Updated 2026/2027
Methods & Application Reviews
All 550 Questions with Correct
Certified Answers with Rationales
Guaranteed Pass Already Graded A+
1. Spray drift may be defined as? - ANSWER✔️✔️-Particles that move out of
the target area and deposit on adjoining properties, a complex movement of
pesticide chemicals out of the target area and the movement of spray
particles or droplets, granules or dust particles away from the target site
before the deposit.
2. Information that should be collected prior to an application would include: -
ANSWER✔️✔️-Crops to be treated, pest(s) to be controlled and the
application rate
3. After the pesticide has been selected, the mixer/loader should check the
_____ to understand all of the requirements and warnings. -
ANSWER✔️✔️-Label
4. Pesticide labels change periodically? - ANSWER✔️✔️-True
5. After selecting the product, the mixer/loader must understand all of the
requirements and warnings on the label, they should mark the label
information that is important for the job, and he should file the marked label
for future reference. Which of the following is not true? - ANSWER✔️✔️-
Once a label is marked and filed it can be followed indefinitely as long as
you are using the same activation ingredient with the same formulation.
6. When comparing a new label to a previously marked and filed label the two
should contain the same data, to which of the following should you pay
close attention? - ANSWER✔️✔️-Registration numbers and other
identification data, application rate and drop size spectrum, and wind
limitations, susceptible crops, and state and federal regulations.
,7. The pilot must be briefed or should analyze all risks and hazards of the
product being applied and these may include _____? - ANSWER✔️✔️-
Areas susceptible to damage downwind such as crops, orchards, and garden.
Neighbors and businesses. Physical obstructions, bees, water, and wildlife
habitat.
8. Two excellent ways to manage spray drift are ____? - ANSWER✔️✔️-To
control the spray droplet size and to spray when the air is calm.
9. A droplet having the diameter of 50-100 micrometers is similar to: -
ANSWER✔️✔️-Mist
10.A droplet having a diameter of 500 micrometers is similar to: -
ANSWER✔️✔️-Light rain, medium agricultural sprays
11.Pesticide particles X and Y have diameters of 150 micrometers and 300
micrometers respectively. The volume of particle Y is: - ANSWER✔️✔️-
Eight times greater than particle X
12.The spray particles emitted by a nozzle are: - ANSWER✔️✔️-Of various
sizes - a spectrum of droplet sizes
13.If 300 micrometers is the volume medium diameter of a spray, then any
volume of said spray will consist of the following distribution of particle
size. - ANSWER✔️✔️-½ greater than 300 micrometers, ½ less than 300
micrometers
14.Major factors in controlling drift that an aerial applicator must consider are?
- ANSWER✔️✔️-Weather, equipment, and product characteristics
15.What is a water soluble polymer, also called a DCA (Drift Control Agent) -
ANSWER✔️✔️-Hydroxy-ethyl cellulose
16.What specific characteristics of pesticide formulations and carriers are
known to affect the droplet size spectrum? - ANSWER✔️✔️-Viscosity,
Surface tension, Vapor pressure, and density
,17.When emitted from a spray nozzle operating at a pressure that will produce
spray, high viscosity spray mixes - as compared to lower viscosity spray
mixes - are expected to produce sprays with? - ANSWER✔️✔️-An
increased volume of droplets in the larger size range & a decreased volume
of droplets in the smaller size range.
18.In comparing the flow rate (gallon/min) of several liquids of differing
viscosities, one would find the liquid with highest viscosity to have: -
ANSWER✔️✔️-The lowest flow rate
19.When comparing several liquids with differing viscosities at a constant flow
rate (gallon/min) through the same nozzle would fine the liquid with high
viscosity to have? - ANSWER✔️✔️-The highest droplet VMD
20.When all temperatures are held constant, the viscosity of diesel fuel and
vegetable oils are? - ANSWER✔️✔️-Greater than that of water
21.Two spray mixes are prepared having viscosities of "A" and "B" where "B"
is greater than "A", and applied with the same equipment under similar
condition. The spray mix with viscosity "B" is expected to produce a
spectrum of particle sizes. - ANSWER✔️✔️-Contains a higher percentage
of large particles that spray mix "A"
22.When adding hydroxyethyl cellulose (an adjuvant) to a spray mix, you may
produce a wider spectrum of droplet sizes with more large drops and fewer
small drops. - ANSWER✔️✔️-True
23.When adding polyvinyl polymer (an adjuvant) to a spray mix, you may
produce a wider spectrum of droplet sizes with more large drops than fewer
drops. - ANSWER✔️✔️-True
24.The primary reason or reasons for adding adjuvants commonly referred to as
a "drift control agents" to mixtures of pesticides and diluents are: -
ANSWER✔️✔️-Reduce the quantity of "off target" and increase the
quantity of "on target" pesticide deposition
25.Which of the following might be caused by adding adjuvant to the
pesticide/carrier mixture? - ANSWER✔️✔️-The surface tension on water
, drops may be reduced, there may be a change in the resistance to flow of the
spray mixture, and calibration should be rechecked.
26.Some adjuvants added to a spray mixture may actually produce more small
drops since a small amount of the adjuvants can reduce surface tension and
therefore reduce droplet size. - ANSWER✔️✔️-True
27.The addition of a small amount of the surfactant or a wetting agent to a spray
mix may result in the following change in surface tension of the spray mix. -
ANSWER✔️✔️-Surface tension will decrease
28.At a constant temperature, diesel fuel and vegetable oil have surface tensions
that are. - ANSWER✔️✔️-Greater than that of water
29.The surface tension of liquids ____? - ANSWER✔️✔️-Decreases with
increases in temperatures
30.Surface tension for water is _____ xylene, diesel fuel and cottonseed oil. -
ANSWER✔️✔️-Greater than
31._____ is a measure of the capacity of a substance to evaporate -
ANSWER✔️✔️-Vapor Pressure
32.What change in the pressure of liquids might be expected when the
temperature changes? - ANSWER✔️✔️-A: Vapor pressure increases as the
temperature increases
33.2,4-D herbicide formulations are commonly referred to as "high volatile",
"low volatile" and "nonvolatile". Non-volatile formulations may vaporize on
very hot days. - ANSWER✔️✔️-True
34.The density of water is _____ than that of diesel fuel and cottonseed oil. -
ANSWER✔️✔️-Less
35.Droplets having the same size but of a less dense liquid will fall _____ than
a more dense liquid. - ANSWER✔️✔️-Slower