1|Page
CSA S304 Masonry Design Standards Exam Practice
Questions And Correct Answers||Verified Exam!!!
(Verified Answers) Plus Rationale 2026/2027 Q&A|
Instant Download Pdf
The packaged mortar that includes measured quantities of
all needed materials except water is called:
a) preblended mortar
b) ready-mix mortar
c) masonry cement
d) mortar blend - Answer-a) preblended mortar
Water that is used in mortar must be:
a) filtered
b) potable
c) between 40 degrees and 70 degrees f
d) purified - Answer-b) potable
ASTM specifies that Type S mortar must withstand a
compression of at least
a) 750 psi
,2|Page
b) 1,250 psi
c) 1,800 psi
d) 2,500 psi - Answer-c) 1,800 psi
How well mortar sticks to itself is referred to as:
a) cohesion
b) compressive strength
c) adhesion
d) tensile strength - Answer-a) cohesion
The approximate percentage of a masonry structure's
surface represented by mortar is around?
A) 1 percent
b) 5 percent
c) 20 percent
d) 40 percent - Answer-c) 20 percent
Of the materials used in mortar, the one that is least
uniform is:
a) lime
b) Portland cement
c) water
,3|Page
d) sand - Answer-d) sand
Mortar and masonry units form a bond that is basically:
a) frictional
b) mechanical
c) chemical
d) positional - Answer-b) mechanical
Mortar receives strength from the:
a) sand percentage
b) length of curing time
c) cement content
d) amount of lime - Answer-c) cement content
Adding too much water when mixing mortar is referred to
as:
a) overwatering
b) flooding the mortar
c) overloading
d) drowning the mortar - Answer-d) drowning the mortar
, 4|Page
To avoid the need for extensive tempering, a batch of
mixed mortar should be used within:
a) one hour
b) two hours
c) three hours
d) four hours - Answer-b) two hours
Under low-temperature conditions, mortar should be
mixed with cement designated as:
a) Type 1
b) Type II
c) Type III
d) Type IV - Answer-Type III
MASONRY - Answer-
the building structures from individual units laid in and
bound together by mortar, and can also refer to the unit
itself - Answer-masonry
name the common materials of masonry construction -
Answer-brick, stone, concrete block, glass block, stucco,
and tile
CSA S304 Masonry Design Standards Exam Practice
Questions And Correct Answers||Verified Exam!!!
(Verified Answers) Plus Rationale 2026/2027 Q&A|
Instant Download Pdf
The packaged mortar that includes measured quantities of
all needed materials except water is called:
a) preblended mortar
b) ready-mix mortar
c) masonry cement
d) mortar blend - Answer-a) preblended mortar
Water that is used in mortar must be:
a) filtered
b) potable
c) between 40 degrees and 70 degrees f
d) purified - Answer-b) potable
ASTM specifies that Type S mortar must withstand a
compression of at least
a) 750 psi
,2|Page
b) 1,250 psi
c) 1,800 psi
d) 2,500 psi - Answer-c) 1,800 psi
How well mortar sticks to itself is referred to as:
a) cohesion
b) compressive strength
c) adhesion
d) tensile strength - Answer-a) cohesion
The approximate percentage of a masonry structure's
surface represented by mortar is around?
A) 1 percent
b) 5 percent
c) 20 percent
d) 40 percent - Answer-c) 20 percent
Of the materials used in mortar, the one that is least
uniform is:
a) lime
b) Portland cement
c) water
,3|Page
d) sand - Answer-d) sand
Mortar and masonry units form a bond that is basically:
a) frictional
b) mechanical
c) chemical
d) positional - Answer-b) mechanical
Mortar receives strength from the:
a) sand percentage
b) length of curing time
c) cement content
d) amount of lime - Answer-c) cement content
Adding too much water when mixing mortar is referred to
as:
a) overwatering
b) flooding the mortar
c) overloading
d) drowning the mortar - Answer-d) drowning the mortar
, 4|Page
To avoid the need for extensive tempering, a batch of
mixed mortar should be used within:
a) one hour
b) two hours
c) three hours
d) four hours - Answer-b) two hours
Under low-temperature conditions, mortar should be
mixed with cement designated as:
a) Type 1
b) Type II
c) Type III
d) Type IV - Answer-Type III
MASONRY - Answer-
the building structures from individual units laid in and
bound together by mortar, and can also refer to the unit
itself - Answer-masonry
name the common materials of masonry construction -
Answer-brick, stone, concrete block, glass block, stucco,
and tile
