- Study guides, Class notes & Summaries

Electrical Masters Test 2 EXAM LATEST EXAM QUESTIONS AND CORRECT DETAILED ANSWERS WITH RATIONALES (VERIFIED ANSWERS) |ALREADY GRADED A+ Electrical work not in excess of how many dollars is considered minor repair work? - Answer -$100 The minimum weight of a manhole cover is how many pounds? - Answer -100 pounds The total resistance of a 20 ohms, 30 ohms and 40 ohms resistor wired in parallel is how many OHMS? - Answer -9.2 A 120 V circuit has a 35 OHMS and 58 OHMS resistor connected ...

-

4 pages

Written in 2024/2025

Grade A+

BrightByte

Electrical Masters EXAM NEWEST 2025 ACTUAL EXAM COMPLETE QUESTIONS AND CORRECT DETAILED ANSWERS (VERIFIED ANSWERS) |ALREADY GRADED A+ Mutual Induction - Answer -The process of inducing a current flow through a secondary coil, by passing a varying current on the primary coil Secondary Induced Voltage - Answer -Voltage induced in the secondary winding of a transformer is equal to the sum of the voltages induced in each loop of the secondary winding. Eddy Currents - Answer -Loops of electr...

-

9 pages

Written in 2024/2025

Grade A+

BrightByte

The main disadvantage of a low power factor is that __________. - Current required for a given load, power is higher Overcurrent devices shall not be connected in series with any conductor that is ______. - Intentionally grounded If the length and area of a cross-section of a wire are doubled, then it's resistance _________. - (Remains the same)- key words in the question, length and area, only when the area (csa) doubled and not both length and csa. Doubling the csa only will cut the ...

-

25 pages

Written in 2024/2025

Grade A+

TIPSTAR

In an area served by a separately derived system, the grounding electrode must be as near as practicable and must be the nearest _____________. a. structural metal grounding electrode b. metal water pipe electrode c. metal building skin d. a or b - d. a or b [250.30(A)(4)] The size of the grounding electrode conductor for a single separately derived system must not be smaller than that identified in ____________, based on the area of the largest derived ungrounded supply conductor. a. ...

-

9 pages

Written in 2024/2025

Grade A+

TIPSTAR

The term "_________" is used to identify the ungrounded (hot) conductors in an electrical system. a. load b. line c. system d. grounded - b. line ______________ voltage is the voltage measured between any two ungrounded (hot) conductors. a. Load b. Line c. Grounded d. and of these - b. Line

-

9 pages

Written in 2024/2025

Grade A+

TIPSTAR

©THESTAR 2024/2025 ALL RIGHTS RESERVED 11:42PM. A+ 1 Electrical Masters Exam Questions With Correct Answers 100% Verified. Mutual Induction - AnswerThe process of inducing a current flow through a secondary coil, by passing a varying current on the primary coil Secondary Induced Voltage - AnswerVoltage induced in the secondary winding of a transformer is equal to the sum of the voltages induced in each loop of the secondary winding. Eddy Currents - AnswerLoops of electrical current indu...

-

12 pages

Written in 2024/2025

Grade A+

TheStar

Electrical Masters EXAM LATEST QUESTIONS AND CORRECT DETAILED ANSWERS WITH RATIONALES (VERIFIED ANSWERS) |ALREADY GRADED A+ Given three resistors of 20 ohms, 30 ohms, and 40 ohms in parallel what is the total resistance? - Answer -9.23 ohms A 120V circuit has two resistors connected in series, R1= 35 ohms and R2= 58 ohms. What is the voltage drop on R1? - Answer -45.16 volts What is the expected expansion of a 202' run of RNC with a 102° temperature rise? - Answer -8.2 inches What ...

-

4 pages

Written in 2024/2025

Grade A+

BrightByte