AFAB 110 Latest 2026 UPDATED Exam
Questions and Verified Answers
(2026/2027) | Graded A+ | 100%
Success
A geometric tolerance that can be measured with a dial indicator to determien the
variation of surface points as the part is rotated about a datum axis is
__________. - Correct Answer -Runout
It is important to note that a surface could be perfectly cylindrical, but if it is not
___________ with the datum axis, then runout can occur. - Correct Answer -
Coaxial
A double layer feature control frame is used for a ________ tolerance - Correct
Answer -Composite
The standard term for a drawing composed of two or more parts that, once
assembled, are permandently joined is _____________. - Correct Answer -
Inseparable assembly
Which of the following is the least likely to be found on assembly drawings in the
multiveiw format? - Correct Answer -Hidden lines for every part
, An assembly drawing that provides the necessary information to install or rect a
piece of equipment is known as a(n) _________ assembly. - Correct Answer -
Installation
An assembly drawing wherein the parts are separated from each other to help
show the correct method of assembly is known as a(n) ____________ assembly -
Correct Answer -Exploded
Which of tghe following is least likely to be found in any parts list? - Correct
Answer -Finish type
Which of the following terms is not covered by surface texture specifications? -
Correct Answer -Flatness
Specifically, the fine irregularities in the texture of the surface are defined as
______________. - Correct Answer -Surface roughness
Which of the following is not a choice for a lay symbol? - Correct Answer -L
Questions and Verified Answers
(2026/2027) | Graded A+ | 100%
Success
A geometric tolerance that can be measured with a dial indicator to determien the
variation of surface points as the part is rotated about a datum axis is
__________. - Correct Answer -Runout
It is important to note that a surface could be perfectly cylindrical, but if it is not
___________ with the datum axis, then runout can occur. - Correct Answer -
Coaxial
A double layer feature control frame is used for a ________ tolerance - Correct
Answer -Composite
The standard term for a drawing composed of two or more parts that, once
assembled, are permandently joined is _____________. - Correct Answer -
Inseparable assembly
Which of the following is the least likely to be found on assembly drawings in the
multiveiw format? - Correct Answer -Hidden lines for every part
, An assembly drawing that provides the necessary information to install or rect a
piece of equipment is known as a(n) _________ assembly. - Correct Answer -
Installation
An assembly drawing wherein the parts are separated from each other to help
show the correct method of assembly is known as a(n) ____________ assembly -
Correct Answer -Exploded
Which of tghe following is least likely to be found in any parts list? - Correct
Answer -Finish type
Which of the following terms is not covered by surface texture specifications? -
Correct Answer -Flatness
Specifically, the fine irregularities in the texture of the surface are defined as
______________. - Correct Answer -Surface roughness
Which of the following is not a choice for a lay symbol? - Correct Answer -L
