than 20
What is the correct nozzle angle on a spray bar? 15-30 degrees
What is added to hot mixed asphalt to make it more fluid? Asphalt cement or moisture


, undercut (over beak)

What is indicated by "J" on the illustration?



152 feet 4 inches

Refer to the illustration. What is the finished elevation of
lot no. 409?


What grading operation requires the most operator skill? Finish grading
Who has the authority to change or adjust the shoring
Engineer
method of an excavation?
An instrument used to measure horizontal changes and
Dumpy level or builders level
elevations is a ?
Subsoil drains should be surrounded with: Coarse gravel
Unsuitable soil can be recognized by a rolling movement
of the ground as equipment runs over it. What is this Pumping
commonly called?
The sides of a 6 foot deep trench in type B soil which is
sloped to prevent cave-ins should have a maximum slope 45 degrees from vertical
angle of ?
Before each shift safety regulations require that you must
check equipment for all the following except:

- fuel and oil levels Fuel and oil levels
- horn
- operational controls
- emergency brake

Written for

Institution
A-5 Excavating, Grading and Oil Surfacing
Course
A-5 Excavating, Grading and Oil Surfacing

Document information

Uploaded on
July 25, 2026
Number of pages
22
Written in
2025/2026
Type
Exam (elaborations)
Contains
Questions & answers

Subjects

$11.99
Get access to the full document:

Wrong document? Swap it for free Within 14 days of purchase and before downloading, you can choose a different document. You can simply spend the amount again.
Written by students who passed
Immediately available after payment
Read online or as PDF

Get to know the seller

Seller avatar
Reputation scores are based on the amount of documents a seller has sold for a fee and the reviews they have received for those documents. There are three levels: Bronze, Silver and Gold. The better the reputation, the more your can rely on the quality of the sellers work.
EWLindy Harvard University
View profile
Follow You need to be logged in order to follow users or courses
Sold
765
Member since
3 year
Number of followers
431
Documents
8358
Last sold
16 hours ago
EN.CY.CLO.PE.DI.A

As a Career Tutor, I understand the pressure of managing demanding coursework, exams, and practical requirements across multiple disciplines. These professionally organized revision materials are designed to support students in nursing, healthcare administration, business, information systems, Engineering, health, IT, or trade courses management programs by simplifying complex concepts and reinforcing high-yield academic content. The materials are developed to help students: Understand core theories and practical applications across Multiple Disciplines Review exam relevant content aligned with undergraduate and graduate curriculam To Strengthen critical thinking, analytical reasoning, and decision-making skills Save time with clear, structured summaries instead of overwhelming textbooks Prepare efficiently for tests, assignments, case studies, and professional exams Each resource is created with academic standards in mind, integrating real world examples, industry terminology, and evidence based concepts commonly required in professional programs. Whether you are studying nursing fundamentals, healthcare management, information systems, project management, business strategy, Engineering these materials provide focused, reliable support for academic success. These revision guides are ideal for: Nursing and allied health students Healthcare administration and public health students Business, MBA, and management students Information technology and information systems students, engineering, business, IT, or trade courses If you are looking for clear, student-friendly, exam-focused revision materials that support multiple career pathways, these resources are designed to help you study smarter, perform better, and stay confident throughout your academic journey. WISH YOU SUCCESS!!

Read more Read less
3.7

113 reviews

5
57
4
14
3
17
2
6
1
19

Why students choose Stuvia

Created by fellow students, verified by reviews

Quality you can trust: written by students who passed their tests and reviewed by others who've used these notes.

Didn't get what you expected? Choose another document

No worries! You can instantly pick a different document that better fits what you're looking for.

Pay as you like, start learning right away

No subscription, no commitments. Pay the way you're used to via credit card and download your PDF document instantly.

Student with book image

“Bought, downloaded, and aced it. It really can be that simple.”

Alisha Student

Working on your references?

Create accurate citations in APA, MLA and Harvard with our free citation generator.

Working on your references?

Frequently asked questions