FIRE INSPECTOR 2 LATEST 2026 EVALUATION EXAM
QUESTIONS AND ANSWERS MARKED A+
✔✔Acceptance testing should be witnessed by: - ✔✔Representatives of building
owner/occupant
Fire department
System installer/manufacturer
✔✔All functions of the system must be... - ✔✔Operated
✔✔Power supplies - ✔✔Operate the system on both primary and secondary power
supplies to ensure both will supply the system adequately
✔✔Lead acid and primary batteries should be inspected - ✔✔Monthly
✔✔Nickel cadmium and sealed lead acid batteries should be inspected -
✔✔Semiannually
✔✔All testing should be in accordance with local guidelines, manufacturers specs and
... - ✔✔NFPA 72
✔✔Records should be maintained for at least 5 years and should include - ✔✔1) test
date
2) detector type
3) location
4) type of test
5) test results
✔✔Non restorable fixed temperature detector does not require testing until _____ years
after installation then ___ percent of detectors must be removed - ✔✔15 and 2 %
✔✔Restorable heat detectors - ✔✔Hair dryers or electric heat guns
✔✔Non restorable heat detectors - ✔✔Do not test during field inspection
✔✔Periodic test recommended by - ✔✔NFPA 72
✔✔Restorable heat detection device - ✔✔Test one detector on each signal circuit
semiannually
✔✔Smoke detector - Sensitivity testing should be performed after _____ year of service
and every _____ years following - ✔✔First and 2 years
✔✔Local alarm systems test in accordance with - ✔✔NFPA 72
, ✔✔Emergency voice alarm system - ✔✔Quarterly functional test of various component
and annually for all components
✔✔Based on the five classifications of fire extinguisher - ✔✔A, B, C, D and K
✔✔NFPA 10 - ✔✔Portable fire extinguisher
✔✔5 Important elements in selection and distribution - ✔✔1) potential severity of
resulting fire
2) accessibility of extinguisher
3) personnel available to operate extinguisher
4) environmental conditions
5) anticipated adverse chemical reaction
✔✔Class A maximum travel distance to extinguisher is - ✔✔75 feet
✔✔NFPA 10 recommends class D the travel distance not exceed - ✔✔75 ft
✔✔Class K Tavel distance - ✔✔30 feet
✔✔Gross weight not exceeding 40 lbs - ✔✔Not more than 5 feet
✔✔Gross weight greater than 40 lbs - ✔✔Not more than 3 1/2 feet
✔✔Clearance between bottom of extinguisher and floor should never be less than -
✔✔4 inches
✔✔Extinguisher maintenance - ✔✔Should be performed by trained, certified personnel
✔✔Three common types for elevator design - ✔✔Single, multiple( not separated) and
blind ( only upper floors)
✔✔Injury prevention - ✔✔Equipped with locks to keep them from opening when an
elevator door is not at the landing
✔✔Moving stair designs should - ✔✔Not be used during emergency operations
✔✔Moving stairs design operation - ✔✔1) each step rides track
2) steps are linked together
3) driving machinery is located upper landing
4) handrails move at same speed
QUESTIONS AND ANSWERS MARKED A+
✔✔Acceptance testing should be witnessed by: - ✔✔Representatives of building
owner/occupant
Fire department
System installer/manufacturer
✔✔All functions of the system must be... - ✔✔Operated
✔✔Power supplies - ✔✔Operate the system on both primary and secondary power
supplies to ensure both will supply the system adequately
✔✔Lead acid and primary batteries should be inspected - ✔✔Monthly
✔✔Nickel cadmium and sealed lead acid batteries should be inspected -
✔✔Semiannually
✔✔All testing should be in accordance with local guidelines, manufacturers specs and
... - ✔✔NFPA 72
✔✔Records should be maintained for at least 5 years and should include - ✔✔1) test
date
2) detector type
3) location
4) type of test
5) test results
✔✔Non restorable fixed temperature detector does not require testing until _____ years
after installation then ___ percent of detectors must be removed - ✔✔15 and 2 %
✔✔Restorable heat detectors - ✔✔Hair dryers or electric heat guns
✔✔Non restorable heat detectors - ✔✔Do not test during field inspection
✔✔Periodic test recommended by - ✔✔NFPA 72
✔✔Restorable heat detection device - ✔✔Test one detector on each signal circuit
semiannually
✔✔Smoke detector - Sensitivity testing should be performed after _____ year of service
and every _____ years following - ✔✔First and 2 years
✔✔Local alarm systems test in accordance with - ✔✔NFPA 72
, ✔✔Emergency voice alarm system - ✔✔Quarterly functional test of various component
and annually for all components
✔✔Based on the five classifications of fire extinguisher - ✔✔A, B, C, D and K
✔✔NFPA 10 - ✔✔Portable fire extinguisher
✔✔5 Important elements in selection and distribution - ✔✔1) potential severity of
resulting fire
2) accessibility of extinguisher
3) personnel available to operate extinguisher
4) environmental conditions
5) anticipated adverse chemical reaction
✔✔Class A maximum travel distance to extinguisher is - ✔✔75 feet
✔✔NFPA 10 recommends class D the travel distance not exceed - ✔✔75 ft
✔✔Class K Tavel distance - ✔✔30 feet
✔✔Gross weight not exceeding 40 lbs - ✔✔Not more than 5 feet
✔✔Gross weight greater than 40 lbs - ✔✔Not more than 3 1/2 feet
✔✔Clearance between bottom of extinguisher and floor should never be less than -
✔✔4 inches
✔✔Extinguisher maintenance - ✔✔Should be performed by trained, certified personnel
✔✔Three common types for elevator design - ✔✔Single, multiple( not separated) and
blind ( only upper floors)
✔✔Injury prevention - ✔✔Equipped with locks to keep them from opening when an
elevator door is not at the landing
✔✔Moving stair designs should - ✔✔Not be used during emergency operations
✔✔Moving stairs design operation - ✔✔1) each step rides track
2) steps are linked together
3) driving machinery is located upper landing
4) handrails move at same speed
