DANTE CERTIFICATION LEVEL 2
COMPREHENSIVE EXAM 2026 FULL
QUESTIONS AND ANSWERS EXPERT
VERIFIED A+
●● What protocol does Dante for clocking?
Answer: A. NTP
B. PTP
C. SMPTE Time Code
●● As a simple rule of thumb, how much latency should be allowed per
network switch hop?
Answer: A. 0.001 msec (1 microsecond)
B. 0.01 msec (10 microseconds)
C. 0.1 msec (100
microseconds)
D. 1.0 msec
, ●● If a transmitting device runs out of flows, what should you do to
enable all subscriptions to be made?
Answer: A. Get a managed switch with Packet Propagation Protocol
(PPP) to duplicate a stream with new destination IP addresses.
B. Flip stream(s) to unicast so it only takes one flow for multiple
destinations.
C. Flip stream(s) to multicast so it only takes one flow for multiple
destinations.
D. Add a Dante AVIO "repeater" module, which will accept a stream and
retransmit it with up to 32 more streams.
●● The redundant port allows for a second network connection in case
the first fails. Which describes the operation?
Answer: A. Primary and secondary can be connected in the same
broadcast domain (VLAN). If one cable fails, the other will take over.
B. The secondary network is dormant until a problem is encoutered on
the primary. In that case, the primary network shuts down, and the
secondary network starts sending and receiving data.
COMPREHENSIVE EXAM 2026 FULL
QUESTIONS AND ANSWERS EXPERT
VERIFIED A+
●● What protocol does Dante for clocking?
Answer: A. NTP
B. PTP
C. SMPTE Time Code
●● As a simple rule of thumb, how much latency should be allowed per
network switch hop?
Answer: A. 0.001 msec (1 microsecond)
B. 0.01 msec (10 microseconds)
C. 0.1 msec (100
microseconds)
D. 1.0 msec
, ●● If a transmitting device runs out of flows, what should you do to
enable all subscriptions to be made?
Answer: A. Get a managed switch with Packet Propagation Protocol
(PPP) to duplicate a stream with new destination IP addresses.
B. Flip stream(s) to unicast so it only takes one flow for multiple
destinations.
C. Flip stream(s) to multicast so it only takes one flow for multiple
destinations.
D. Add a Dante AVIO "repeater" module, which will accept a stream and
retransmit it with up to 32 more streams.
●● The redundant port allows for a second network connection in case
the first fails. Which describes the operation?
Answer: A. Primary and secondary can be connected in the same
broadcast domain (VLAN). If one cable fails, the other will take over.
B. The secondary network is dormant until a problem is encoutered on
the primary. In that case, the primary network shuts down, and the
secondary network starts sending and receiving data.
