LS160
LS170
86585958 7/99
,TO THE OWNER:
This manual contains information concerning the adjustment and maintenance of your New Holland skid
steer. You have purchased a dependable machine, but only by proper care and operation can you expect to
receive the performance and long service built into this skid steer. PLEASE HAVE ALL OPERATORS READ
THIS MANUAL CAREFULLY AND KEEP IT AVAILABLE FOR READY REFERENCE.
This machine was designed to power and propel itself. It is intended to load and move materials with a variety
of buckets and forks. Allied attachments built and supplied by other manufacturers can be used on the skid
steer where recommended and approved by New Holland North America, Inc.
Your New Holland dealer will instruct you in the general operation of your skid steer. (Refer to the “Delivery
Report” at the back of this manual.) Your dealer’s staff of factory-trained service technicians will be glad to
answer any questions that may arise regarding the operation of your loader.
Your New Holland dealer carries a complete line of genuine New Holland service parts. These parts are
manufactured and carefully inspected in the same factories that built the skid steer, to insure high quality and
accurate fitting of any necessary replacement parts. Be prepared to give your dealer the model and serial
number of the engine and skid steer when ordering parts. Locate these numbers now and record them
below. Refer to the “General Information” section of this manual for the location of the model and serial
numbers of your loader.
Skid Steer Model Engine Model
Skid Steer Number Engine Serial Number
DANGER:
FASTEN SEAT BELT
BEFORE STARTING ENGINE!
THIS SKID STEER IS A VERY STABLE UNIT BUT IT CAN BE UPSET IF STOPPED SUDDENLY WHEN
THE BUCKET IS RAISED AND LOADED.
THEREFORE, DO NOT START THE ENGINE BEFORE SECURELY FASTENING THE SEAT BELT.
CAUTION: THIS SYMBOL IS USED THROUGHOUT THIS MANUAL WHENEVER PERSONAL SAFETY
IS INVOLVED. TAKE TIME TO READ AND FOLLOW THE INSTRUCTIONS. BE CAREFUL!
CAUTION: PICTURES IN THIS MANUAL MAY SHOW PROTECTIVE SHIELDING OPEN OR REMOVED
TO BETTER ILLUSTRATE A PARTICULAR FEATURE OR ADJUSTMENT.
BE CERTAIN, HOWEVER, TO CLOSE OR REPLACE ALL SHIELDING BEFORE OPERATING THE MA-
CHINE.
IMPROVEMENTS
New Holland North America, Inc. is continually striving to improve its products. We reserve the right to make
improvements or changes when it becomes practical and possible to do so, without incurring any obligation
to make changes or additions to the equipment sold previously.
148 ã 1999 NEW HOLLAND NORTH AMERICA, INC.
, FEDERAL EMISSIONS WARRANTY
New Holland warrants that your new 1998 N844T or 1999 N844 and later heavy-duty off-road diesel engine was designed, built, and equipped
to conform to applicable U.S. Environmental Protection Agency regulations for a period of use of five years or 3,000 hours of operation,
whichever occurs first.
The new model year, class of diesel engine, and emission application determination for your engine are identified on the emission control
information label affixed to the top of your engine’s rocker arm cover. The warranty period begins on the date the new equipment is sold to the
first retail purchaser.
Any emission control system parts which are proven defective during normal use will be repaired or replaced during the warranty period. The
warranty repairs and service will be performed by any authorized New Holland dealer at the dealer’s place of business, with no charge for parts
or labor (including diagnosis).
As the engine owner, you are responsible to perform all the required maintenance listed in your owner’s manual. New Holland will not deny an
emission warranty claim solely because you have no record of maintenance; however, a claim may be denied if your failure to perform
maintenance resulted in the failure of a warranted part. Receipts covering regular maintenance should be retained in the event of questions and
these receipts should be passed on to each subsequent owner of the engine.
It is recommended replacement parts used for maintenance or repairs be New Holland Service Parts to maintain the quality originally designed
into your emission certified engine. The use of non-New Holland parts does not invalidate the warranty on other components unless the use of
such parts causes damage to warranted parts.
New Holland wishes to assure the emission control systems warranty is being properly administered. If you believe you have not received the
service entitled to under this warranty, you should contact the nearest New Holland Branch Office for assistance. The address and phone
number of each Branch Office is in your vehicle owner’s manual. If additional assistance or information is needed, contact:
Service Department
New Holland North America, Inc.
500 Diller Avenue
New Holland, PA 17557
(717) 355-1121
Please note that the Emission Warranty does not cover:
1. Systems and parts that were not first installed on the new equipment or engine as original equipment by New Holland.
2. Part malfunctions caused by abuse, misuse, improper adjustment, modification, alteration, tampering, disconnection, improper or
inadequate maintenance, or use of non-recommended fuels and lubricating oils.
3. Accident caused damage, acts of nature, or other events beyond New Holland’s control.
4. Replacement of expendable items made in connection with scheduled maintenance.
5. Parts requiring replacement, inspection or adjustment maintenance intervals for reasons other than being defective.
6. Parts which are not New Holland Service Parts.
7. Loss of time, inconvenience, loss of use of equipment/engine or commercial loss.
8. Equipment with altered or disconnected hourmeter where the hours cannot be determined.
9. Equipment normally operated outside the United States.
10. Non-defective parts replaced by other than New Holland dealers.
Coverage
This emission control system warranty applies to the following N844T, N844 emission control parts.
Fuel Injection Pump
Fuel Injectors
Turbocharger
Intake Manifold
Charge Air Cooler
Exhaust Manifold
Boost Pressure Tubing-connection to Aneroid Device ON F.I.P.
0-1
, 0-2
LS170
86585958 7/99
,TO THE OWNER:
This manual contains information concerning the adjustment and maintenance of your New Holland skid
steer. You have purchased a dependable machine, but only by proper care and operation can you expect to
receive the performance and long service built into this skid steer. PLEASE HAVE ALL OPERATORS READ
THIS MANUAL CAREFULLY AND KEEP IT AVAILABLE FOR READY REFERENCE.
This machine was designed to power and propel itself. It is intended to load and move materials with a variety
of buckets and forks. Allied attachments built and supplied by other manufacturers can be used on the skid
steer where recommended and approved by New Holland North America, Inc.
Your New Holland dealer will instruct you in the general operation of your skid steer. (Refer to the “Delivery
Report” at the back of this manual.) Your dealer’s staff of factory-trained service technicians will be glad to
answer any questions that may arise regarding the operation of your loader.
Your New Holland dealer carries a complete line of genuine New Holland service parts. These parts are
manufactured and carefully inspected in the same factories that built the skid steer, to insure high quality and
accurate fitting of any necessary replacement parts. Be prepared to give your dealer the model and serial
number of the engine and skid steer when ordering parts. Locate these numbers now and record them
below. Refer to the “General Information” section of this manual for the location of the model and serial
numbers of your loader.
Skid Steer Model Engine Model
Skid Steer Number Engine Serial Number
DANGER:
FASTEN SEAT BELT
BEFORE STARTING ENGINE!
THIS SKID STEER IS A VERY STABLE UNIT BUT IT CAN BE UPSET IF STOPPED SUDDENLY WHEN
THE BUCKET IS RAISED AND LOADED.
THEREFORE, DO NOT START THE ENGINE BEFORE SECURELY FASTENING THE SEAT BELT.
CAUTION: THIS SYMBOL IS USED THROUGHOUT THIS MANUAL WHENEVER PERSONAL SAFETY
IS INVOLVED. TAKE TIME TO READ AND FOLLOW THE INSTRUCTIONS. BE CAREFUL!
CAUTION: PICTURES IN THIS MANUAL MAY SHOW PROTECTIVE SHIELDING OPEN OR REMOVED
TO BETTER ILLUSTRATE A PARTICULAR FEATURE OR ADJUSTMENT.
BE CERTAIN, HOWEVER, TO CLOSE OR REPLACE ALL SHIELDING BEFORE OPERATING THE MA-
CHINE.
IMPROVEMENTS
New Holland North America, Inc. is continually striving to improve its products. We reserve the right to make
improvements or changes when it becomes practical and possible to do so, without incurring any obligation
to make changes or additions to the equipment sold previously.
148 ã 1999 NEW HOLLAND NORTH AMERICA, INC.
, FEDERAL EMISSIONS WARRANTY
New Holland warrants that your new 1998 N844T or 1999 N844 and later heavy-duty off-road diesel engine was designed, built, and equipped
to conform to applicable U.S. Environmental Protection Agency regulations for a period of use of five years or 3,000 hours of operation,
whichever occurs first.
The new model year, class of diesel engine, and emission application determination for your engine are identified on the emission control
information label affixed to the top of your engine’s rocker arm cover. The warranty period begins on the date the new equipment is sold to the
first retail purchaser.
Any emission control system parts which are proven defective during normal use will be repaired or replaced during the warranty period. The
warranty repairs and service will be performed by any authorized New Holland dealer at the dealer’s place of business, with no charge for parts
or labor (including diagnosis).
As the engine owner, you are responsible to perform all the required maintenance listed in your owner’s manual. New Holland will not deny an
emission warranty claim solely because you have no record of maintenance; however, a claim may be denied if your failure to perform
maintenance resulted in the failure of a warranted part. Receipts covering regular maintenance should be retained in the event of questions and
these receipts should be passed on to each subsequent owner of the engine.
It is recommended replacement parts used for maintenance or repairs be New Holland Service Parts to maintain the quality originally designed
into your emission certified engine. The use of non-New Holland parts does not invalidate the warranty on other components unless the use of
such parts causes damage to warranted parts.
New Holland wishes to assure the emission control systems warranty is being properly administered. If you believe you have not received the
service entitled to under this warranty, you should contact the nearest New Holland Branch Office for assistance. The address and phone
number of each Branch Office is in your vehicle owner’s manual. If additional assistance or information is needed, contact:
Service Department
New Holland North America, Inc.
500 Diller Avenue
New Holland, PA 17557
(717) 355-1121
Please note that the Emission Warranty does not cover:
1. Systems and parts that were not first installed on the new equipment or engine as original equipment by New Holland.
2. Part malfunctions caused by abuse, misuse, improper adjustment, modification, alteration, tampering, disconnection, improper or
inadequate maintenance, or use of non-recommended fuels and lubricating oils.
3. Accident caused damage, acts of nature, or other events beyond New Holland’s control.
4. Replacement of expendable items made in connection with scheduled maintenance.
5. Parts requiring replacement, inspection or adjustment maintenance intervals for reasons other than being defective.
6. Parts which are not New Holland Service Parts.
7. Loss of time, inconvenience, loss of use of equipment/engine or commercial loss.
8. Equipment with altered or disconnected hourmeter where the hours cannot be determined.
9. Equipment normally operated outside the United States.
10. Non-defective parts replaced by other than New Holland dealers.
Coverage
This emission control system warranty applies to the following N844T, N844 emission control parts.
Fuel Injection Pump
Fuel Injectors
Turbocharger
Intake Manifold
Charge Air Cooler
Exhaust Manifold
Boost Pressure Tubing-connection to Aneroid Device ON F.I.P.
0-1
, 0-2
