IFT 266

IFT 266 Lab 23 (Using VLSM in Designing a Network) COMPLETE and Already GRADED A

Final Exam Logical Topology Network Requirements Examine the network requirements (current and future) and answer the questions below. 1. How many subnets are possible? How many subnets are required?

IFT 266 Introduction to Network Information Communication Technology (ICT) Lab 22 Local Link Address Configuration Objective: Configure a simple network with IPv6 and get the hosts communicating with each other and configure the router interfaces for IPv6. 1. Setup the following topology. For this lab use the 1941 Router which by default has Gigabit interfaces.

IFT 266 Introduction to Network Information Communication Technology Lab 21 IPv6: EUI-64

IFT 266 Introduction to Network Information Communication Technology Lab 18 The Hidden Network Co-authored by Ricardo Garcia Note: This is a challenging lab. Ask other students for help if you need it.

IFT 266 Introduction to Network Information Communication Technology Lab 17 DHCP Snooping

IFT 266 Introduction to Network Information Communication Technology Lab 16 Port Security Configuration After you complete each step, put a ‘√’ or ‘x’ in the completed box 1. Setup the following topology in packet tracer. - It is recommended that you use a 2960 switch for this lab. - You can change the MAC address of the server and PCs by going to the particular Fast Ethernet interface on each device (config tab) and overwriting what is currently listed. - To check your PC sett...

IFT 266 Introduction to Network Information Communication Technology Lab 15 Cisco Discovery Protocol (CDP)

IFT 266 Introduction to Network Information Communication Technology Lab 14 Routing with a Multilayer Switch Co-authored by Marc Herrero After you complete each step, put a ‘√’ or ‘x’ in the completed box 1. Set up the following topology in packet tracer.

IFT 266 Introduction to Network Information Communication Technology (ICT) Lab 13 VLAN Setup and Configuration After you complete each step, put a ‘√’ or ‘x’ in the completed box Part A: VLAN Setup Setup the following topology (we will connect the switch to router later on)