PROPANE FINAL PRACTICE QUESTIONS
WITH CORRECT ANSWERS
Cylinders stored within a residential building, including the basement or
| | | | | | | | | |
any storage area in a common basement of a multiple-family building
| | | | | | | | | | |
and attached or detached garages, shall be limited to cylinders each
| | | | | | | | | | |
with a maximum water capacity of _______ and shall NOT exceed 5.4 lb
| | | | | | | | | | | | |
aggregate water capacity per each living space unit. - CORRECT
| | | | | | | | | |
ANSWER✔✔-2.7 lbs |
All new Class I permit holders must provide bulk storage capacity of NOT
| | | | | | | | | | | |
less than an aggregate of ___________ water gallons. - CORRECT
| | | | | | | | | | |
ANSWER✔✔-18,000
LP-gas containers shall be located __________ unless specifically
| | | | | | | |
allowed to be inside. - CORRECT ANSWER✔✔-Outside buildings
| | | | | | |
Effective January 1, 1993, a ________ shall be applied to all portable
| | | | | | | | | | | |
refillable LP-Gas cylinders of 100 lbs or less NOT filled on site. - CORRECT
| | | | | | | | | | | | |
ANSWER✔✔-Warning Label
| |
,A Type B or Type L gas vent shall terminate at least _________ in vertical
| | | | | | | | | | | | | |
height above the highest connected appliance draft hood or flue collar. -
| | | | | | | | | | | |
CORRECT ANSWER✔✔-5 feet
| | |
All appliances using electrical controls shall have the controls connected
| | | | | | | | |
into a ________. - CORRECT ANSWER✔✔-Permanently live circuit
| | | | | | | |
All LP gases shall be _______ prior to delivery with a warning agent
| | | | | | | | | | | | |
down to a concentration in air of NOT over 1/5 the lower flammability
| | | | | | | | | | | | |
limit. - CORRECT ANSWER✔✔-Odorized
| | |
All metallic equipment and components that are ______ shall be coated
| | | | | | | | | |
or protected and maintained to minimize corrosion. - CORRECT
| | | | | | | | | |
ANSWER✔✔-Buried or mounded | |
The upper flammability limit of propane vapor is _____. - CORRECT
| | | | | | | | | | |
ANSWER✔✔-9.6
A sniff test is done to ______ when LP-gas is delivered to the bulk plant.
| | | | | | | | | | | | | |
- CORRECT ANSWER✔✔-Detect odorization
| | | |
A clearly identified and accessible switch or circuit breaker shall be
| | | | | | | | | | |
installed at a location NOT less than _______ or more than 100 feet
| | | | | | | | | | | | |
, from the dispensing device to shut off power in the event of a fire,
| | | | | | | | | | | | | |
accident, or other emergency. - CORRECT ANSWER✔✔-20 feet
| | | | | | |
Where work is being performed on piping that contains gas, provisions
| | | | | | | | | | |
for ___________ shall be made before alterations are made in a metallic
| | | | | | | | | | |
|piping system. - CORRECT ANSWER✔✔-Electrical continuity
| | | | |
Air for cooling, heating, or ventilation distributed to habitable spaces is
| | | | | | | | | | |
known as __________. - CORRECT ANSWER✔✔-Circulating air
| | | | | |
ASME code refers to the __________ of the American Society of
| | | | | | | | | | |
Mechanical Engineers. - CORRECT ANSWER✔✔-Boiler and pressure
| | | | | | |
vessel code |
A chimney for residential type or low heat appliances shall extend at
| | | | | | | | | | | |
least 2 feet higher than any portion of a building with a horizontal
| | | | | | | | | | | | |
distance of __________. - CORRECT ANSWER✔✔-10 feet
| | | | | |
The location where connections and disconnections are made or where
| | | | | | | | | |
LP-Gas vented to the atmosphere in the course of transfer operations is
| | | | | | | | | | | |
known as __________. - CORRECT ANSWER✔✔-Point of transfer
| | | | | | |
Appliances or equipment that, because of their intended modes of use
| | | | | | | | | | |
or operation, are capable of providing sufficient thermal energy to ignite
| | | | | | | | | |
WITH CORRECT ANSWERS
Cylinders stored within a residential building, including the basement or
| | | | | | | | | |
any storage area in a common basement of a multiple-family building
| | | | | | | | | | |
and attached or detached garages, shall be limited to cylinders each
| | | | | | | | | | |
with a maximum water capacity of _______ and shall NOT exceed 5.4 lb
| | | | | | | | | | | | |
aggregate water capacity per each living space unit. - CORRECT
| | | | | | | | | |
ANSWER✔✔-2.7 lbs |
All new Class I permit holders must provide bulk storage capacity of NOT
| | | | | | | | | | | |
less than an aggregate of ___________ water gallons. - CORRECT
| | | | | | | | | | |
ANSWER✔✔-18,000
LP-gas containers shall be located __________ unless specifically
| | | | | | | |
allowed to be inside. - CORRECT ANSWER✔✔-Outside buildings
| | | | | | |
Effective January 1, 1993, a ________ shall be applied to all portable
| | | | | | | | | | | |
refillable LP-Gas cylinders of 100 lbs or less NOT filled on site. - CORRECT
| | | | | | | | | | | | |
ANSWER✔✔-Warning Label
| |
,A Type B or Type L gas vent shall terminate at least _________ in vertical
| | | | | | | | | | | | | |
height above the highest connected appliance draft hood or flue collar. -
| | | | | | | | | | | |
CORRECT ANSWER✔✔-5 feet
| | |
All appliances using electrical controls shall have the controls connected
| | | | | | | | |
into a ________. - CORRECT ANSWER✔✔-Permanently live circuit
| | | | | | | |
All LP gases shall be _______ prior to delivery with a warning agent
| | | | | | | | | | | | |
down to a concentration in air of NOT over 1/5 the lower flammability
| | | | | | | | | | | | |
limit. - CORRECT ANSWER✔✔-Odorized
| | |
All metallic equipment and components that are ______ shall be coated
| | | | | | | | | |
or protected and maintained to minimize corrosion. - CORRECT
| | | | | | | | | |
ANSWER✔✔-Buried or mounded | |
The upper flammability limit of propane vapor is _____. - CORRECT
| | | | | | | | | | |
ANSWER✔✔-9.6
A sniff test is done to ______ when LP-gas is delivered to the bulk plant.
| | | | | | | | | | | | | |
- CORRECT ANSWER✔✔-Detect odorization
| | | |
A clearly identified and accessible switch or circuit breaker shall be
| | | | | | | | | | |
installed at a location NOT less than _______ or more than 100 feet
| | | | | | | | | | | | |
, from the dispensing device to shut off power in the event of a fire,
| | | | | | | | | | | | | |
accident, or other emergency. - CORRECT ANSWER✔✔-20 feet
| | | | | | |
Where work is being performed on piping that contains gas, provisions
| | | | | | | | | | |
for ___________ shall be made before alterations are made in a metallic
| | | | | | | | | | |
|piping system. - CORRECT ANSWER✔✔-Electrical continuity
| | | | |
Air for cooling, heating, or ventilation distributed to habitable spaces is
| | | | | | | | | | |
known as __________. - CORRECT ANSWER✔✔-Circulating air
| | | | | |
ASME code refers to the __________ of the American Society of
| | | | | | | | | | |
Mechanical Engineers. - CORRECT ANSWER✔✔-Boiler and pressure
| | | | | | |
vessel code |
A chimney for residential type or low heat appliances shall extend at
| | | | | | | | | | | |
least 2 feet higher than any portion of a building with a horizontal
| | | | | | | | | | | | |
distance of __________. - CORRECT ANSWER✔✔-10 feet
| | | | | |
The location where connections and disconnections are made or where
| | | | | | | | | |
LP-Gas vented to the atmosphere in the course of transfer operations is
| | | | | | | | | | | |
known as __________. - CORRECT ANSWER✔✔-Point of transfer
| | | | | | |
Appliances or equipment that, because of their intended modes of use
| | | | | | | | | | |
or operation, are capable of providing sufficient thermal energy to ignite
| | | | | | | | | |
