NWSA TOWER TECHNICIAN
TRAINING LEVEL 2 (TTT-2)
EXAM QUESTIONS AND
ANSWERS 2026 -2027
Which is an unacceptable practice when hoisting personnel?
A. Following the directive's requirements
B. Bypassing safety devices
C. Using trained operators
D. Performing required checks
Ref: CPL 02-01-056 Guidance - ANSWERS-B
The best reason OSHA issued tower-hoist inspection procedures is:
A. Billing
B. Reduce Hazards of hoisting personnel on towers
C. Improve RF Coverage
D. Reduce Paint Costs
Ref: CPL 02-01-056 Purpose - ANSWERS-B
,Who should operate a personnel hoist on a tower?
A. Any Climber
B. Trained/Qualified Operator per Employer Program and Applicable
Requirements
C. Customer
D. Engineer Only
Ref: CPL 02-01-056 Guidance (Training/Competence Theme) -
ANSWERS-B
If weather deteriorates during hoist operations, the correct action is:
A. Continue
B.. Suspend Operations and reassess
C. Only warn crew
D. Speed Up
Ref: CPL Safety Approach + A10.48 Safe work practices -
ANSWERS-B
The hoist line should be protected from:
A. Taglines
B. Sharp edges and damage
C. Radios
D. Gloves
,Ref: CPL hoist safety concepts - ANSWERS-B
Pre-Use Checks should include verifying:
A. Sticker Placement
B. Brakes/Controls/Safety Devices function as intended
C. Lunch Schedule
D. RF Plot
Ref: CPL Inspection checklist conecpt - ANSWERS-B
The most common failure mode addressed by rigorous hoist
inspection is:
A. Paperwork error
B. Mechanical/rigging failure leading to fall/struck-by
RF Overexposure
D. Lighting outage
Ref: CPL Safety Intent - ANSWERS-B
If any critical component fail inspection:
A. Continue Anyway
B. Remove from Service until Corrected
C. Tape it
D. Use at half speed
, Ref: CPL Enforcement Logic - ANSWERS-B
Hoisting Personnel should be coordinated using:
A. No Communication
B. Clear Communication Protocol
C. Only texting
D. Customer Hand Signals
Ref: CPL Safety Practice Theme + A10.48 Communication Practices -
ANSWERS-B
The directive emphasizes that the inspection procedures apply to:
A. Only New Towers
B. All Hoisting of Personnel to/From Workstations on Towers
(Covered Scope)
C. Only 5G Sites
D. Only Microwave Sites
Ref: CPL "Covers all Hoisting..." - ANSWERS-B
Which is most likely to trigger additional scrutiny during hoisting?
A. Controlled Lift
B. Uncontrolled Load Movement
TRAINING LEVEL 2 (TTT-2)
EXAM QUESTIONS AND
ANSWERS 2026 -2027
Which is an unacceptable practice when hoisting personnel?
A. Following the directive's requirements
B. Bypassing safety devices
C. Using trained operators
D. Performing required checks
Ref: CPL 02-01-056 Guidance - ANSWERS-B
The best reason OSHA issued tower-hoist inspection procedures is:
A. Billing
B. Reduce Hazards of hoisting personnel on towers
C. Improve RF Coverage
D. Reduce Paint Costs
Ref: CPL 02-01-056 Purpose - ANSWERS-B
,Who should operate a personnel hoist on a tower?
A. Any Climber
B. Trained/Qualified Operator per Employer Program and Applicable
Requirements
C. Customer
D. Engineer Only
Ref: CPL 02-01-056 Guidance (Training/Competence Theme) -
ANSWERS-B
If weather deteriorates during hoist operations, the correct action is:
A. Continue
B.. Suspend Operations and reassess
C. Only warn crew
D. Speed Up
Ref: CPL Safety Approach + A10.48 Safe work practices -
ANSWERS-B
The hoist line should be protected from:
A. Taglines
B. Sharp edges and damage
C. Radios
D. Gloves
,Ref: CPL hoist safety concepts - ANSWERS-B
Pre-Use Checks should include verifying:
A. Sticker Placement
B. Brakes/Controls/Safety Devices function as intended
C. Lunch Schedule
D. RF Plot
Ref: CPL Inspection checklist conecpt - ANSWERS-B
The most common failure mode addressed by rigorous hoist
inspection is:
A. Paperwork error
B. Mechanical/rigging failure leading to fall/struck-by
RF Overexposure
D. Lighting outage
Ref: CPL Safety Intent - ANSWERS-B
If any critical component fail inspection:
A. Continue Anyway
B. Remove from Service until Corrected
C. Tape it
D. Use at half speed
, Ref: CPL Enforcement Logic - ANSWERS-B
Hoisting Personnel should be coordinated using:
A. No Communication
B. Clear Communication Protocol
C. Only texting
D. Customer Hand Signals
Ref: CPL Safety Practice Theme + A10.48 Communication Practices -
ANSWERS-B
The directive emphasizes that the inspection procedures apply to:
A. Only New Towers
B. All Hoisting of Personnel to/From Workstations on Towers
(Covered Scope)
C. Only 5G Sites
D. Only Microwave Sites
Ref: CPL "Covers all Hoisting..." - ANSWERS-B
Which is most likely to trigger additional scrutiny during hoisting?
A. Controlled Lift
B. Uncontrolled Load Movement
