What class of drawings that are official Coast Guard Drawings that apply to more than
on class?
Give this one a try later!
Fleet drawings
This is the additional heat that is required to produce saturation at any specific
pressure?
Give this one a try later!
Super heat
,What should be the air gap for a potable hose connected to the potable water
system be when Diodefilling another system (IE Filling the ships jacket water system).
Give this one a try later!
2 times the diameter
What is the prime mover for the P6?
Give this one a try later!
6.5hp single cylinder four stroke engine
If a cutter is under pilot house control what should be done in regards to the bell
book?
Give this one a try later!
No bell book needs to be kept
On a cutter how many volts are personnel usually shocked by, that leads to death?
Give this one a try later!
115 volt
, Calibration interval for portable measuring instruments are controlled by?
Give this one a try later!
Metrology requirements list
What is the formula for finding cap end area
Give this one a try later!
Dsquared x .7854
Sudden opening of the gauge valve may cause _____ resulting in a reduction in
expected life damage?
Give this one a try later!
Severe strain
What type of maintenance is the performance scheduled and unscheduled tasks
designed to restore equipment to service able condition after a failure or pending
failure?
Give this one a try later!
on class?
Give this one a try later!
Fleet drawings
This is the additional heat that is required to produce saturation at any specific
pressure?
Give this one a try later!
Super heat
,What should be the air gap for a potable hose connected to the potable water
system be when Diodefilling another system (IE Filling the ships jacket water system).
Give this one a try later!
2 times the diameter
What is the prime mover for the P6?
Give this one a try later!
6.5hp single cylinder four stroke engine
If a cutter is under pilot house control what should be done in regards to the bell
book?
Give this one a try later!
No bell book needs to be kept
On a cutter how many volts are personnel usually shocked by, that leads to death?
Give this one a try later!
115 volt
, Calibration interval for portable measuring instruments are controlled by?
Give this one a try later!
Metrology requirements list
What is the formula for finding cap end area
Give this one a try later!
Dsquared x .7854
Sudden opening of the gauge valve may cause _____ resulting in a reduction in
expected life damage?
Give this one a try later!
Severe strain
What type of maintenance is the performance scheduled and unscheduled tasks
designed to restore equipment to service able condition after a failure or pending
failure?
Give this one a try later!
