Home Inspection Exam Questions and Answers |New Update with 100% Verified Answers
Branch circuitconductorsarethe____________ wires to the outlet
Voltage is equal to amps X resistance
If a service entrance has a 200-amp supply, the minimum cable size should be? 2/0 copper
or 4/0 aluminum
The following item is safe to insert into an electrical panel: Nothing
The main panel is also called the? Electrical Panel
_____ are the units used to measure resistance. Ohms
AWG means_____ and is a standardized wire gauge system. American Wire Gauge
Branch circuit conductors are the ? Wires to the outlets
A____-amp breaker should supply a minimum # 12 conductor. 20
The maximum breaker rating must ____the allowed ampacity of the conductor. not exceed
____ is/are considered unsuitable to wear during an inspection. Nylon Clothing
A live wire is sometimes called an? Ungrounded Conductor
For a 14-gauge copper wire, the maximum over-current protection rating is ____ amps. 15
,What would cause rafter spread? Inadequate knee walls
Roof sheathing should be installed____ to the rafters. Perpendicular
De-lamination of the roof sheathing may cause? Depression between the rafters
The horizontal board enclosing the ends of the rafter projections ( or Tails) is normally referred
to as the ____board. Fascia
The distance that should separate the siding from the roof's surface is? 1 to 2 inches
Small dimples or circular depressions on asphalt shingles are often caused by___?
Hailstones
Most Jurisdictions allow more than ___ layers of asphalt shingles. two
T/F: Slate tile roofs should never be walked on? True
T/F:Most concrete and clay tiles are installed the same way. True
Fasteners made of_____ are recommended for tile roofs. Copper or stainless steel
T/F: Wood Shingles should be installed over tap paper or similar underlayment, although this is
not always required if installed over skip sheathing. True
Wood shakes and shingles should be used only on roofs with a slope of at least? 4:12
, Concrete and clay tile roofs with a slope of less than 4:12 require____ layers of underlayment.
Two
A wood shingle is ____-cut, whereas a shake is split by____? Machine.....Hand
Asphalt shingles use either____or_____ as a base. Cellulose....Fiberglass
T/F: it is not necessary to note previous shingle repair if the repair was preformed by a
professional. False
T/F: Clay tiles are easily distinguishable from concrete tiles. False
The inspector should___ when reporting on an asbestos cement tile roof. Not the roof
material
The size of a standard roll roofing is ____ inches wide. 36
The layers that make up a built-up roof are called. Plys
T/F: alligatoring of a roof covering is only a cosmetic issue. False
When a flat roof has water stains, these are signs of previous. Ponding
Metal roof tiles are typically made of___. Steel
Crushed Stone or gravel ballast on a built-up rood___. Protects the roof from sunlight
Branch circuitconductorsarethe____________ wires to the outlet
Voltage is equal to amps X resistance
If a service entrance has a 200-amp supply, the minimum cable size should be? 2/0 copper
or 4/0 aluminum
The following item is safe to insert into an electrical panel: Nothing
The main panel is also called the? Electrical Panel
_____ are the units used to measure resistance. Ohms
AWG means_____ and is a standardized wire gauge system. American Wire Gauge
Branch circuit conductors are the ? Wires to the outlets
A____-amp breaker should supply a minimum # 12 conductor. 20
The maximum breaker rating must ____the allowed ampacity of the conductor. not exceed
____ is/are considered unsuitable to wear during an inspection. Nylon Clothing
A live wire is sometimes called an? Ungrounded Conductor
For a 14-gauge copper wire, the maximum over-current protection rating is ____ amps. 15
,What would cause rafter spread? Inadequate knee walls
Roof sheathing should be installed____ to the rafters. Perpendicular
De-lamination of the roof sheathing may cause? Depression between the rafters
The horizontal board enclosing the ends of the rafter projections ( or Tails) is normally referred
to as the ____board. Fascia
The distance that should separate the siding from the roof's surface is? 1 to 2 inches
Small dimples or circular depressions on asphalt shingles are often caused by___?
Hailstones
Most Jurisdictions allow more than ___ layers of asphalt shingles. two
T/F: Slate tile roofs should never be walked on? True
T/F:Most concrete and clay tiles are installed the same way. True
Fasteners made of_____ are recommended for tile roofs. Copper or stainless steel
T/F: Wood Shingles should be installed over tap paper or similar underlayment, although this is
not always required if installed over skip sheathing. True
Wood shakes and shingles should be used only on roofs with a slope of at least? 4:12
, Concrete and clay tile roofs with a slope of less than 4:12 require____ layers of underlayment.
Two
A wood shingle is ____-cut, whereas a shake is split by____? Machine.....Hand
Asphalt shingles use either____or_____ as a base. Cellulose....Fiberglass
T/F: it is not necessary to note previous shingle repair if the repair was preformed by a
professional. False
T/F: Clay tiles are easily distinguishable from concrete tiles. False
The inspector should___ when reporting on an asbestos cement tile roof. Not the roof
material
The size of a standard roll roofing is ____ inches wide. 36
The layers that make up a built-up roof are called. Plys
T/F: alligatoring of a roof covering is only a cosmetic issue. False
When a flat roof has water stains, these are signs of previous. Ponding
Metal roof tiles are typically made of___. Steel
Crushed Stone or gravel ballast on a built-up rood___. Protects the roof from sunlight
