NETA LEVEL II EXAM QUESTIONS AND
ANSWERS 2026 ACTUAL PAPER
COMPLETE QUESTIONS AND ANSWERS
GRADED A+
⩥ Which of the following would best describe the relation between
voltage and current for an ac circuit containing resistance and capacitive
reactance? Answer: The current leads the voltage
⩥ Once placed into service, how often must rubber gloves must be
cleaned, inspected and electrically tested? Answer: Every 6 months
⩥ In a three-phase connection, the current that flows in an externally
connected voltage conductor is the _____ current. Answer: Line
⩥ Upon the outbreak of a fire, your first action should be to: Answer:
Alert or alarm
⩥ A given 120VAC 60Hz circuit has a load of 10A with a 20° lagging
power factor for 30 minutes. What is the apparent power? Answer:
1200.00VA, S=IE
⩥ Insulation resistance must be corrected for? Answer: Temperature
, ⩥ What is the Restricted Approach Boundary for a 480V system?
Answer: 12 inches
⩥ OSHA requires the testing of a volt meter after a voltage test on
voltage above ______. Answer: 600V
⩥ The arcing contacts on a circuit breaker are used to: Answer: Prevent
damage to the main contacts
⩥ Which type of electromechanical relay is commonly used for time
delay functions? Answer: Shaded Pole
⩥ A wye-delta transformer has a primary line voltage of 7200 V and a
secondary voltage of 360 V. What is the turns ratio? Answer: 11.55:1,
Vp/sqrt(3)/Vs
⩥ For which reason does a Kelvin Bridge have 4 leads? Answer: To
eliminate extra impedance
⩥ ower transformer cooling classes went through major changes in the
United States when IEEE Standard C57.12.00-2000 adopted the modern
four-letter designation. Which of the following old designations does not
match the new? Answer: OA/FOA=ONAN/ONAF
ANSWERS 2026 ACTUAL PAPER
COMPLETE QUESTIONS AND ANSWERS
GRADED A+
⩥ Which of the following would best describe the relation between
voltage and current for an ac circuit containing resistance and capacitive
reactance? Answer: The current leads the voltage
⩥ Once placed into service, how often must rubber gloves must be
cleaned, inspected and electrically tested? Answer: Every 6 months
⩥ In a three-phase connection, the current that flows in an externally
connected voltage conductor is the _____ current. Answer: Line
⩥ Upon the outbreak of a fire, your first action should be to: Answer:
Alert or alarm
⩥ A given 120VAC 60Hz circuit has a load of 10A with a 20° lagging
power factor for 30 minutes. What is the apparent power? Answer:
1200.00VA, S=IE
⩥ Insulation resistance must be corrected for? Answer: Temperature
, ⩥ What is the Restricted Approach Boundary for a 480V system?
Answer: 12 inches
⩥ OSHA requires the testing of a volt meter after a voltage test on
voltage above ______. Answer: 600V
⩥ The arcing contacts on a circuit breaker are used to: Answer: Prevent
damage to the main contacts
⩥ Which type of electromechanical relay is commonly used for time
delay functions? Answer: Shaded Pole
⩥ A wye-delta transformer has a primary line voltage of 7200 V and a
secondary voltage of 360 V. What is the turns ratio? Answer: 11.55:1,
Vp/sqrt(3)/Vs
⩥ For which reason does a Kelvin Bridge have 4 leads? Answer: To
eliminate extra impedance
⩥ ower transformer cooling classes went through major changes in the
United States when IEEE Standard C57.12.00-2000 adopted the modern
four-letter designation. Which of the following old designations does not
match the new? Answer: OA/FOA=ONAN/ONAF
