NCCER Electrical 1 Module 10 questions
and answers 2026\2027 A+ Grade
Blue Prints
- correct answer An exact copy of reproduction of an original drawing
Floor plan
- correct answer As viewed from above
Site plan
- correct answer Location of building on the property
Surveys show
- correct answer All property lines, existing public utilities and their location on or near the property
Elevation drawings show
- correct answer The exterior face of the building
Floor plans are in
- correct answer 2 dimension, length and width
Topographic survey shows
- correct answer Property lines, contour lines, notes and symbols
Sectional view
- correct answer Is a cutaway view that shows the inside of the building
, Title block
- correct answer A table located in the bottom right-hand corner of an engineering drawing that
identifies, in an organized way, all of the necessary information that is not given on the drawing itself.
Also referred to as a title strip.
Revision Block
- correct answer Shows modifications or redrawn drawings
Architectural scale
- correct answer 1/16" = 1', 1/8" = 1' 1/4" = 1
Engineer scale measurements
- correct answer 1"=10 units through 1"=100 units
Metric scale 1:1 to 1:100
- correct answer Millimeters are used
Metric scale 1:200 to 1:2000
- correct answer Meter is used
CAD
- correct answer Computer aided design
Masterformat
- correct answer Most common used writing format
Division 26 is
- correct answer Electrical
Division 27 is
- correct answer Communications
and answers 2026\2027 A+ Grade
Blue Prints
- correct answer An exact copy of reproduction of an original drawing
Floor plan
- correct answer As viewed from above
Site plan
- correct answer Location of building on the property
Surveys show
- correct answer All property lines, existing public utilities and their location on or near the property
Elevation drawings show
- correct answer The exterior face of the building
Floor plans are in
- correct answer 2 dimension, length and width
Topographic survey shows
- correct answer Property lines, contour lines, notes and symbols
Sectional view
- correct answer Is a cutaway view that shows the inside of the building
, Title block
- correct answer A table located in the bottom right-hand corner of an engineering drawing that
identifies, in an organized way, all of the necessary information that is not given on the drawing itself.
Also referred to as a title strip.
Revision Block
- correct answer Shows modifications or redrawn drawings
Architectural scale
- correct answer 1/16" = 1', 1/8" = 1' 1/4" = 1
Engineer scale measurements
- correct answer 1"=10 units through 1"=100 units
Metric scale 1:1 to 1:100
- correct answer Millimeters are used
Metric scale 1:200 to 1:2000
- correct answer Meter is used
CAD
- correct answer Computer aided design
Masterformat
- correct answer Most common used writing format
Division 26 is
- correct answer Electrical
Division 27 is
- correct answer Communications
