NCCER Module 9 Introduction
to Materials Handling | Latest
Update | 2025/2026 | Already
Passed
What is the proper procedure to lift objects? - ANSWER-Lift with your legs, keep
your back straight, and keep your head up.
In order to work with motorized materials-handling equipment, you must be? -
ANSWER-trained, certified, and authorized
Before attempting to lift any material, you should look for any? - ANSWER-
protruding nails, wires, or sharp edges
Before attempting to lower and overhead load,________. - ANSWER-Consider the
size of the load.
When stacking bags of material that are the same width, step back and cross key
the bags________. - ANSWER-At least every 10 bags high
, When moving a material cart on an inclined or declined surface, you must be sure
the load does not exceed the labeled __________capacity. - ANSWER-weight
Never stack or store materials_______. - ANSWER-On scaffolds
When using hand signals, you must always keep __________contact with the
operator. - ANSWER-eye
The knot shown in the figure above is a ___________. - ANSWER-Clove hitch
One common way to tie a clove hitch is to use two___________. - ANSWER-Half
hitches
How is the fall zone for a fork lift operation best defined? - ANSWER-This area
includes the area directly beneath a load, as well as any portion of the area that
suspended materials could possibly fall into.
What device may have a rotating table surface and/or spikes on the table surface
for a better grip? - ANSWER-Roller skids
To transport a bottle of compressed gas, use a________. - ANSWER-Cylinder cart
To prevent a tip over when driving a rough terrain forklift, keep the load________.
- ANSWER-Low
to Materials Handling | Latest
Update | 2025/2026 | Already
Passed
What is the proper procedure to lift objects? - ANSWER-Lift with your legs, keep
your back straight, and keep your head up.
In order to work with motorized materials-handling equipment, you must be? -
ANSWER-trained, certified, and authorized
Before attempting to lift any material, you should look for any? - ANSWER-
protruding nails, wires, or sharp edges
Before attempting to lower and overhead load,________. - ANSWER-Consider the
size of the load.
When stacking bags of material that are the same width, step back and cross key
the bags________. - ANSWER-At least every 10 bags high
, When moving a material cart on an inclined or declined surface, you must be sure
the load does not exceed the labeled __________capacity. - ANSWER-weight
Never stack or store materials_______. - ANSWER-On scaffolds
When using hand signals, you must always keep __________contact with the
operator. - ANSWER-eye
The knot shown in the figure above is a ___________. - ANSWER-Clove hitch
One common way to tie a clove hitch is to use two___________. - ANSWER-Half
hitches
How is the fall zone for a fork lift operation best defined? - ANSWER-This area
includes the area directly beneath a load, as well as any portion of the area that
suspended materials could possibly fall into.
What device may have a rotating table surface and/or spikes on the table surface
for a better grip? - ANSWER-Roller skids
To transport a bottle of compressed gas, use a________. - ANSWER-Cylinder cart
To prevent a tip over when driving a rough terrain forklift, keep the load________.
- ANSWER-Low
