NIMS TEST II | QUESTIONS AND ANSWERS | 100%
CORRECT 2025/2026 UPDATE!!
Unit of measure for lathe feed rate Answer - IPR
To convert inches to millimeters, a machinist would use a constant of
_________. Answer - 25.4
The feed rate for converting a hole on a drill press should be __________ that
of drilling. Answer - 2 times
The feed rate for reaming a hole on a drill press should be __________ that of
drilling. Answer - 1/8th
The most accurate method of measuring an angle is a : Answer - combination
set
Which type of head for a combination set is the best choice for finding the
center of a shaft? Answer - Center
A solid square has two sides that form an angle of ___________ degrees that
checks ________________. Answer - 90, perpendicularity
The resolution of a micrometer with a vernier scale is ___________ inches,
Answer - 0.0001
CORRECT 2025/2026 UPDATE!!
Unit of measure for lathe feed rate Answer - IPR
To convert inches to millimeters, a machinist would use a constant of
_________. Answer - 25.4
The feed rate for converting a hole on a drill press should be __________ that
of drilling. Answer - 2 times
The feed rate for reaming a hole on a drill press should be __________ that of
drilling. Answer - 1/8th
The most accurate method of measuring an angle is a : Answer - combination
set
Which type of head for a combination set is the best choice for finding the
center of a shaft? Answer - Center
A solid square has two sides that form an angle of ___________ degrees that
checks ________________. Answer - 90, perpendicularity
The resolution of a micrometer with a vernier scale is ___________ inches,
Answer - 0.0001
