Manual Transmission/Transaxle Principles Final Exam Test Questions And Answers | Updated 2026/2027|

Manual Transmission/Transaxle Principles Final Exam Test Questions And Answers | Updated 2026/2027| Technician A says a manual transmission must always be lubricated with the exact gear oil or fluid specified by the manufacturer. Technician B says other fluids or gear oils may be used once the vehicle is out of warranty. Who is correct? - ANSWER -Technician A Technician A says a limited slip differential can redirect power from a drive wheel that is slipping to the wheel that has traction. Technician B says traction control can redirect power by applying the brake on a drive wheel that is slipping. Who is correct? - ANSWER -Both Tech A and B If a drive gear has 20 teeth and its driven gear has 40 teeth, what is the mechanical advantage of the gear set? - ANSWER -2:1 Referring to transfer cases, all of the following statements are true, EXCEPT: - ANSWER -power is always directed to both front and rear axles Technician A says manual transmissions use bushings instead of bearings. Technician B says two gears in mesh will try to push each other apart when the vehicle is accelerating. Who is correct? - ANSWER -Tech B Technician A says a transmission countershaft gear is in constant mesh with the input gear. Technician B says the countershaft contains gears that mesh with gears on the output shaft. Who is correct? - ANSWER - A vehicle with a manual transaxle can be cranked and started without depressing the clutch pedal. Technician A says the clutch is not releasing when the pedal is depressed. Technician B says the most likely cause is a defective clutch safety switch. Who is correct? - ANSWER -Technician B The purpose of the clutch safety switch is to: - ANSWER -allow the engine to be cranked only when the clutch pedal is depressed The purpose of the final drive assembly is to: - ANSWER -increase torque from the transmission The clutch is designed to: - ANSWER -connect and disconnect the transmission from the engine When tracing the power flow from the engine to the drive wheels, what transmits power directly to the transmission input shaft? - ANSWER -flywheel Which of the following is the first driveline component to receive power from the engine in a manual transmission vehicle? - ANSWER - Every component in a manual transmission drivetrain requires lubrication according to the manufacturer's specifications: - ANSWER - Technician A says gear ratios can be found by comparing the number of teeth on the drive gear to those on the driven gear. Technician B says the highest a gear ratio can be is 1:1. Who is correct? - ANSWER -Tech A In a manual transmission, bearings do all of the following, EXCEPT: - ANSWER -a. reduce synchronizer temperature. Correct The final drive unit is used to provide gear reduction and also to: - ANSWER change the direction of the power delivered to the drive wheels. All of the following are used by auto manufacturers when selecting the final drive gear ratio, EXCEPT: - ANSWER -the suspensions standing height The driven gear in a final drive assembly is the: - ANSWER -