GMETRIX PRACTICE EXAM 2
A designer would like to crank the shaft to rotate about the x axis
within the crank case. Which joint type would be best for achieving
this motion? - ANSWERS-Revolute
Which option removes all degrees of freedom from a component that
is first placed into an assembly? - ANSWERS-ground
which assembly option allows the changing of the starting position of
the horizontal bar from being aligned with the x axis to being aligned
with the y axis as shown? - ANSWERS-Drive joints
A designer runs an interference analysis on an assembly. Based upon
the interference results, which component was made incorrectly and
needs revision? - ANSWERS-roller
which methods will result in adding another sheet to the drawing file?
- ANSWERS-Select the large plus in the drawing navigation bar and
right click
The top view was created using which drawing view command? -
ANSWERS-Projected view
Which dimension tool allows creating dimension as shown? -
ANSWERS-Angular Dimension
, For each statement about center marks and centerlines select yes and
no - ANSWERS-Centerlines indicate symmetry, center marks are only
placed on (YES)
Center marks can only be placed on circles, Centerlines require two
selections for creation (NO)
You are creating a few new designs that need to be created in metric
units specified as mm. Currently the unit type is set to inches for the
design file. Which setting allows for changing of units and setting a
specific unit type as default? - ANSWERS-Preferences and Document
Settings
For each statement about bodies and components select yes and no -
ANSWERS-A component cant be created after a body has modeled,
Bodies can contain sketches, etc ( NO)
Joints can be applied to components, When components are created
from a body (YES)
What Fusion 360 project is the Quick slider assembly stored in? -
ANSWERS-Quick slider
Which view option allows a user to set a new front view that is
different from the original front view modeled for the design? -
ANSWERS-Set Current View as Front
Once a design is modeled, a designer needs to create engineering
drawings of a proposed design so it can be manufactured. Which
A designer would like to crank the shaft to rotate about the x axis
within the crank case. Which joint type would be best for achieving
this motion? - ANSWERS-Revolute
Which option removes all degrees of freedom from a component that
is first placed into an assembly? - ANSWERS-ground
which assembly option allows the changing of the starting position of
the horizontal bar from being aligned with the x axis to being aligned
with the y axis as shown? - ANSWERS-Drive joints
A designer runs an interference analysis on an assembly. Based upon
the interference results, which component was made incorrectly and
needs revision? - ANSWERS-roller
which methods will result in adding another sheet to the drawing file?
- ANSWERS-Select the large plus in the drawing navigation bar and
right click
The top view was created using which drawing view command? -
ANSWERS-Projected view
Which dimension tool allows creating dimension as shown? -
ANSWERS-Angular Dimension
, For each statement about center marks and centerlines select yes and
no - ANSWERS-Centerlines indicate symmetry, center marks are only
placed on (YES)
Center marks can only be placed on circles, Centerlines require two
selections for creation (NO)
You are creating a few new designs that need to be created in metric
units specified as mm. Currently the unit type is set to inches for the
design file. Which setting allows for changing of units and setting a
specific unit type as default? - ANSWERS-Preferences and Document
Settings
For each statement about bodies and components select yes and no -
ANSWERS-A component cant be created after a body has modeled,
Bodies can contain sketches, etc ( NO)
Joints can be applied to components, When components are created
from a body (YES)
What Fusion 360 project is the Quick slider assembly stored in? -
ANSWERS-Quick slider
Which view option allows a user to set a new front view that is
different from the original front view modeled for the design? -
ANSWERS-Set Current View as Front
Once a design is modeled, a designer needs to create engineering
drawings of a proposed design so it can be manufactured. Which
