JUMPMASTER WRITTEN LATEST
TEST
What does 1NANAS stand for? - ANSWERS--1st Suspended Item
-Night
-Altitude
-Not in Trail Formation
-Additional Jumpers or HE Platforms
-Station Keeping Equipment (SKE)
What are the minimum size requirements for one jumper? - ANSWERS-
600 yards wide by 600 yards long.
What are the minimum size requirements for one HE platform? -
ANSWERS-600 yard wide by 1,000 yards long.
When are the hours of darkness? - ANSWERS-1800-0600
What is the rule for night? - ANSWERS-Add 100 yards to the length
and width.
END OF
PAGE
1
, JUMPMASTER WRITTEN LATEST
TEST
What is the rule for altitude? - ANSWERS-Add 30 yards to the length
and width for every full 100 feet over the planning altitude.
What is the rule for C-130s not flying in trail? - ANSWERS-Add 100
yards to the width.
What is the rule for C-17s dropping HE not flying in trail? -
ANSWERS-Add 100 yards to the width.
What is the rule for C-17s dropping personnel not flying in trail? -
ANSWERS-Add 640 yards to the width for 2 C-17s and 1,200 yards to
the width for 3 C-17s.
Can C-17s drop personnel while flying in trail? - ANSWERS-No.
What is the maximum number of C-17s that can be in formation? -
ANSWERS-3
What is the rule for additional jumpers? - ANSWERS-Add 75 yards to
the length for each addition jumper.
END OF
PAGE
2
, JUMPMASTER WRITTEN LATEST
TEST
What is the rule for additional HE platforms dropped from C-130s? -
ANSWERS-Add 400 yards to the length for each additional platform.
What is the rule for additional HE platforms dropped from a C-17? -
ANSWERS-Add 500 yards to the length for each additional platform.
What does ADEPT stand for? - ANSWERS-Alternate Door Exiting
Procedures for Training
What is ADEPT Option 1 and how do you calculate additional jumpers?
- ANSWERS-One door, one pass. Half of the jumpers minus 1.
What is ADEPT Option 2 and how do you calculate additional jumpers?
- ANSWERS-One door followed by the other door, one pass. Total
jumpers minus 1.
How do you calculate additional jumpers for Mass Exit? - ANSWERS--
Even number of total jumpers, divide in half.
-Odd number of total jumpers, divide in half and use the lower number.
END OF
PAGE
3
, JUMPMASTER WRITTEN LATEST
TEST
What is the interval between jumpers during Mass Exit? - ANSWERS-
1/2 second
What is the rule for Station Keeping Equipment (SKE)? - ANSWERS-
Add 400 yards to the width when used.
When does SKE cancel out Not in Trail? - ANSWERS-When the SKE
addition is larger than the Not in Trail addition.
Where is the Point of Impact (PI) measured from? - ANSWERS-
Centerline on the Leading Edge of the DZ
C-130 CDS PI - ANSWERS--Day: 200 yards
-Night: 250 yards
C-17 CDS PI - ANSWERS--Day: 225 yards
-Night: 275 yards
END OF
PAGE
4
TEST
What does 1NANAS stand for? - ANSWERS--1st Suspended Item
-Night
-Altitude
-Not in Trail Formation
-Additional Jumpers or HE Platforms
-Station Keeping Equipment (SKE)
What are the minimum size requirements for one jumper? - ANSWERS-
600 yards wide by 600 yards long.
What are the minimum size requirements for one HE platform? -
ANSWERS-600 yard wide by 1,000 yards long.
When are the hours of darkness? - ANSWERS-1800-0600
What is the rule for night? - ANSWERS-Add 100 yards to the length
and width.
END OF
PAGE
1
, JUMPMASTER WRITTEN LATEST
TEST
What is the rule for altitude? - ANSWERS-Add 30 yards to the length
and width for every full 100 feet over the planning altitude.
What is the rule for C-130s not flying in trail? - ANSWERS-Add 100
yards to the width.
What is the rule for C-17s dropping HE not flying in trail? -
ANSWERS-Add 100 yards to the width.
What is the rule for C-17s dropping personnel not flying in trail? -
ANSWERS-Add 640 yards to the width for 2 C-17s and 1,200 yards to
the width for 3 C-17s.
Can C-17s drop personnel while flying in trail? - ANSWERS-No.
What is the maximum number of C-17s that can be in formation? -
ANSWERS-3
What is the rule for additional jumpers? - ANSWERS-Add 75 yards to
the length for each addition jumper.
END OF
PAGE
2
, JUMPMASTER WRITTEN LATEST
TEST
What is the rule for additional HE platforms dropped from C-130s? -
ANSWERS-Add 400 yards to the length for each additional platform.
What is the rule for additional HE platforms dropped from a C-17? -
ANSWERS-Add 500 yards to the length for each additional platform.
What does ADEPT stand for? - ANSWERS-Alternate Door Exiting
Procedures for Training
What is ADEPT Option 1 and how do you calculate additional jumpers?
- ANSWERS-One door, one pass. Half of the jumpers minus 1.
What is ADEPT Option 2 and how do you calculate additional jumpers?
- ANSWERS-One door followed by the other door, one pass. Total
jumpers minus 1.
How do you calculate additional jumpers for Mass Exit? - ANSWERS--
Even number of total jumpers, divide in half.
-Odd number of total jumpers, divide in half and use the lower number.
END OF
PAGE
3
, JUMPMASTER WRITTEN LATEST
TEST
What is the interval between jumpers during Mass Exit? - ANSWERS-
1/2 second
What is the rule for Station Keeping Equipment (SKE)? - ANSWERS-
Add 400 yards to the width when used.
When does SKE cancel out Not in Trail? - ANSWERS-When the SKE
addition is larger than the Not in Trail addition.
Where is the Point of Impact (PI) measured from? - ANSWERS-
Centerline on the Leading Edge of the DZ
C-130 CDS PI - ANSWERS--Day: 200 yards
-Night: 250 yards
C-17 CDS PI - ANSWERS--Day: 225 yards
-Night: 275 yards
END OF
PAGE
4
