Preparation: Practice Questions,
Correct Answers & Rationales
Reference Analysis – Major Topic Areas Identified:
· Structural Pest Control (Termites, Wood-
Destroying Organisms)
· General Pest Control (Cockroaches, Ants,
Rodents, Stored Product Pests)
· Pesticide Formulations & Classifications
· Application Equipment Operation & Calibration
· Safety Protocols & PPE Requirements
· Regulatory Compliance (FIFRA, State Laws)
· Environmental Protection (Groundwater, Drift,
Runoff)
· Integrated Pest Management (IPM) Principles
· Pesticide Toxicity & Human Health Effects
· Professional Standards & Documentation
· Biology & Behavior of Key Pests
EXAMINATION – 80 QUESTIONS
,QUESTION 1
A pest control technician discovers an infestation in a commercial
bakery where small beetles are found in flour and cereal
products. The beetles are approximately 1/8 inch long, reddish-
brown, and have a distinct snout. These pests are most likely:
A. Cigarette beetles
B. Flour beetles
C. Rice weevils
D. Drugstore beetles
CORRECT ANSWER: C. Rice weevils
RATIONALE: Rice weevils (Sitophilus oryzae) are characterized by
their small size, reddish-brown color, and elongated snout
(rostrum). They are common stored product pests that infest
grains, flour, and cereal products. Their snout distinguishes them
from other stored product beetles like flour beetles and cigarette
beetles.
QUESTION 2
When applying a wettable powder formulation with a compressed
air sprayer, which maintenance issue is most likely to occur if the
sprayer is not properly cleaned after use?
A. Corrosion of the tank
B. Clogging of the nozzle and strainer
C. Deterioration of the hose
,D. Gumming of the piston seal
CORRECT ANSWER: B. Clogging of the nozzle and strainer
RATIONALE: Wettable powders leave abrasive and insoluble
residues that settle in the tank and clog nozzles, strainers, and
hoses if not properly cleaned after each use. This can affect spray
pattern and application rate. The abrasive nature of wettable
powders makes thorough cleaning essential to maintain
equipment function.
QUESTION 3
A homeowner reports seeing large black ants approximately ½
inch long in their kitchen. The ants are seen primarily at night
and leave behind piles of sawdust-like material. These
characteristics indicate:
A. Pharaoh ants
B. Argentine ants
C. Carpenter ants
D. Odorous house ants
CORRECT ANSWER: C. Carpenter ants
RATIONALE: Carpenter ants (Camponotus species) are among the
largest ants found in structures, reaching up to ½ inch in length.
They are primarily nocturnal and excavate galleries in wood,
leaving behind frass (sawdust-like material containing wood
shavings and insect parts). Their nesting behavior creates
distinctive piles of debris near their galleries.
, QUESTION 4
The primary reason for calibrating spray equipment before each
use is to:
A. Ensure the equipment is functioning properly
B. Confirm the pesticide is correctly mixed
C. Verify the correct amount of pesticide is being applied to the
target area
D. Check for leaks in the system
CORRECT ANSWER: C. Verify the correct amount of pesticide is
being applied to the target area
RATIONALE: Calibration ensures that the equipment delivers the
accurate rate of pesticide per unit area specified on the label.
This prevents under-application (ineffective control) and over-
application (waste, potential environmental harm, and label
violations). While checking equipment function is important, the
primary purpose is accurate delivery.
QUESTION 5
A technician is inspecting a home and finds evidence of termite
damage in the floor joists. The inspector notices small, round,
light-colored pellets approximately 1 millimeter in length
scattered near the damaged area. These pellets are most likely
from:
A. Subterranean termites
B. Drywood termites