RHODE ISLAND JOURNEYMAN/MASTER PLUMBER FINAL
STUDY GUIDE QUESTIONS AND CORRECT DETAILED
ANSWERS WITH RATIONALES (VERIFIED ANSWERS)
|ALREADY GRADED A+
Terms in this set (152) QUESTIONS VERIFIED ANSWERS
1. Plumbing Code Regulation SBC-3 State of Rhode Island Plumbing
Code is known as:
2. 4' 6" Below Grade Water Services Shall Be Installed
Not Less Than:
3. Insulated/Heated or Both Piping installed in exterior walls or
areas subject to freezing must:
4. 36" Below Grade Building Sewers connected to a
public sewer shall have a minimum
coverage of:
5. Under a water heater 6 gallons or greater A safe waste pan shall be installed
that is elevated
6. 2" deep with 2" clearance around heater A safe waste pan shall be at least
7. 10' undisturbed compacted earth Water service piping and building
drain/sewer shall be separated by:
8. Water line is installed minimum 12" above Water service separation distance is
, sewer line at highest point not required if:
9. 50' Distance for a septic tank/sewer to a
private water supply(well) is:
10. 6"below the roof with an approved fitting Where frost closure is common an
increase in vent size shall take place:
11. "V" zone (subject to wave heights in High Hazard flood zone is:
excess of 3')
12. 8.0% Lead Lead free pipe and fittings contain
less than:
13. 110 degrees Hot water is water at temperature
greater than or equal to:
14. 0.2% Lead Lead free solder and flux contain no
more than
15. 0.5 inches Strainer plates on drain lines for
rodent proofing must have openings:
16. Two pipe size greater than the pipe Sleeves for pipes passing through
passing through it foundation walls or under footings
shall be:
17. 500' Travel distance to toilet facilities in
merchantile/occupancies are:
18. 300' Travel distance to toilet facilities in
covered malls are:
19. 15" Water closets, bidets or lavatories
, shall have a clearance from center of
fixture to wall of:
20. 21" The required clearance from front of
fixture to a wall, door or other
fixture is:
21. 3" Minimum size floor drains for public
laundries or central washing
facilities is:
22. 1 1/2" Shower waste outlets shall be
minimum of:
23. 3" Minimum size removable strainer
for shower compartments are:
24. .25 inches Minimum size floor drain strainer
opening is:
25. 4 pounds per square foot Sheet lead shall not weigh less than:
26. 12 ounces per square foot Sheet copper shall not weigh less
than:
27. 67% Urinals shall not be substituted for
more than what percent of water
closets?
28. 120 degrees Shower and Tub/Shower valves
maximum hot water setting is:
29. 140 degrees Maximum water temperature of a
STUDY GUIDE QUESTIONS AND CORRECT DETAILED
ANSWERS WITH RATIONALES (VERIFIED ANSWERS)
|ALREADY GRADED A+
Terms in this set (152) QUESTIONS VERIFIED ANSWERS
1. Plumbing Code Regulation SBC-3 State of Rhode Island Plumbing
Code is known as:
2. 4' 6" Below Grade Water Services Shall Be Installed
Not Less Than:
3. Insulated/Heated or Both Piping installed in exterior walls or
areas subject to freezing must:
4. 36" Below Grade Building Sewers connected to a
public sewer shall have a minimum
coverage of:
5. Under a water heater 6 gallons or greater A safe waste pan shall be installed
that is elevated
6. 2" deep with 2" clearance around heater A safe waste pan shall be at least
7. 10' undisturbed compacted earth Water service piping and building
drain/sewer shall be separated by:
8. Water line is installed minimum 12" above Water service separation distance is
, sewer line at highest point not required if:
9. 50' Distance for a septic tank/sewer to a
private water supply(well) is:
10. 6"below the roof with an approved fitting Where frost closure is common an
increase in vent size shall take place:
11. "V" zone (subject to wave heights in High Hazard flood zone is:
excess of 3')
12. 8.0% Lead Lead free pipe and fittings contain
less than:
13. 110 degrees Hot water is water at temperature
greater than or equal to:
14. 0.2% Lead Lead free solder and flux contain no
more than
15. 0.5 inches Strainer plates on drain lines for
rodent proofing must have openings:
16. Two pipe size greater than the pipe Sleeves for pipes passing through
passing through it foundation walls or under footings
shall be:
17. 500' Travel distance to toilet facilities in
merchantile/occupancies are:
18. 300' Travel distance to toilet facilities in
covered malls are:
19. 15" Water closets, bidets or lavatories
, shall have a clearance from center of
fixture to wall of:
20. 21" The required clearance from front of
fixture to a wall, door or other
fixture is:
21. 3" Minimum size floor drains for public
laundries or central washing
facilities is:
22. 1 1/2" Shower waste outlets shall be
minimum of:
23. 3" Minimum size removable strainer
for shower compartments are:
24. .25 inches Minimum size floor drain strainer
opening is:
25. 4 pounds per square foot Sheet lead shall not weigh less than:
26. 12 ounces per square foot Sheet copper shall not weigh less
than:
27. 67% Urinals shall not be substituted for
more than what percent of water
closets?
28. 120 degrees Shower and Tub/Shower valves
maximum hot water setting is:
29. 140 degrees Maximum water temperature of a
