Florida Construction Safety (OSHA)
Exam Practice Questions And Correct
Answers (Verified Answers) Plus
Rationale 2026 Q&A| Instant Download
Pdf
1. A construction superintendent on a multistory commercial project in
Florida notices that workers are operating near an unprotected roof
edge approximately 14 feet above the lower level while installing
HVAC ductwork. According to Occupational Safety and Health
Administration construction safety standards, which of the following is
the minimum required employer action to ensure compliance with fall
protection regulations in this situation?
A. Require workers to sign a waiver acknowledging the fall hazard before
beginning work
B. Provide and enforce the use of a compliant fall protection system such as
,guardrails, safety nets, or personal fall arrest systems
C. Allow workers to continue if they have more than five years of roofing
experience
D. Permit work without fall protection as long as warning lines are installed
3 feet from the edge
B. Provide and enforce the use of a compliant fall protection system such
as guardrails, safety nets, or personal fall arrest systems
Fall protection is required in construction when employees are exposed to
falls of 6 feet or more to a lower level. OSHA allows several compliant
systems, including guardrails, safety nets, and personal fall arrest systems,
but employers must ensure one is properly used and maintained.
2. A crew performing trenching operations for underground utility
installation encounters soil conditions that appear wet and unstable.
The trench depth is 8 feet, and employees must enter the trench to
complete pipe alignment. Which OSHA requirement applies most
directly before allowing employee entry?
A. The trench only requires caution tape and warning signs around the
perimeter
B. Employees may enter if they wear high-visibility vests and hard hats
C. A competent person must inspect the trench and a protective system
,must be used unless the excavation is entirely stable rock
D. Workers may enter if the trench is less than 10 feet wide
C. A competent person must inspect the trench and a protective system
must be used unless the excavation is entirely stable rock
OSHA excavation standards require protective systems such as sloping,
shielding, or shoring for trenches 5 feet or deeper unless the excavation is
in stable rock. A competent person must inspect excavations daily and
after hazard-increasing events such as rainstorms.
3. During demolition activities, an employee uses an extension cord with
visible insulation damage to power an electric saw. Which statement
best reflects OSHA electrical safety requirements for temporary wiring
and extension cords on construction sites?
A. Damaged cords may be used temporarily if electrical tape covers exposed
conductors
B. Extension cords are exempt from OSHA inspection requirements
C. Damaged or defective cords must be removed from service immediately
D. Employees may continue using damaged cords if the voltage is below 120
volts
C. Damaged or defective cords must be removed from service immediately
, OSHA requires employers to remove defective electrical equipment and
extension cords from service immediately to prevent shock, electrocution,
burns, and fire hazards. Temporary repairs with tape alone do not satisfy
compliance requirements.
4. A masonry contractor stores compressed gas cylinders near active
welding operations. Which OSHA requirement is most applicable
regarding cylinder storage and handling?
A. Oxygen and fuel gas cylinders may be stored together without separation
if indoors
B. Cylinders should be stored horizontally to prevent tipping
C. Valve protection caps must be in place when cylinders are not in use
D. Cylinders can be transported by dragging them across the floor
C. Valve protection caps must be in place when cylinders are not in use
Compressed gas cylinders must be stored upright, secured, and protected
from damage. Valve protection caps are required when cylinders are not
connected for use to reduce the risk of accidental release or explosion.
5. On a highway construction project, workers are exposed to moving
traffic while placing barriers. Which of the following OSHA-compliant
measures best protects employees in work zones?
Exam Practice Questions And Correct
Answers (Verified Answers) Plus
Rationale 2026 Q&A| Instant Download
1. A construction superintendent on a multistory commercial project in
Florida notices that workers are operating near an unprotected roof
edge approximately 14 feet above the lower level while installing
HVAC ductwork. According to Occupational Safety and Health
Administration construction safety standards, which of the following is
the minimum required employer action to ensure compliance with fall
protection regulations in this situation?
A. Require workers to sign a waiver acknowledging the fall hazard before
beginning work
B. Provide and enforce the use of a compliant fall protection system such as
,guardrails, safety nets, or personal fall arrest systems
C. Allow workers to continue if they have more than five years of roofing
experience
D. Permit work without fall protection as long as warning lines are installed
3 feet from the edge
B. Provide and enforce the use of a compliant fall protection system such
as guardrails, safety nets, or personal fall arrest systems
Fall protection is required in construction when employees are exposed to
falls of 6 feet or more to a lower level. OSHA allows several compliant
systems, including guardrails, safety nets, and personal fall arrest systems,
but employers must ensure one is properly used and maintained.
2. A crew performing trenching operations for underground utility
installation encounters soil conditions that appear wet and unstable.
The trench depth is 8 feet, and employees must enter the trench to
complete pipe alignment. Which OSHA requirement applies most
directly before allowing employee entry?
A. The trench only requires caution tape and warning signs around the
perimeter
B. Employees may enter if they wear high-visibility vests and hard hats
C. A competent person must inspect the trench and a protective system
,must be used unless the excavation is entirely stable rock
D. Workers may enter if the trench is less than 10 feet wide
C. A competent person must inspect the trench and a protective system
must be used unless the excavation is entirely stable rock
OSHA excavation standards require protective systems such as sloping,
shielding, or shoring for trenches 5 feet or deeper unless the excavation is
in stable rock. A competent person must inspect excavations daily and
after hazard-increasing events such as rainstorms.
3. During demolition activities, an employee uses an extension cord with
visible insulation damage to power an electric saw. Which statement
best reflects OSHA electrical safety requirements for temporary wiring
and extension cords on construction sites?
A. Damaged cords may be used temporarily if electrical tape covers exposed
conductors
B. Extension cords are exempt from OSHA inspection requirements
C. Damaged or defective cords must be removed from service immediately
D. Employees may continue using damaged cords if the voltage is below 120
volts
C. Damaged or defective cords must be removed from service immediately
, OSHA requires employers to remove defective electrical equipment and
extension cords from service immediately to prevent shock, electrocution,
burns, and fire hazards. Temporary repairs with tape alone do not satisfy
compliance requirements.
4. A masonry contractor stores compressed gas cylinders near active
welding operations. Which OSHA requirement is most applicable
regarding cylinder storage and handling?
A. Oxygen and fuel gas cylinders may be stored together without separation
if indoors
B. Cylinders should be stored horizontally to prevent tipping
C. Valve protection caps must be in place when cylinders are not in use
D. Cylinders can be transported by dragging them across the floor
C. Valve protection caps must be in place when cylinders are not in use
Compressed gas cylinders must be stored upright, secured, and protected
from damage. Valve protection caps are required when cylinders are not
connected for use to reduce the risk of accidental release or explosion.
5. On a highway construction project, workers are exposed to moving
traffic while placing barriers. Which of the following OSHA-compliant
measures best protects employees in work zones?
