License
Stationary
Part 3 –
Engineer
BoilerNYC
License
Systems,
Stationary
Part
Controls,
3 –
Engineer
Boiler
Safety,
License
Systems,
and Exam
Part
Controls,
3Study
– Boiler
Guide.pdf
Safety,
Systems,
and Exam
Controls,
Study Guide.pdf
Safety, and Exam Study Guide.pdf
NYC Stationary
Engineer License
Part 3 – Boiler
Systems, Controls,
Safety, and Exam
Study Guide
NYC Stationary EngineerNYC
License
Stationary
Part 3 –
Engineer
BoilerNYC
License
Systems,
Stationary
Part
Controls,
3 –
Engineer
Boiler
Safety,
License
Systems,
and Exam
Part
Controls,
3Study
– Boiler
Guide.pdf
Safety,
Systems,
and Exam
Controls,
Study Guide.pdf
Safety, and Exam Study Guide.pdf
,NYC Stationary Engineer License Part 3.pdf NYC Stationary Engineer License Part 3.pdf NYC Stationary Engineer License Part 3.pdf
Terms in this set (163)
Heating Surface All areas in contact with heated gases (fire tube
ID, Water tube OD)
Boiler pH The pH should be between 7-9 (8.5). Acid attack
pH below 8.5, caustic attack above 12.9.
Blowoff Tank Outlet Size 2 times the diameter of the blowdown piping, 6
inches internal entering the bottom of the blow
off tank.
NYC Stationary Engineer License Part 3.pdf NYC Stationary Engineer License Part 3.pdf NYC Stationary Engineer License Part 3.pdf
,NYC Stationary Engineer License Part 3.pdf NYC Stationary Engineer License Part 3.pdf NYC Stationary Engineer License Part 3.pdf
Clogged Strainers Deep vacuum.
Heat Recovery Steam Generators Water chemistry is harder to maintain during start
(HRSG) ups and shut down.
Welding Control An engineer supervising a welding company
approved by the D.O.B.
Remote Disconnect Label Remote control for burner.
Deficiency of Air Supply High heat loss.
NYC Stationary Engineer License Part 3.pdf NYC Stationary Engineer License Part 3.pdf NYC Stationary Engineer License Part 3.pdf
, NYC Stationary Engineer License Part 3.pdf NYC Stationary Engineer License Part 3.pdf NYC Stationary Engineer License Part 3.pdf
Electric Remote Shut Down Egress of the boiler room.
Location
Steam Gauge Dial Graduation Approx double the PSI that the safety valve is set
to, but never less than 1.5 times the pressure.
Certified Welder Report The welding agency, must be available to the
Maintenance DOB.
Standard Non-Mercury Gauge Label Name of manufacturer.
Boiler Requirements One pressure gauge.
NYC Stationary Engineer License Part 3.pdf NYC Stationary Engineer License Part 3.pdf NYC Stationary Engineer License Part 3.pdf