PRIMARY SYSTEMS

Propulsion System - Answer Provides power (thrust) for aircraft Provides Power for aircraft systems such as electrical, hydraulics, and fuel pumps Electrical System - Answer Provides electrical power for aircraft systems Primary power from starter/generator Secondary power from battery Backup power from auxiliary battery External power through fuselage receptacle Primary aircraft electrical power is provided by which component of the electrical system? - Answer ...

IDENTIFY functions of the flight controls system - Answer Primary = Controls movement around lateral, longitudinal, and vertical axes (Elevator, Ailerons, Rudder, and Gust Lock) Secondary = Lessen control forces required to maintain normal flight attitudes (Elevator trim, Aileron Trim, Rudder Trim, and Trim Aid Device) Purpose of Gust Lock - Answer Locks controls in a neutral position to prevent wind damage. (Elevator is locked in a nose down configuration) Purpose of the Tri...

CFR Part 91 - FAR/AIM. Part 91 contains some applicable flight rules not specifically addressed in OPNAV 3710.7. Naval Aviators must be thoroughly familiar and MUST COMPLY with this document. - Answer a. T Which of the following flight instruments (located on the primary flight display [PFD]) is not used as a "crosscheck" or performance instrument? a. Altimeter b. Angle of Attack Indicator c. Air Speed Indicator d. Rate of turn, and Sideslip Indicator. - Answer b Spatial ...

What are the ATO service areas? - Answer Western, Center, Eastern The safe, secure, and efficient management for the NAS is the responsibility of which division? - Answer Air traffic Services The ATO is managed by - Answer Chief Operating Officer (COO) What is the first duty priority of the ATC system? - Answer Separating aircraft and issuing safety alerts What are the primary purposes of the ATC system? - Answer Provide support for National Security and Homeland Defen...

Fly-by wire - Answer Electronic rather than mechanical system Primary Flight controls - Answer Control Wheel inputs Column inputs Pedal inputs PFC - Answer 3 Primary Flight Computers Receives input from the Autopilot Redundant Contain enhanced control features Generate all control surface commands ACEs - Answer 4 Actuator Control Electronics Receives input from Pilot Control Inputs Provide redundant control in each axis ACEs control - Answer Spoilers Ailerons ...

What is the Hydraulic 1 System primarily driven by? - Answer The Engine One Hydraulic Pump in the accessory gear box. What systems do Hydraulic System 1 operate? - Answer The Rudder, Left Aileron, Right Aileron, Inboard (Ground) Spoilers, Left Thrust Reverser, Outboard Wheel Brakes, Landing Gear and Steering. What systems are limited by the priority valve? On what Hydraulic System does the priority valve reside? - Answer The Landing Gear and Steering are assisted by the Priority V...

How many Cabin Doors provide access to the aircraft cabin? - Answer 4 How many Cargo Compartments are on the ERJ 175? - Answer 2 Are both Cargo Compartments pressurized? - Answer Yes Can the DV windows be removed by the crew? - Answer No Are fault(s) in the water system monitored from the cockpit? - Answer No What is the purpose of the Ramp Horn buttons installed in the cockpit? - Answer To call Ground Personnel via a continuous horn sound (when pressed) When ...

Identify the acronym "I'M SAFE" in determining if you are ready and fit to fly - Answer ○ I - Illness ○ M - Medication ○ S - Stress ○ A - Alcohol ○ F - Fatigue ○ E - Eating KNOW WHAT EACH STANDS FOR, SPECIFICALLY THE 'F.' Identify four factors that contribute to the aircraft's yawing tendency - Answer ○ Torque reaction to the engine and propeller. ○ The propeller's gyroscopic effect. ○ The corkscrewing effect of the propeller slipstream ...

1-skill level (student/helper) - Answer unskilled 3-skill level (apprentice) - Answer semi-skilled 5-skill level (journeyman) - Answer skilled, 12 months OJT 7-skill level (craftsman) - Answer perform more proficiently, advise others, troubleshoot 9-skill level (superintendent) - Answer trusted to handle the management & direction 1-skill level requirements - Answer meet the physical & mental standards for entry into the AF 3-skill level requirements - Answer ...

a thermal efficiency of around 30% of the heat energy of the fuel being used for power output is typical in a reciprocating engine - Answer true select the type of connecting rod generally used in V-type engine according to the class PowerPoint - Answer fork and blade the cross-sectional area or diameter of the inside of the cylinder is the - Answer bore the otto, diesel, and brayton cycles of heat engines all include which three items below - Answer compression of air, conv...