_ Career Engineer
and Exam–
Revision
LectureMaterial.pdf
NotesStationary
_ Career Engineer
and Exam–
Revision
LectureMaterial.pdf
Notes _ Career and Exam Revision Material.pdf
Stationary
Engineer – Lecture
Notes / Career and
Exam Revision
Material
Stationary Engineer – Lecture NotesStationary
_ Career Engineer
and Exam–
Revision
LectureMaterial.pdf
NotesStationary
_ Career Engineer
and Exam–
Revision
LectureMaterial.pdf
Notes _ Career and Exam Revision Material.pdf
,Stationary Engineer.pdf Stationary Engineer.pdf Stationary Engineer.pdf
Terms in this set (628)
How much clearance from the top of the boiler is 7 feet
needed for a HP boiler that produces 70000 lbs of
steam?
On a gas fired boiler what is the proper gas to air 30%-70% and in special arrangements it can be as high as 100% . ANSWER
mixture CHAPTER 11 remember%
What is the total hardness in a system that was found to TH=(Ca x 2.5) + (Mg x 4.1)\nTH=(60 x 2.5) + (18 x 4.1)\nTH= 150+73.8 =( 223.8 PPM)
have calcium hardness of 60ppm and magnesium
hardness of 18ppm and carbon hardness of 12 ppm?
How often should a complete external inspection of the Once a Shift
boiler be done?
With 24 hr operation how often do you check the water Once per shift
level?
How often do you check the LWCO? Once per shift
Stationary Engineer.pdf Stationary Engineer.pdf Stationary Engineer.pdf
,Stationary Engineer.pdf Stationary Engineer.pdf Stationary Engineer.pdf
How often do you check the High Limit Switch? Annually
A 2" pipe was found to be delivering water at 100 psia at GPM= V (diameter squared) divided by .4085 ANSWER pg 469 BOG
1040ft per second. How many gallons per hour will it
deliver?
What controls the amount of blowback on a safety Blowback ring or adjusting ring
valve?
On a open air expansion tank hot water boiler system; (4 Feet ) above the highest heating element.
how high should it be mounted?
What is the minimum top clearance of boilers with 5 feet
manholes?
Package boilers; steam heating boilers and hot water 2 feet from ceiling. Code chapter 10 page76
heating boilers shall have a minimum clearance of?
Most important safety device on a boiler? Safety relief valve
Stationary Engineer.pdf Stationary Engineer.pdf Stationary Engineer.pdf
, Stationary Engineer.pdf Stationary Engineer.pdf Stationary Engineer.pdf
What does a Black Liquor Boiler do? Black Liquor is the by product of wood pulp processing in the paper making
industry.
What does Black liquor boiler known for? Steam generation and recovery of soda ash
Maximum line voltage for control on a boiler? 150 volts
Under what code are boilers designed and ASME- CSD 1
constructed?
How many low water cut offs are needed per code for a 1 LWCO is needed.
hot water system when a boiler has inputs greater than
400,000 btu per hr
What is the minimum and maximum size for a safety Minimum 3/4" and Maximum 4 1/2"
valve per code for boilers?
What stamp is put on a boiler after repairs? "R"
What is the equalizing system used for? The equalizing system is for warming up the steam lead.
Stationary Engineer.pdf Stationary Engineer.pdf Stationary Engineer.pdf