RSE - Practice Test Latest ,recent and
frequently tested exam with
comprehensive questions and verified
accurate solution (detailed &
elaborated) GRADED A+
Professional Academic Assistance Services
Services Offered
Proctored Exam Assistance
Online Class Management (Full Course Support)
Exam Preparation & Study Materials
Assignments and Coursework Support
Essays and Research Papers
Discussion Posts and Replies
n an IPv6 routing table, all routing table entries are classified as which type of routes? - correct ans:level
1 ultimate routes
, A company security policy requires that all MAC addressing be dynamically learned and added to both
the MAC address table and the running configuration on each switch. Which port security configuration
will accomplish this? - correct ans:Mac security sticky
What command will enable a router to begin sending messages that allow it to configure a link-local
address without using an IPv6 DHCP server? - correct ans:the ipv6 unicast-routing command
A technician is configuring a switch to allow access both to IP phones and to PCs on interface Fa0/12.
The technician enters the interface command mls qos trust cos . What is the reason for including that
command? - correct ans:It is used to set the trusted state of an interface to allow classification of traffic
for QoS based on the CoS value of the IP phone.
A network administrator has entered the following command: ip route 192.168.10.64 255.255.255.192
serial0/0/1 When the network administrator enters the command show ip route , the route is not in the
routing table. What should the administrator do next? - correct ans:Verify that the serial 0/0/1 interface
is active and available.
A small business uses VLANs 8, 20, 25, and 30 on two switches that have a trunk link between them.
What native VLAN should be used on the trunk if Cisco best practices are being implemented? - correct
ans:5
Assuming that the routing tables are up to date and no ARP messages are needed, after a packet leaves
H1, how many times is the L2 header rewritten in the path to H2? - correct ans:2
Which switching method provides error-free data transmission? - correct ans:store-and-forward
To enable RIP routing for a specific subnet, the configuration command network 192.168.5.64 was
entered by the network administrator. What address, if any, appears in the running configuration file to
identify this network? - correct ans:192.168.5.0
The buffers for packet processing and the running configuration file are temporarily stored in which type
of router memory? - correct ans:Ram
frequently tested exam with
comprehensive questions and verified
accurate solution (detailed &
elaborated) GRADED A+
Professional Academic Assistance Services
Services Offered
Proctored Exam Assistance
Online Class Management (Full Course Support)
Exam Preparation & Study Materials
Assignments and Coursework Support
Essays and Research Papers
Discussion Posts and Replies
n an IPv6 routing table, all routing table entries are classified as which type of routes? - correct ans:level
1 ultimate routes
, A company security policy requires that all MAC addressing be dynamically learned and added to both
the MAC address table and the running configuration on each switch. Which port security configuration
will accomplish this? - correct ans:Mac security sticky
What command will enable a router to begin sending messages that allow it to configure a link-local
address without using an IPv6 DHCP server? - correct ans:the ipv6 unicast-routing command
A technician is configuring a switch to allow access both to IP phones and to PCs on interface Fa0/12.
The technician enters the interface command mls qos trust cos . What is the reason for including that
command? - correct ans:It is used to set the trusted state of an interface to allow classification of traffic
for QoS based on the CoS value of the IP phone.
A network administrator has entered the following command: ip route 192.168.10.64 255.255.255.192
serial0/0/1 When the network administrator enters the command show ip route , the route is not in the
routing table. What should the administrator do next? - correct ans:Verify that the serial 0/0/1 interface
is active and available.
A small business uses VLANs 8, 20, 25, and 30 on two switches that have a trunk link between them.
What native VLAN should be used on the trunk if Cisco best practices are being implemented? - correct
ans:5
Assuming that the routing tables are up to date and no ARP messages are needed, after a packet leaves
H1, how many times is the L2 header rewritten in the path to H2? - correct ans:2
Which switching method provides error-free data transmission? - correct ans:store-and-forward
To enable RIP routing for a specific subnet, the configuration command network 192.168.5.64 was
entered by the network administrator. What address, if any, appears in the running configuration file to
identify this network? - correct ans:192.168.5.0
The buffers for packet processing and the running configuration file are temporarily stored in which type
of router memory? - correct ans:Ram
