QUESTIONS AND CORRECT
ANSWERS RATED A+ 2026/2027
Before using an electric drill, what is the first thing you should do?
Make sure the diameter of the hole to be drilled is within the capacity of the
drill
The purpose of cutting lubricant in most drilling ops is to increase the
Drilling speed and drill bit life
Minimum protection using a bench grinder
eye and face protection
Lifting capacity of the MJ 1 series lift truck
3,000
Lifting capacity of MHU 83 lift truck
7,000
When using fork adapters on MHU 83 series lift truck
it reduces lifting capacity by 1,000
What happens when you release the accelerator pedal on a vehicle driven
with a hydrostatic transmission
the unit coasts to a stop very quickly
what is the primary drawback to using the hydraulic hand pump to build
hydraulic pressure on the MHU 83 lift truck
extremely slow way to build hydraulic pressure
How is the yaw positioning from the cradle or boom controls of an MJ 1 lift
truck adjusted
Manually
what condition would prevent an operator from applying power to a hoist or
other powered lifting device
an AF Form 979
most common type of lifting sling
wire rope
the enunciators displayed on the fluke 8025 series multimeter are used to
distinguish among
ohms, kilohm, and megohms
2 operational modes of the Fluke 8025
range and hold
the steering system on the MHU 141/ M trailer has a turning radius of how
many inches
,200
what transport module used for decoy munitions has a max capacity of 30
magazines
ALE- 50
How often should the positive locking devices on the doors of munitions
transport modules be checked
after loading, unloading and periodically between stops
the purpose of the transport beam beneath the lift arm assemblies on the
MJ- 1 series lift truck is to
provide added support and to relieve hydraulic pressure from the lift arms
when carrying loads for long distances
what category are Air Force air compressors classified?
high or low pressure
what is the purpose behind good operator maintenance of all assigned
vehicles
maintain vehicle serviceability at reduced cost
max amount thee MB 4 aircraft towing tractor can tow
140,000
pintle safety locking pins must remain attached to the pintle assembly
to prevent an insecure pin from coming out and getting lost
what gear should a tractor with automatic transmission while going downhill
low
what are hose couplers used for on tractor trailer combination
to connect the service and emergency brake airlines from the tractor to the
trailer
which procedure is not a consideration for backing a tractor trailer
combination
what transport module used for decoy munitions has a max capacity of 30
magazines
ALE- 50
How often should the positive locking devices on the doors of munitions
transport modules be checked
after loading, unloading and periodically between stops
the purpose of the transport beam beneath the lift arm assemblies on the
MJ- 1 series lift truck is to
provide added support and to relieve hydraulic pressure from the lift arms
when carrying loads for long distances
Lifting capacity of the MJ 1 series lift truck
3,000
,Lifting capacity of MHU 83 lift truck
7,000
When using fork adapters on MHU 83 series lift truck
it reduces lifting capacity by 1,000
What happens when you release the accelerator pedal on a vehicle driven
with a hydrostatic transmission
the unit coasts to a stop very quickly
what is the primary drawback to using the hydraulic hand pump to build
hydraulic pressure on the MHU 83 lift truck
extremely slow way to build hydraulic pressure
How is the yaw positioning from the cradle or boom controls of an MJ 1 lift
truck adjusted
Manually
what category are Air Force air compressors classified?
high or low pressure
When the MHU 141 trailer is loaded or towed with the hinged deck panels
open, what must be done?
the deck supports must be properly positioned and locked in place with
quick release pins
Max load capacity of the MHU 110/ M trailer
15,000
the parking brake on the MHU 110/ M is applied by
pulling either one of two hand levers located on each side of the front of
trailer
how many openings are on the deck of the MHU- 226 trailer
3
what type of steering aids the MHU- 226
four wheeled double ackerman
After 463L pallets are positioned on a rollerized trailer, what can you use to
secure the pallets
MB-1 chain assemblies and or tie down straps
what kind of movements supports on base activities to or from the flightline
operational
what is the purpose behind good operator maintenance of all assigned
vehicles
maintain vehicle serviceability at reduced cost
max amount thee MB 4 aircraft towing tractor can tow
140,000
pintle safety locking pins must remain attached to the pintle assembly
, to prevent an insecure pin from coming out and getting lost
what gear should a tractor with automatic transmission while going downhill
low
what are hose couplers used for on tractor trailer combination
to connect the service and emergency brake airlines from the tractor to the
trailer
which procedure is not a consideration for backing a tractor trailer
combination
turn towards the passengers side
with the forks level, what is the maximum reach of the variable reach forklift
22 feet
what USAF gun system is loaded and unloaded by the Linkless Ammo
Loading System (LALS)
the M61A1, 20mm cannon
Which weapons replaceable assembly of the Linkless Ammo Loading
System (LALS) has no moving parts
storage container
Which subassembly of the Universal ammo loading system (UALS) houses
a remaining indicator window that provides approximate number of rounds
in unit
Outer drum
Which subassembly of the UALS provides the means to load live rounds
into aircraft gun system
Interface Unit
What altitude is attainable by the M131 signal when fired
1,500 feet
largest caliber classified as small arms
.50
what type of explosive filler does an M26 frag grenade have
comp B
what filler for the M34 smoke grenade is
white phosphorus
explosive filler for M30 practice grenade
black powder
the AN-M8 smoke grenade uses hexachloroethane as a chemical filler to
produce what color
white
Claymore
M18A1