Gross capacity is 10,300 Ibs total deductions are 7,622 lbs. What is the net capacity?
Give this one a try later!
2,678 lbs.
When lifting personnel what type of hook latch must be used?
Give this one a try later!
One that can be closed and locked
What is the best source of information for determining boom tip height?
,Give this one a try later!
Working range diagram
ANSI/ASME B 30.5 requires a signal to observe power lines clearances and to be in
constant communication with the operator when the crane is within:
Give this one a try later!
A boom's length of the limit of approach
When personnel are engaged in hooking, when unhooking or guiding a load in the
fall zone they must:
Give this one a try later!
Wear steel toe boots
A crane must be level within _______% for the load chart ratings to be valid?
Give this one a try later!
1%
Excessive side loading can occur when:
,Give this one a try later!
Dragging a load
When leaving telescopic boom cranes unattended overnight or for longer periods,
the boom should
Give this one a try later!
Be fully retracted and stowed
What is the primary purpose for installing a fixed jib on a crane?
Give this one a try later!
To increase the total height
It is important to know when lubricating wire rope that the lubricant must:
Give this one a try later!
Not hinder visual inspection
What is the purpose of a work area diagram (chart)?
Give this one a try later!
, To identify operational quadrants
When inspecting the boom on a telescopic boom crane which item should be
inspected?
Give this one a try later!
Wear pads
According to ASME B30.5, if the power to the crane fails during operation, what is the
FIRST action that should be taken?
Give this one a try later!
Set all brakes and locking devices
OSHA 1926 Subpart CC, requires hoist drum rotation indicator to be installed on
cranes manufactured after November 8,2011
Give this one a try later!
When the hoist drum is not visible to the operator
Crawler cranes produce the least amount of ground pressure is over the:
Give this one a try later!
2,678 lbs.
When lifting personnel what type of hook latch must be used?
Give this one a try later!
One that can be closed and locked
What is the best source of information for determining boom tip height?
,Give this one a try later!
Working range diagram
ANSI/ASME B 30.5 requires a signal to observe power lines clearances and to be in
constant communication with the operator when the crane is within:
Give this one a try later!
A boom's length of the limit of approach
When personnel are engaged in hooking, when unhooking or guiding a load in the
fall zone they must:
Give this one a try later!
Wear steel toe boots
A crane must be level within _______% for the load chart ratings to be valid?
Give this one a try later!
1%
Excessive side loading can occur when:
,Give this one a try later!
Dragging a load
When leaving telescopic boom cranes unattended overnight or for longer periods,
the boom should
Give this one a try later!
Be fully retracted and stowed
What is the primary purpose for installing a fixed jib on a crane?
Give this one a try later!
To increase the total height
It is important to know when lubricating wire rope that the lubricant must:
Give this one a try later!
Not hinder visual inspection
What is the purpose of a work area diagram (chart)?
Give this one a try later!
, To identify operational quadrants
When inspecting the boom on a telescopic boom crane which item should be
inspected?
Give this one a try later!
Wear pads
According to ASME B30.5, if the power to the crane fails during operation, what is the
FIRST action that should be taken?
Give this one a try later!
Set all brakes and locking devices
OSHA 1926 Subpart CC, requires hoist drum rotation indicator to be installed on
cranes manufactured after November 8,2011
Give this one a try later!
When the hoist drum is not visible to the operator
Crawler cranes produce the least amount of ground pressure is over the:
