AUTO 1 FINAL EXAM STUDY GUIDE QUESTIONS AND
ANSWERS 100% CORRECT!!
, Each of the following is a basic part of the starting system except - ANSWER Inverter
To prevent an engine from cranking while the vehicle is in gear a
_____________________________ is commonly used - ANSWER neutral safety
switch
A starting motor typically draws over ____________ amps, more than any other
automotive electrical component - ANSWER 200
To be usable in an automotive electrical system, the AC output of the alternator must be
__________ into DC - ANSWER Rectified
To properly charge the vehicle battery, alternator output is typically
_____________________ volts - ANSWER 13-15
The most frequent cause of alternator failure is ___________ - ANSWER Diode
Which of the following is not a true statement regarding a hydraulic system - ANSWER
Air in a confined area will not compress.
List some desirable characteristics of brake fluid - ANSWER High boiling point, low
freezing point, hygroscopic, non corrosive, maintain viscosity
Blowing dust off a brake assembly shouldn't be done because the dust may contain
cancer-causing _____________ - ANSWER Asbestos
Brake system parts should be cleaned only with __________ - ANSWER Brake cleaner
The rule of thumb for determining brake bad replacement thickness is:
__________________ - ANSWER 20% = 1 nickle
Which type of tire has the most stable footprint? - ANSWER Radial
In a tire size designation, what do the last two digits represent - ANSWER Rim size
The relationship of tire height to it's width is called its - ANSWER Aspect ratio
What is an example of road damage to a tire? - ANSWER Puncture
Converting chemical energy to electrical energy - ANSWER Discharging
ANSWERS 100% CORRECT!!
, Each of the following is a basic part of the starting system except - ANSWER Inverter
To prevent an engine from cranking while the vehicle is in gear a
_____________________________ is commonly used - ANSWER neutral safety
switch
A starting motor typically draws over ____________ amps, more than any other
automotive electrical component - ANSWER 200
To be usable in an automotive electrical system, the AC output of the alternator must be
__________ into DC - ANSWER Rectified
To properly charge the vehicle battery, alternator output is typically
_____________________ volts - ANSWER 13-15
The most frequent cause of alternator failure is ___________ - ANSWER Diode
Which of the following is not a true statement regarding a hydraulic system - ANSWER
Air in a confined area will not compress.
List some desirable characteristics of brake fluid - ANSWER High boiling point, low
freezing point, hygroscopic, non corrosive, maintain viscosity
Blowing dust off a brake assembly shouldn't be done because the dust may contain
cancer-causing _____________ - ANSWER Asbestos
Brake system parts should be cleaned only with __________ - ANSWER Brake cleaner
The rule of thumb for determining brake bad replacement thickness is:
__________________ - ANSWER 20% = 1 nickle
Which type of tire has the most stable footprint? - ANSWER Radial
In a tire size designation, what do the last two digits represent - ANSWER Rim size
The relationship of tire height to it's width is called its - ANSWER Aspect ratio
What is an example of road damage to a tire? - ANSWER Puncture
Converting chemical energy to electrical energy - ANSWER Discharging
