UPDATE!!!!2025/2026|GUARANTEED PASS|GRADED
What is the MINIMUM overlap for joints in polyethylene film moisture barrier applied over
the exterior of a below grade foundation wall? - ANSWER 6 inches
What is the MINIMUM height required for a nonabsorbent wall surface above a bathtub? -
ANSWER 6 feet
Nails used to fasten concrete roofing tiles must penetrate the deck a MINIMUM of how
many inches or through the thickness of the deck, Whichever is less? - ANSWER 3/4
inch
How must rafters be framed to each other? - ANSWER with a gusset plate
All of the following are benefits of platform construction as compared to balloon
construction EXCEPT. - ANSWER easier installation of plumbing and wiring
750 feet of pipe is being laid at 0.5% slope. On a topographic map that has 6 inch contour
intervals approximately how many intervals will be depicted on the map from one end of the
pipe to the other? - ANSWER 8 contour intervals
Where would the most specific information about the size and location of windows be found
in a set of construction drawings? - ANSWER In the window schedule
A contractor should do all of the following when estimating a project EXCEPT. -
ANSWER assume ideal conditions
1
What is the MINIMUM overlap for joints in polyethylene film moisture barrier applied over
the exterior of a below grade foundation wall? - ANSWER 6 inches
What is the MINIMUM height required for a nonabsorbent wall surface above a bathtub? -
ANSWER 6 feet
Nails used to fasten concrete roofing tiles must penetrate the deck a MINIMUM of how
many inches or through the thickness of the deck, Whichever is less? - ANSWER 3/4
inch
How must rafters be framed to each other? - ANSWER with a gusset plate
All of the following are benefits of platform construction as compared to balloon
construction EXCEPT. - ANSWER easier installation of plumbing and wiring
750 feet of pipe is being laid at 0.5% slope. On a topographic map that has 6 inch contour
intervals approximately how many intervals will be depicted on the map from one end of the
pipe to the other? - ANSWER 8 contour intervals
Where would the most specific information about the size and location of windows be found
in a set of construction drawings? - ANSWER In the window schedule
A contractor should do all of the following when estimating a project EXCEPT. -
ANSWER assume ideal conditions
1
