California Motorcycle Safety Program
Test 2 2026
Give three reasons why motorcycling is more risky than driving a car? - -
1- motorcycles are more vulnerable than cars
2-they are harder to see than cars
3-you are exposed to the elements
What is rider readiness - -Being mentally focused, physically fit, wear proper riding gear,
know your limitations, awareness of conditions, and knowing your motorcycle
What does it mean that to "accept your responsibility"? - -Ride within your limits and the
bike's to reduce the risk of motorcycling and set an example.
What is the benefit of wearing apparel specifically designed for motorcycling? - -
How does riding gear make a rider more comfortable? - -With some jackets you are
able to adjust the amount of wind you want and you can button down straps to avoid
them flapping in the wind.
What is the difference between retro-reflective and reflective? - -Reflective reflects the
light in any which way,retro-reflective directs the light back to the source.
Why aren't ordinary sunglasses or sunglasses sufficient eye protection? - -Might shatter
upon impact
What three things should you consider when shopping for riding gear? - -
Where do you find the recommended maintenance schedule for your motorcycle? - -In
the motorcycle operation manual ( MOM).
What are the five primary controls and where is each located? - -Throttle, clutch lever,
gearshift lever, front brake lever, rear brake pedal
What is the purpose of the engine cut off switch and where is it located? - -To avoid
taking your hands off the bar in a situation where control is critical and you need to turn
off the engine. Located on the right side of the handlebars.
What must you remember when your motorcycle turn signal? - -To turn it off after you
have completed the movement.
What is the significance of ONE-C? - -O- turn the petcock and ignition ON
N- make sure the bike is in NEUTRAL
Motorcycle
, Motorcycle
E- move the ENGINE cut off switch to ON
C- cover the CLUTCH and if the engine is cold turn the CHOKE to the on position.
What is SPAT? - -S-decrease SPEED
P- set your body into POSITION
A- look and AIM where you are going
T- complete the movement and TURN
What is ONE-C used for? - -Pre start checklist to start the engine
What is SPAT used for? - -Turning maneuvers
What is counter-steering? Why is it important? - -A way of steering, it is a more reliable
way of steering at speed.
When should you lean with your bike? - -Higher speed turns
When should you counter the lean of your bike? - -Lower speed turns
What is the friction zone? What is it used for? - -The point where the clutch starts to
grab
Describe good riding posture - -Straightened back, eyes up, feet on foot rests, knees
against the tank, relax your arms and bend your elbows a little.
How can you improve your visibility to other traffic? - -Have bright clothes, ride with your
headlight on, use your turn signals, flash your brake light before you stop completely,
and use your horn.
What is the 20 second visual lead? - -
What is the recommended minutes mum following distance? - -
What should you consider when choosing a lane position - -
What is SMOG-C? What is it used for? - -
What is SIPDE? - -
What is a head check? - -Looking back to check your blind spots
Where do most multi vehicle crashes occur - -In an intersection
What can you do to reduce reaction time in hazardous situations? - -
How do you know if you are overriding your headlight? - -
Motorcycle