AMMO 51 MV EXAM QUESTIONS AND
ANSWERS GRADED A+ 2025/2026
Which regulation establishes the Department of Defense (DOD) policies and procedures for the
transportation and movement of material? - ANS DTR 4500.9-R
Which volume of the NAVSEA OP5 applies to the transportation of hazardous materials ashore?
- ANS Volume 1
Which Department of Transportation Special Permit applies when shipping NSN 1410-01-235-
7044 NALC PC84 material by motor vehicle? - ANS DOT SP-868
What is the minimum number of motor vehicles required to ship NALC items G878, D528, E487,
H110 and PA08. The weight of each item is 1,500 lbs. - ANS
Which placards would be required if 4 trucks were shipping the following material? -
ANS 1.1,1.2,1.3,1.4
A semi-tractor trailer is pulling a trailer transporting Hazard Class/Division 1.3. The tractor will
carry no explosives. Which statement is the most correct? - ANS The explosives 1.3 placard
may be placed on either the front of the tractor or the front of the trailer.
1 @COPYRIGHT 2025/2026 ALLRIGHTS RESERVED.
, Must a copy of a Competent Authority Approval (CAA) accompany a shipment of PE79 that will
be shipped to a location in Japan? - ANS YES
What is assigned to every type of ammunition so that it can be properly accounted for and
protected from falling into the wrong hands? Select all that apply. - ANS CIIC
Which ammunition item would be assigned a lower security level? - ANS bomb
Ordnance carried on military-owned tactical vehicles operating on public roads must be blocked
and braced in accordance with a MIL-STD, WR or other approved procedure. - ANS MIL-STD-
1320D
What is a size of steel strapping that may be used to secure ammunition to flatbed trailers? -
ANS 2 in x 0.050 in
Which factor governs the total load weight that may be placed on a truck shipment of NSN,
1305-00-147-5904 NALC A475? - ANS Cube, permissible gross weight and axle load limitation
Which section of the DD Form 626 would provide specific requirements for inspecting a
vehicle's steering system? - ANS
What part of the DD Form 626 documents the required driver information? - ANS Section 1
What requirements does Section I of the DD Form 626 verify? Select all that apply. -
ANS HAZMAT/VALID LEASE/ROUTE PLAN/ERG EQUIVALENT COMMERCIAL/DRIVER VEHICLE
INSPECTION/COPY OF CFR 49 PART 397/TRUCK TRACTOR/TRAILER
2 @COPYRIGHT 2025/2026 ALLRIGHTS RESERVED.
ANSWERS GRADED A+ 2025/2026
Which regulation establishes the Department of Defense (DOD) policies and procedures for the
transportation and movement of material? - ANS DTR 4500.9-R
Which volume of the NAVSEA OP5 applies to the transportation of hazardous materials ashore?
- ANS Volume 1
Which Department of Transportation Special Permit applies when shipping NSN 1410-01-235-
7044 NALC PC84 material by motor vehicle? - ANS DOT SP-868
What is the minimum number of motor vehicles required to ship NALC items G878, D528, E487,
H110 and PA08. The weight of each item is 1,500 lbs. - ANS
Which placards would be required if 4 trucks were shipping the following material? -
ANS 1.1,1.2,1.3,1.4
A semi-tractor trailer is pulling a trailer transporting Hazard Class/Division 1.3. The tractor will
carry no explosives. Which statement is the most correct? - ANS The explosives 1.3 placard
may be placed on either the front of the tractor or the front of the trailer.
1 @COPYRIGHT 2025/2026 ALLRIGHTS RESERVED.
, Must a copy of a Competent Authority Approval (CAA) accompany a shipment of PE79 that will
be shipped to a location in Japan? - ANS YES
What is assigned to every type of ammunition so that it can be properly accounted for and
protected from falling into the wrong hands? Select all that apply. - ANS CIIC
Which ammunition item would be assigned a lower security level? - ANS bomb
Ordnance carried on military-owned tactical vehicles operating on public roads must be blocked
and braced in accordance with a MIL-STD, WR or other approved procedure. - ANS MIL-STD-
1320D
What is a size of steel strapping that may be used to secure ammunition to flatbed trailers? -
ANS 2 in x 0.050 in
Which factor governs the total load weight that may be placed on a truck shipment of NSN,
1305-00-147-5904 NALC A475? - ANS Cube, permissible gross weight and axle load limitation
Which section of the DD Form 626 would provide specific requirements for inspecting a
vehicle's steering system? - ANS
What part of the DD Form 626 documents the required driver information? - ANS Section 1
What requirements does Section I of the DD Form 626 verify? Select all that apply. -
ANS HAZMAT/VALID LEASE/ROUTE PLAN/ERG EQUIVALENT COMMERCIAL/DRIVER VEHICLE
INSPECTION/COPY OF CFR 49 PART 397/TRUCK TRACTOR/TRAILER
2 @COPYRIGHT 2025/2026 ALLRIGHTS RESERVED.
