Definition Net Load
Give this one a try later!
Gross load minus capacity deductions
Definition of gross capacity
Give this one a try later!
maximum weight a crane can lift (including all capacity deductions) given
by the manufacturer for each configuration (number on the load chart)
Capacity lost at 2 degrees
,Give this one a try later!
41%
Rated capacity of Angle of choke over 120
Give this one a try later!
100
Inspecting throat opening
Give this one a try later!
5% not to exceed 1/4 inch
What to do with materials under energized power lines
Give this one a try later!
Never be lifted by crane
TA up to 50V
Give this one a try later!
, 10ft TA
What is the Load Angle Factor if Horizontal Sling Angle Factor is 90 degrees
Give this one a try later!
1.000
TA 200-350V
Give this one a try later!
20ft TA
Option 3 when securing barge to crane
Give this one a try later!
Rails
On crawler or truck cranes, where should assembly or disassembly be done
Give this one a try later!
, Over the quadrant of maximum stability
What happens to line pull strength when there are more layers on the drum
Give this one a try later!
Line pull strength decreases
Definition Boom length lattice measurement
Give this one a try later!
Center of the boom FOOT pin to the center of the HEAD SHEAVE pin
Pads must be_________to cylinder
Give this one a try later!
90 degree angle
IWRC design factor
Give this one a try later!
Give this one a try later!
Gross load minus capacity deductions
Definition of gross capacity
Give this one a try later!
maximum weight a crane can lift (including all capacity deductions) given
by the manufacturer for each configuration (number on the load chart)
Capacity lost at 2 degrees
,Give this one a try later!
41%
Rated capacity of Angle of choke over 120
Give this one a try later!
100
Inspecting throat opening
Give this one a try later!
5% not to exceed 1/4 inch
What to do with materials under energized power lines
Give this one a try later!
Never be lifted by crane
TA up to 50V
Give this one a try later!
, 10ft TA
What is the Load Angle Factor if Horizontal Sling Angle Factor is 90 degrees
Give this one a try later!
1.000
TA 200-350V
Give this one a try later!
20ft TA
Option 3 when securing barge to crane
Give this one a try later!
Rails
On crawler or truck cranes, where should assembly or disassembly be done
Give this one a try later!
, Over the quadrant of maximum stability
What happens to line pull strength when there are more layers on the drum
Give this one a try later!
Line pull strength decreases
Definition Boom length lattice measurement
Give this one a try later!
Center of the boom FOOT pin to the center of the HEAD SHEAVE pin
Pads must be_________to cylinder
Give this one a try later!
90 degree angle
IWRC design factor
Give this one a try later!
