DANTE CERTIFICATION LEVEL 2 2ND EDITION
CERTIFICATION TEST PAPER 2026 QUESTIONS
WITH ANSWERS GUARANTEED TO PASS
◉ Can the Secondary (redundant) port on a Dante device be connected
to the Primary network to increase channel count? Answer: No. This will
cause the network to fail.
◉ How does one setup Dante redundancy? Answer: Connect a second
set of cables and switches to create a network that uses only the
Secondary port of Dante devices
◉ Can the Secondary (redundant) port be configured to daisy chain
devices? Answer: Yes, but only on certain Dante devices. Always check.
◉ When would you select the "Enable Sync to External" box for devices
on the DC Clock Status tab? Answer: When a device is either a)
connected to an external word clock, or b) when using the internal clock
of a device to drive a Dante option card
◉ Dante [ ... ] use unicast as the default mode of transmission. Answer:
does
, ◉ A unicast network connection is: Answer: - Communication that is
only between specific devices on a network
- Default Dante behavior
◉ A multicast network connection is: Answer: - One to many
- Useful for solving "Fan out" conditions
◉ A broadcast network connection is: Answer: - One to everyone
- Not used by Dante for audio
- A common type of network traffic
◉ A unicast Dante Flow can contain up to [ ... ] different Tx channels of
audio from the same device. Answer: 4
◉ How does Dante Controller inform you that multicast is
recommended? Answer: With a "Fan out' warning.
◉ Dante Multicast Flows are manually created on an as needed basis.
Answer: True
◉ Multicast Flows should be used when you... Answer: Wish to connect
a transmitter to multiple receiving devices, typically more than 3
CERTIFICATION TEST PAPER 2026 QUESTIONS
WITH ANSWERS GUARANTEED TO PASS
◉ Can the Secondary (redundant) port on a Dante device be connected
to the Primary network to increase channel count? Answer: No. This will
cause the network to fail.
◉ How does one setup Dante redundancy? Answer: Connect a second
set of cables and switches to create a network that uses only the
Secondary port of Dante devices
◉ Can the Secondary (redundant) port be configured to daisy chain
devices? Answer: Yes, but only on certain Dante devices. Always check.
◉ When would you select the "Enable Sync to External" box for devices
on the DC Clock Status tab? Answer: When a device is either a)
connected to an external word clock, or b) when using the internal clock
of a device to drive a Dante option card
◉ Dante [ ... ] use unicast as the default mode of transmission. Answer:
does
, ◉ A unicast network connection is: Answer: - Communication that is
only between specific devices on a network
- Default Dante behavior
◉ A multicast network connection is: Answer: - One to many
- Useful for solving "Fan out" conditions
◉ A broadcast network connection is: Answer: - One to everyone
- Not used by Dante for audio
- A common type of network traffic
◉ A unicast Dante Flow can contain up to [ ... ] different Tx channels of
audio from the same device. Answer: 4
◉ How does Dante Controller inform you that multicast is
recommended? Answer: With a "Fan out' warning.
◉ Dante Multicast Flows are manually created on an as needed basis.
Answer: True
◉ Multicast Flows should be used when you... Answer: Wish to connect
a transmitter to multiple receiving devices, typically more than 3
