- Study guides, Class notes & Summaries
Looking for the best study guides, study notes and summaries about ? On this page you'll find 35 study documents about .
All 35 results
Sort by:
-
Exam (elaborations)
Auto Final Exam Questions and Correct Answers
-
---8April 20262025/2026A+
- Auto Final Exam Questions and Correct Answers 
Technician A says a load tester can be used to check the condition of a vehicles battery. Technician B says a load tester can be used to check the condition of a vehicle starting system. Who is right - Correct Answer Both a and B 
 
What tool measures voltage overtime? - Correct Answer Oscilloscope 
 
What tool is used when making a electrical test on a diesel engine - Correct Answer Luminosity timing meter 
 
Technician a says and inductive wire tr...
-
$12.99 More Info
Winfred
-
Exam (elaborations)
AUTO DAMAGE AND THEFT EXAM NEW YORK STATE 2024 STUDY GUIDE AND PRACTICE TEST BANK 300 QUESTIONS COMPLETE SET
-
---69December 20252025/2026A+
- AUTO DAMAGE AND THEFT EXAM NEW YORK 
STATE 2024 STUDY GUIDE AND PRACTICE TEST 
BANK 300 QUESTIONS COMPLETE SET
-
$11.99 More Info
FocusFile7
-
Exam (elaborations)
Auto Final Exam Questions and Answers Already Passed
-
---11November 20232023/2024A+
- Technician A says a load tester can be used to check the condition of a vehicles battery. 
Technician B says a load tester can be used to check the condition of a vehicle starting system. 
Who is right Both a and B 
What tool measures voltage overtime? Oscilloscope 
What tool is used when making a electrical test on a diesel engine Luminosity timing meter 
Technician a says and inductive wire tracer generates a DC voltage in the wiring being tested. 
Technician B says and inductive wire tracer c...
-
$6.99 More Info
jessybrown
-
Exam (elaborations)
Auto Final Exam Questions and Answers 100% Pass
-
---14November 20232023/2024A+
- which part is the cylinder head bolted to? the block 
What is the ratio of coolant to water in a typical automotive cooling system? 50:50 
Which material are new model cylinder heads made from? aluminum 
Who issues technical service bulletins? manufacturers 
If blue smoke is seen at the tailpipe when an engine is started, which part(s) is/are most likely 
worn out? valve stem seals 
Technician A says a water pump controls the flow of coolant through an engine. Technician B 
says an oil filter co...
-
$7.99 More Info
jessybrown
-
Exam (elaborations)
Auto-Chapter 5 Questions and Answers 100% Pass
-
---5November 20232023/2024A+
- what does an auto shop's repair area normally include? Shop stall, lift, alignment rack, and 
outside work area 
A(n)____ is a small work area where a car can be parked for repairs. Shop stall 
List the rules that should be followed when using a lift Ask for permission to use the lift, 
center the vehicle on the lift, check ceiling clearance before lifting large or tall vehicles, make 
sure lift catch is safely engaged 
Describe how a vehicle should be pulled onto an alignment rack Pulled in sl...
-
$5.99 More Info
jessybrown
-
Exam (elaborations)
Automotive chapter 5 questions and answers already passed
-
---7April 20232022/2023A+
- Which of the following is NOT represented by the "3 Cs" abbreviation? Customer 
Which of the following is a typical label found on vehicles? All of the answers listed 
The ________________ is used by technicians to identify engine and emission control 
information for the vehicle. Vehicle Emission Control Information (VECI) label 
The ______________ certifies that the vehicle meets the Federal Motor Vehicle Safety, Bumper, 
and Theft Prevention standards in effect at the time of manufacture. V...
-
$8.49 More Info
UNLIMITEDPAPERS
-
Exam (elaborations)
Automotive Chapter 6 Questions and Answers Graded A
-
---4April 20232022/2023A+
- Which of the following is a common type of wrench used in the service of automobiles? All 
of the answers listed 
All of the following are variations on the open-end wrench, EXCEPT box-end wrench 
Sockets most commonly come in which of the following configurations 12 and 6 points 
Which of the following is NOT a type of pliers used in the automotive industry? Open-end 
pliers 
Which of the following is a cutting tool? All of the answers listed
-
$6.99 More Info
UNLIMITEDPAPERS
-
Exam (elaborations)
Automotive Chapter 8 Questions and Answers
-
---2April 20232022/2023A+
- Parallel Circuit has more than one electrical path or leg. 
current the flow of electrons through a conductor 
atom small particles charged protons, neutrons, and electrons 
resistance the opposition to current flow 
relay an electrically operated switch
-
$4.99 More Info
UNLIMITEDPAPERS
-
Exam (elaborations)
Automotive Exam Study Guide Questions and Answers 100% Pass
-
---18April 20232022/2023A+
- A fire involving gasoline is what class of fire? 
B class fire. 
Your workplace would will be a much safer place if you: 
Know what to do in an emergency. 
Exhaust gases in workshops are a serious health hazard. The best way to get rid of these gases is: 
With an exhaust extraction system. 
Why should you disconnect the battery prior to cleaning a vehicle with solvents? 
Because some solvents are highly volatile and can explode. 
Material Safety Data Sheets provide information about: 
The handli...
-
$10.99 More Info
UNLIMITEDPAPERS
-
Exam (elaborations)
Auto 1: final exam questions 180-200 with complete solutions
-
---5April 20232022/2023A+
- What's the main reason to measure a battery's state of charge? It indicates the battery's 
condition 
When inspecting the power steering belt, Technician A says if the belt is cracked or glazed then 
it should be replaced. Technician B says that a V-Belt should be checked with a belt tension 
gauge after the belt is replaced. Who is right? Both A and B 
While draining and refilling a differential, one should: Follow procedures using the correct 
type of fluid. 
Technician A says oil-soaked be...
-
$8.49 More Info
UNLIMITEDPAPERS
-
Exam (elaborations)
Auto Final Exam Questions and Answers 100% Pass
-
---14April 20232022/2023A+
- which part is the cylinder head bolted to? the block 
What is the ratio of coolant to water in a typical automotive cooling system? 50:50 
Which material are new model cylinder heads made from? aluminum 
Who issues technical service bulletins? manufacturers 
If blue smoke is seen at the tailpipe when an engine is started, which part(s) is/are most likely 
worn out? valve stem seals 
Technician A says a water pump controls the flow of coolant through an engine. Technician B 
says an oil filter co...
-
$10.99 More Info
UNLIMITEDPAPERS
-
Exam (elaborations)
Auto Final Exam Questions and Answers Already Passed
-
---11April 20232022/2023A+
- Technician A says a load tester can be used to check the condition of a vehicles battery. 
Technician B says a load tester can be used to check the condition of a vehicle starting system. 
Who is right Both a and B 
What tool measures voltage overtime? Oscilloscope 
What tool is used when making a electrical test on a diesel engine Luminosity timing meter 
Technician a says and inductive wire tracer generates a DC voltage in the wiring being tested. 
Technician B says and inductive wire tracer c...
-
$9.99 More Info
UNLIMITEDPAPERS
-
Exam (elaborations)
Auto-Chapter 5 Questions and Answers 100% Pass
-
---4April 20232022/2023A+
- what does an auto shop's repair area normally include? Shop stall, lift, alignment rack, and 
outside work area 
A(n)____ is a small work area where a car can be parked for repairs. Shop stall 
List the rules that should be followed when using a lift Ask for permission to use the lift, 
center the vehicle on the lift, check ceiling clearance before lifting large or tall vehicles, make 
sure lift catch is safely engaged 
Describe how a vehicle should be pulled onto an alignment rack Pulled in sl...
-
$8.49 More Info
UNLIMITEDPAPERS
-
Exam (elaborations)
Automotive 1: Chapter 9 Questions and Answers Graded A
-
---7April 20232022/2023A+
- A large repair facility recycles its used motor oil. Technician A says that only about one quart of 
high-quality oil can be recovered from each gallon of used oil that is recycled. Technician B says 
the recovery rate is about two and one-half quarts per gallon. Who is right? B only 
When checking hose conditions, which would indicate the need for replacement? -Softening 
-Hardening 
-Cracks or abrasions 
If you find fluid dripping from a vehicle, where is the likeliest direction to look for th...
-
$8.49 More Info
UNLIMITEDPAPERS
-
Exam (elaborations)
Automotive Basics Final Questions and Answers Already Passed
-
---23April 20232022/2023A+
- Your automobile relys on what to function Several systems 
What is the best way to diagnose a system failure Look for specific components in a system 
that aren´t working 
What do components make up A system 
Coolant Heat from the engine is transferred into what liquid 
What does the Thermostat do It measures the temp of the engine and tells the water pump 
when to cycle new coolant 
What does the radiator do Allows the heat from the antifreeze to be transferred to the air that 
is being blown ...
-
$11.99 More Info
UNLIMITEDPAPERS
-
Exam (elaborations)
Automotive chapter 2 questions and answers 100% pass
-
---3April 20232022/2023A+
- List four skills that may be needed when working as an automotive technician Computer 
technician, residential/commercial engineer, electronic engineer, tv radio technition 
What is a cooperative training program Combine classroom instructions with real world 
experience 
Which of the following is not a typical specialized technician? 
1) engineering technician 
2) steering and suspension technician
-
$5.99 More Info
UNLIMITEDPAPERS