J-STD-001E EXAM QUESTIONS AND ANSWERS
Hardware characteristics or conditions that do not conform to the requirements of this specification are
classified as ____________ - CORRECT ANSWER✅✅Hardware defects or hardware process indicators.
The __________ always takes precedence over this standard, referenced standards and drawings. -
CORRECT ANSWER✅✅contract
When a clause in this document is referenced, - CORRECT ANSWER✅✅its subordinate clauses also
apply.
This drawing represents? - CORRECT ANSWER✅✅Wire overwrap.
During an audit an employee is found using tobacco products in the work area. this would be? -
CORRECT ANSWER✅✅D1D2D3
The IPC-T- 50 document provides _________ - CORRECT ANSWER✅✅terms and definitions.
Solder alloys shall be in accordance with J-STD- ____ or equivalent. - CORRECT ANSWER✅✅006
A solder connection that appears dull, matte, satin, gray, or grainy and is normal for the material or
process involved is considered? - CORRECT ANSWER✅✅Acceptable.
All IPC certification programs for MIT, CIT, and CIS require re-certification after what period of time? -
CORRECT ANSWER✅✅2 years.
Component damage that exposes the component substrate or active element or affects structural
integrity is? - CORRECT ANSWER✅✅D1D2D3
Any violation of minimum electrical clearance as a result of conformance to defined criteria is a ______
condition. - CORRECT ANSWER✅✅Defect
Hardware characteristics or conditions that do not conform to the requirements of this specification are
classified as ____________ - CORRECT ANSWER✅✅Hardware defects or hardware process indicators.
The __________ always takes precedence over this standard, referenced standards and drawings. -
CORRECT ANSWER✅✅contract
When a clause in this document is referenced, - CORRECT ANSWER✅✅its subordinate clauses also
apply.
This drawing represents? - CORRECT ANSWER✅✅Wire overwrap.
During an audit an employee is found using tobacco products in the work area. this would be? -
CORRECT ANSWER✅✅D1D2D3
The IPC-T- 50 document provides _________ - CORRECT ANSWER✅✅terms and definitions.
Solder alloys shall be in accordance with J-STD- ____ or equivalent. - CORRECT ANSWER✅✅006
A solder connection that appears dull, matte, satin, gray, or grainy and is normal for the material or
process involved is considered? - CORRECT ANSWER✅✅Acceptable.
All IPC certification programs for MIT, CIT, and CIS require re-certification after what period of time? -
CORRECT ANSWER✅✅2 years.
Component damage that exposes the component substrate or active element or affects structural
integrity is? - CORRECT ANSWER✅✅D1D2D3
Any violation of minimum electrical clearance as a result of conformance to defined criteria is a ______
condition. - CORRECT ANSWER✅✅Defect
