study guide
1. The NEC is updated on a regular cycle. How many years between editions?
ANSWER ✓ 3 years
2. Which Article of the NEC contains definitions for terms used throughout the code?
ANSWER ✓ Article 100
3. A device that opens and closes a circuit by nonautomatic means and automatically
closes for a predetermined overcurrent is defined in Article 100 as a:
ANSWER ✓ Circuit breaker
4. What does the term "Ampacity" mean as defined in NEC Article 100?
ANSWER ✓ The maximum current a conductor can carry continuously without
exceeding its temperature rating
5. According to NEC Article 100, "Continuous Load" means a load where the maximum
current is expected to continue for how many hours?
ANSWER ✓ 3 hours or more
6. Which Article of the NEC covers the requirements for grounding and bonding?
ANSWER ✓ Article 250
7. Annex _______ of the NEC covers conduit and tubing fill for conductors and fixture
wire.
ANSWER ✓ Annex C
8. What is the primary purpose of a grounding electrode system as outlined in NEC
250.4(A)(1)?
ANSWER ✓ Limit voltage imposed by lightning, line surges, or unintentional contact
with higher-voltage lines
9. NEC Table 250.66 is used to size which component of a grounding system?
ANSWER ✓ Grounding electrode conductors
10. A main bonding jumper is required to be what color per NEC guidelines?
ANSWER ✓ Green
, 11. True or False: A subpanel in the same building requires a bonding screw installed.
ANSWER ✓ False
12. The minimum size equipment grounding conductor required for a 100-amp
overcurrent protective device, according to NEC Table 250.122, is:
ANSWER ✓ 8 AWG copper
13. According to NEC 250.8, sheet metal screws can be used for bonding only if they
are:
ANSWER ✓ Green with hexagonal heads
14. NEC Article 230 covers requirements for:
ANSWER ✓ Services (service conductors and equipment)
15. The required clearance for a service drop of not over 600V above a residential
property driveway is:
ANSWER ✓ 12 feet
16. According to NEC 230.9(A), an uninsulated service conductor must be at least how
many feet from an operable window?
ANSWER ✓ 3 feet
17. Which NEC Article covers the installation requirements for Rigid Metal Conduit
(RMC)?
ANSWER ✓ Article 342
18. Which NEC Article covers Electrical Metallic Tubing (EMT)?
ANSWER ✓ Article 358
19. The requirements for Nonmetallic-Sheathed Cable (Romex®) are found in NEC:
ANSWER ✓ Article 334
20. According to NEC 334.12, NM cable (Romex®) is NOT permitted in which of the
following locations?
ANSWER ✓ In dropped ceilings of commercial buildings used as return air plenums
21. What is the minimum bending radius for NM cable according to NEC 334.24?
ANSWER ✓ 5 times the cable diameter
22. Which NEC Article covers the installation of cable trays?
ANSWER ✓ Article 392